Samsung SyncMaster 1100 DF Bedienungsanleitung
SyncMaster 1100DF
Main Page On-Screen Display
General
Highlight Zone
Highlight Zone II
MouScreen™
Safety Instructions Troubleshooting
Notational Check List
Power Q & A
Installation Self-Test Feature Check
Cleaning
Other
Introduction Specifications
Unpacking General Specifications
Front Preset Timing Modes
Rear PowerSaver
Bottom
Setup Information
Connecting Your Monitor Service
Installing the Monitor Driver Terms
Automatic Regulatory
Manual Natural Color
Base Installation MouScreen™
Authority
Notational
Power
Installation
Clean
Other
Failure to follow directions noted by this symbol could result in bodily harm or damage to
equipment.
Prohibited Important to read and understand at all times
Do not disassemble Disconnect the plug from the outlet
Do not touch Grounding to prevent an electric shock
Notational
Power
Installation
Clean
Other
When not used for extended periods of time, set your computer to DPMS. If
using a screen saver, set it to the active screen mode.
zIf the size of your monitor is small, or if the same image is present for long
periods of time, you may see afterimages due to damage to the
fluorescent substance on the inside of the CDT.
Do not use a damaged or loose plug.
zThis may cause an electric shock or fire.
Do not pull the plug out by the wire nor touch the plug with wet
hands.
zThis may cause an electric shock or fire.
Use only a properly grounded plug and receptacle.
zAn improper ground may cause electric shock or equipment
damage.
Do not excessively bend the plug and wire nor place heavy objects
upon them, which could cause damage.
zFailure to do so may cause an electric shock or fire.
Disconnect the plug from the outlet during storms or lightening or
if it is not used for a long period of time.
zFailure to do so may cause an electric shock or fire.
Do not connect too many extension cords or plugs to an outlet.
zThis may cause a fire.
Notational
Power
Installation
Clean
Other
Do not cover the vents on the monitor cabinet.
zBad ventilation may cause a breakdown or fire.
Put your monitor in a location with low humidity and a minimum of
dust.
zAn electric shock or fire could result inside the monitor.
Do not drop the monitor when moving it.
zThis may cause damage to the product or human body.
Place the monitor on a flat and stable surface.
zThe monitor can cause injury by falling.
Set down the monitor carefully.
zIt could be damaged or broken.
Do not place the monitor face down.
zThe CDT surface may be damaged.
Do not use the monitor without the monitor stand.
zIt could break down or cause a fire due to bad ventilation.
zIf the monitor must be used without the supplied stand, take steps
to insure proper ventilation.
Notational
Power
Installation
Clean
Other
When cleaning the monitor case or the surface of the CDT, wipe with a
slightly moistened, soft fabric.
Do not clean Flat monitor with water. Use a water-diluted mild
detergent.
(Some detergents contain significant amounts of alcohol-based solvents,
which can damage (color change) or crack the monitor case. The
antiglare/anti-static surface coating on the CDT may also be affected.)
Dilute the detergent (1:10 ratio) with water before using.
Do not spray detergent directly on the monitor.
Use the recommended detergent with a smooth cloth.
zYou can prevent the coated CDT from being damaged or the
monitor cabinet from being dissolved, cracked or discolored.
zYou can buy a recommended detergent at any Samsung Service
Center.
If the connector between the plug and the pin is dusty or dirty,
clean it properly with a dry cloth.
zA dirty connector can cause an electric shock or fire.
Do not set a glass of water, chemicals or any small metal objects
on the monitor.
zThis may cause damage, electric shock or a fire.
zIf a foreign substance gets into the monitor, disconnect the plug
and then contact a service center.
Notational
Power
Installation
Clean
Other
Do not remove cover(or back). No user serviceable parts inside.
zThis may cause an electric shock or a fire.
zRefer servicing to qualified service personnel.
If your monitor does not operate normally - in particular, if there are
any unusual sounds or smells coming from it - unplug it
immediately and contact an authorized dealer or service.
zThis may cause an electric shock or a fire.
Do not place any heavy objects on the monitor.
zThis may cause an electric shock or a fire.
