4. Normal Operation
After synchronizing with the Wireless Fan Coil Controller, the
remote will go to the Home Screen with the following button
functions.
Select heat/cool/auto mode
Select fan operating mode
Enter/Exit User Settings Mode for the following
settings:
• C/F temperature units selection
• Internal/External temperature sensor
selection
• Setback set point setup
(if P16 is not Disable)
• 12/24 hour time display mode selection
• Set Time
(if Standalone or Local mode)
• Set Month and Date
(if Standalone or Local mode)
• Set Year
(if Standalone or Local mode)
• Enter Program Schedule mode
(if P0 = Programmable)
• Set temperature offset
Home Screen: Enter Set Point Change mode
Set Point Change: increase or decrease the set
point for the selected heat/cool mode
Home Screen:
Select what to display under ambient
temperature; set point and humidity, or time.
Set Point Change:
Toggle state of permanent hold between ON and
OFF
5. Code Functions
The device can perform additional functions
required for certain situations. To access the
functions, press the MODE, FAN, and SETTINGS
buttons simultaneously until the C0dE screen
appears (~2 seconds). Enter the code for the
desired function from the table below, using
the !and "buttons.
Identify Mode: Flashes display and links to Wireless
Fan Coil Remote if available.
Parameter Setup: function to set operating
parameters.
Join/Leave Network:
If not part of a network, the device will start the pairing
process.
If part of a network, the device will ask for confirmation
to unpair from the network.
If confirmed, the device will leave the network and
start the pairing process.
Factory Default: Restores all parameters to factory
default values and reboots. The device will ask for
confirmation to restore factory defaults.
When confirmation is required, if confirmation is not received
within 3 minutes, the device will return to the Home Screen.
FCC and Industry Canada
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to complywith the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy, and if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC AND INDUSTRY CANADA
RF Radiation Exposure statement: This equipment complies with FCC and Industry Canada RF
radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with a minimum distance of 20 centimeters between the antenna and
all persons.
Cet appareil est conforme aux limites d’exposition au rayonnement FR du FCC et d’Industrie
Canada pour un environnement non contrôlé. Cet appareil devrait être installé et devrait
fonctionner de sorte qu’il se trouve à une distance d’au moins 20 cm entre l’antenne et toute
personne.
INDUSTRY CANADA
This device complies with IndustryCanada licence-exemptRSSstandard(s).Operationissubject
to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, me"me si le brouillage est susceptible d'en compromettre le
fonctionnement.
Warranty
SALUS North America, Inc. (“Salus”) warrants that fora period of five(5) years (“Warranty Period”)
from the date of purchase by the consumer (“Customer”), this device, excluding batteries
(“Product”), shall be free of defects in materials and workmanship under normal use and service
in accordance with all supplied instructions. During the warranty period, Salus shall, at its option,
repair or replace any defective Products, at no charge for the device. Any replacement and/or
repaired devices are warranted for the remainder of the original Warranty Period or ninety (90)
days, whichever is longer.
This warranty does not cover removal or reinstallation costs. This warranty does not apply to any
Product (i) which has been modified, repaired, or altered, except by Salus or an authorized Salus
representative, (ii) which has not been maintained in accordance with any handling or operating
instructions supplied by Salus, or (iii) which has been subjected to unusual physical or electrical
stress, misuses, abuse, negligence or accidents.
This warranty is the only express warranty Salus makes for the Product. Any implied warranties,
including warranties of merchantability or fitness for a particular purpose, are limited to the
Warranty Period or the shortest period allowed by law.
SALUS SHALL NOT BE LIABLE FOR ANY LOSS OR DAMAGE OF ANY KIND, INCLUDING ANY SPECIAL,
INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING, DIRECTLY OR INDIRECTLY, FROM ANY
BREACH OF ANY WARRANTY, EXPRESS OR IMPLIED, OR ANY OTHER FAILURE OF THIS PRODUCT.
Some states and provinces do not allow the exclusion or limitation of incidental or consequential
damages, or limitation on the duration of implied warranties of merchantability or fitness, so
these exclusions or limitations may not apply to you.
No oral or written information or advice given by Salus or a Salus- authorized representative shall
modify or extend this warranty. If any term is held to be illegal or unenforceable, the legality or
enforceability of the remaining terms shall not be affected or impaired.
Customer’s sole and exclusive remedy under this limited warranty is product repair or replacement
as provided herein. If a Product under warranty is defective, the Customer may:
• contact the party (“Seller”) from which the Customer purchased the Product to obtain an
equivalent replacement product after the Seller has determined that the Product is defective
and the Customer is eligible for a replacement, or
• contact Salus Service at support@salusinc.com, to determinewhether the device qualifies for
a replacement. If a replacement is warranted and is shipped prior to the return of the device
under warranty, a credit card is required and a hold may be placed on the Customer’s credit
card for the value of the replacement until the returned device is verified as eligible for
replacement, in which case, the Customer’s credit card will not be charged.
This warranty gives you specific legal rights, and you may also have other rights that vary from
jurisdiction to jurisdiction. If you have any questions regarding this warranty, please write Salus
at:
SALUS North America, Inc.
850 Main Street
Redwood City, CA 94063
