Samsung SyncMaster 153V Bedienungsanleitung

http://www.samsung-monitor.com

http://www.samsungusa.com/monitor

BN68-00414C-00

SyncMaster 153V/173V

Contents English

Safety Instructions

Unpacking Your Monitor

Setting up Your Monitor

Connecting Your Monitor

Self-Test Feature Check

Werning Messages

Environment

Useful Tips

Adjusting Your Monitor

User Controls

Menu Features

Brightness

Contrast

Image Lock

Fine

Coarse

H-Position

V-Position

Reset Geometry Reset

Color Reset

Color Temperature

Color Control

Language

Menu Position

H-Position

V-Position

Menu Display Time

Display Mode

Auto Adjustment

OSD Lock/Unlock

Power Saver

Troubleshooting

Specifications

Display Modes

Safety Instructions

1. Do not use a damaged or loose plug.

2. Do not pull the plug out by the wire nor touch the plug with wet hands.

3. Use only a properly grounded plug and receptacle.

4. Do not excessively bend the plug and wire nor place heavy objects upon them, which could cause damage.

5. Disconnect the plug from the outlet during storms or lightening or if it is not used for a long period of time.

6. Do not connect too many extension cords or plugs to an outlet.

7. Do not cover the vents on the monitor cabinet.

8. Put your monitor in a location with low humidity and a minimum of dust.

9. Do not drop the monitor when moving it.

10. Place the monitor on a flat and stable surface.

11. Set down the monitor carefully.

12. Do not place the monitor face down.

13. Do not spray detergent directly on the monitor.

14. Use the recommended detergent with a smooth cloth.

15. If the connector between the plug and the pin is dusty or dirty, clean it properly with a dry cloth.

16. Do not set a glass of water, chemicals or any small metal objects on the monitor.

17. Do not remove cover(or back). No user serviceable parts inside.

18. If your monitor does not operate normally - in particular, if there are any unusual sounds or smells coming

from it - unplug it immediately and contact an authorized deal-er or service.

19. Do not place any heavy objects on the monitor.

20. For each hour of looking at the monitor, you should let your eyes rest for 5 minutes.

21. Do not use or store inflammable substances near the monitor.

22. Do not try to move the monitor by pulling on the wire or the signal cable.

23. Do not move the monitor right or left by pulling only the wire or the signal cable.

24. Never insert anything metallic into the monitor openings.

Unpacking Your Monitor

Monitor and Stand

Power Cord

User Manual

Signal Cable

General

Please make sure the following items are

included with your monitor. If any items are

missing, contact your dealer.

Setting up Your Monitor

Connecting Your Monitor

1. Connect the power cord for your monitor to the power port on the back of the monitor.

Plug the power cord for the monitor into a nearby outlet.

2. Connect the signal cable to the 15-pin, D-sub connector on the back of your monitor.

3. Connect the monitor to the Macintosh computer using the D-SUB connection cable.

4. In the case of an old model Macintosh, you need to connect the monitor

using a special Mac adaptor.

5. Turn on your computer and monitor. If your monitor displays an image, installation is complete.

Setup-General

Rear of Monitor

Rear of Computer

New Model Macintosh

Old Model Macintosh

Failure of any of the boxes to appear indicates a problem with your monitor. This box also appears

during normal operation if the video cable becomes disconnected or damaged.

4. Turn off your monitor and reconnect the video cable; then turn on both your computer and the monitor.

If your monitor screen remains blank after using the previous procedure, check your video controller

and computer system; your monitor is functioning properly.

Setting up Your Monitor

Self-Test Feature Check

1. Turn off both your computer and the monitor.

2. Unplug the video cable from the back of the computer.

3. Turn on the monitor.

If the monitor is functioning properly, you will see a box with a border and text inside

as shown in the following illustration:

The three boxes inside the border are red, green and blue.

Your monitor provides a self test feature that allows you to check whether your monitor

is functioning properly.

Setting up Your Monitor

Warning Messages

If there is something wrong with the input signal, a message appears on the screen or the screen

goes blank although the power indicator LED is still on. The message may indicate that the

monitor is out of scan range or that you need to check the signal cable.

Environment

The location and the position of the monitor may influence the quality and other features of the monitor.

1. If there are any woofer speakers near the monitor, unplug and relocate the

woofer to another room.

2. Remove all electronic devices such as radios, fans, clocks and telephones that

are within 3 feet (one meter) of the monitor.

Useful Tips

A monitor recreates visual signals received from the PC. Therefore, if there is trouble with the PC or

the video card, this can cause the monitor to become blank, have poor coloring, noise, Video mode

not supported, etc. In this case, first check the source of the problem, and then contact a service

center or your dealer.

Judging the monitor's working condition

If there is no image on the screen or an “Video mode not supported” message comes up,

disconnect the cable from the computer while the monitor is still powered on.