For each hour of looking at the monitor, you should let your eyes
rest for 5 minutes.
zThis will reduce eye fatigue.
Do not use or store inflammable substances near the monitor.
zThis may cause an explosion or fire.
Do not try to move the monitor by pulling on the wire or the signal
cable.
zThis may cause a breakdown, electric shock or a fire due to
damage to the cable.
Do not move the monitor right or left by pulling only the wire or the
signal cable.
zThis may cause a breakdown, electric shock or a fire due to
damage to the cable.
Never insert anything metallic into the monitor openings.
zThis may cause an electric shock, fire or injury.
Keep the monitor away from any magnetic substances.
zThis may cause discoloring or distortion of the image.
Unpacking
Front
Rear
Bottom
Monitor and Stand
(Some models include a stand attached. )
Please make sure the following items are included
with your monitor. If any items are missing,
contact your dealer.
Power Cord
Stand
Signal Cable (Option)
Quick Setup Guide
Warranty Card
(Not available in all locations)
User's Guide and
Driver Installation CD
USB Cable
Unpacking
Front
Rear
Bottom
1. Highlight button The Highlight Zone ensures clear images on TVs, video conferencing
systems or photos by emphasizing a certain area on the screen.
2. Exit button Use this button for Exit the active menu or the OSD.
3. Adjust buttons These buttons allow you to highlight and adjust items in the menu.
4. Menu button Use this button for open the OSD and activate a highlighted menu item.
5. Power indicator This light glows green during normal operation, and blinks green once as
the monitor saves your adjustments.
6. Power button Use this button for turn the monitor on and off.
Note:
See PowerSaver described in the manual for further information regarding power saving
functions. For energy conservation, turn your monitor OFF when it is not needed, or when
leaving it unattended for long periods.
Unpacking
Front
Rear
Bottom
(The configuration at the back of the monitor may vary from product to product.)
1. Power port Connect the power cord for your monitor to the power port on the back of
the monitor.
2. Signal port Connect the signal cable to the 15-pin D-sub connector on the back of
your monitor.
3. BNC Connectors
(Option)
Connect the signal cable to the BNC signal port on the back of your
monitor.
4. USB Connector
(Option)
Connect the USB cable to the USB port on the back of your monitor.
Note:
See Connecting Your Monitor for further information regarding cable connections.
Andere Handbücher für SyncMaster 1100 DF
1
Inhaltsverzeichnis
Andere Samsung Monitor Handbücher
Samsung
Samsung IAB110 2K Bedienungsanleitung
Samsung
Samsung PS-42C6HR Bedienungsanleitung
Samsung
Samsung 320MP-2 - SyncMaster - 32" LCD Flat Panel... Bedienungsanleitung
Samsung
Samsung C43J890DK Series Bedienungsanleitung
Samsung
Samsung SyncMaster BN59-00654D-04 Bedienungsanleitung
Samsung
Samsung SyncMaster 400DX-3 Bedienungsanleitung
Samsung
Samsung PPM50M7F Bedienungsanleitung
Samsung
Samsung SyncMaster 750ST Bedienungsanleitung
Samsung
Samsung XL30 - SyncMaster - 30" LCD Monitor Bedienungsanleitung
Samsung
Samsung SyncMaster 2494LW Bedienungsanleitung
Samsung
Samsung OH46F Bedienungsanleitung
Samsung
Samsung S22B370B Bedienungsanleitung
Samsung
Samsung 910MP - SyncMaster 19" LCD Monitor Bedienungsanleitung
Samsung
Samsung CFG7 Series Bedienungsanleitung
Samsung
Samsung SyncMaster 2063UW Benutzerhandbuch
Samsung
Samsung S32BM80BUN Bedienungsanleitung
Samsung
Samsung SyncMaster 320TSn-3 Bedienungsanleitung
Samsung
Samsung 2263DX - SyncMaster - 22" LCD Monitor Bedienungsanleitung
Samsung
Samsung SyncMaster S22A300B Bedienungsanleitung
Samsung
Samsung DH40D Bedienungsanleitung