If there is a message coming up on the screen or if the screen goes white, this means the

monitor is in working condition.

In this case, check the computer for trouble.

Adjusting Your Monitor

User Controls

1. Use this button to open the OSD and

activate a highlighted menu item.

2. Use These buttons to highlight and adjust items using

the On Screen Display. These buttons are also direct

access buttons for the brightness feature.

3. Use this button to Exit the active menu or the OSD.

3 1 2

Adjusting Your Monitor

Brightness

1. Push the Menu ( ) button.

2. Push the - button or + button until the

Contrast screen is displayed.

3. Push the Menu ( ) button to open the

Contrast adjustment screen.

4. Use the + button to increase the contrast or - button

to decrease the contrast.

Contrast

1. Push the Menu ( ) button.

2. Push the Menu ( ) button to open the

Brightness adjustment screen.

3. Use the + button to increase the brightness or - button

to decrease the brightness.

Direct Access Feature :

When OSD is not on the screen, Push the + or - button to

adjust brightness.

Adjust the Contrast.

Adjust the Brightness.

1. Push the Menu ( ) button.

2. Push the - button or + button until the Image Lock screen

is displayed.

3. Push the Menu ( ) button twice to open the

Fine adjustment screen.

4. Use the - or + buttons to remove any noise.

Adjusting Your Monitor

Image Lock is used to fine tune and get the best image by

removing noises that creates unstable images with jitters

and shimmers. If satisfactory results are not obtained using

the Fine adjustment, use the Coarse adjustment and then

use Fine again.

Image Lock

Fine

1. Push the Menu ( ) button.

2. Push the - button or + button until the Image Lock screen

is displayed.

3. Push the Menu ( ) button again and then

press the - or + button until the Coarse screen appears.

Push the Menu ( ) button to open the Coarse adjustment

screen.

4. Use the - or + buttons to remove any noise.

Image Lock is used to fine tune and get the best image by

removing noises that creates unstable images with jitters

and shimmers. If satisfactory results are not obtained using

the Fine adjustment, use the Coarse adjustment and then

use Fine again.

Coarse

Andere Handbücher für SyncMaster 153V

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Samsung Monitor Handbücher

Samsung

Samsung SyncMaster 2494HM Bedienungsanleitung

Samsung

Samsung PPM63H3 Bedienungsanleitung

Samsung

Samsung SyncMaster S23A750D Bedienungsanleitung

Samsung

Samsung S27BM500EE Bedienungsanleitung

Samsung

Samsung FP-T6374 Bedienungsanleitung

Samsung

Samsung SyncMaster 743A Bedienungsanleitung

Samsung

Samsung 2.008031020191e16 Bedienungsanleitung

Samsung

Samsung LW22N23N Bedienungsanleitung

Samsung

Samsung SyncMaster C27A750X Benutzerhandbuch

Samsung

Samsung Flip WM55H Bedienungsanleitung

Samsung

Samsung C27T55 Series Bedienungsanleitung

Samsung

Samsung HC673 Bedienungsanleitung

Samsung

Samsung S27C390EAE Bedienungsanleitung

Samsung

Samsung LN37D567F9H Kurzanleitung

Samsung

Samsung S22D360Q Bedienungsanleitung

Samsung

Samsung SyncMaster 225MD Bedienungsanleitung

Samsung

Samsung S22F352FH Bedienungsanleitung

Samsung

Samsung SyncMaster S19B420BW Bedienungsanleitung

Samsung

Samsung C27H800 Bedienungsanleitung

Samsung

Samsung SMT-1930 Bedienungsanleitung

Samsung

Samsung 214T - SyncMaster - 21.3" LCD Monitor Bedienungsanleitung

Samsung

Samsung T220 - SyncMaster - 22" LCD Monitor Bedienungsanleitung

Samsung

Samsung SyncMaster 320TFT Bedienungsanleitung

Samsung

Samsung DC43H Bedienungsanleitung

Beliebte Monitor Handbücher anderer Marken

Linear Acoustic

Linear Acoustic LQ-1000 Bedienungsanleitung

AOC

AOC I2579V Bedienungsanleitung

Gateway

Gateway FPD1520 Bedienungsanleitung

Furuno

Furuno Mu 120c Bedienungsanleitung

Asus

Asus VB171D - 17" LCD Monitor Bedienungsanleitung

Dell

Dell S2230MX Gebrauchsanweisung

Philips

Philips 107C64 Bedienungsanleitung

Dell

Dell S2409WFP Bedienungsanleitung

EverFocus

EverFocus EN-7517E Bedienungsanleitung

Panasonic

Panasonic TH152UX1 - 152" PLASMA TV Bedienungsanleitung

Dell

Dell Precision 7680 Bedienungsanleitung

LG 50PM1M - - 50" Plasma Panel Bedienungsanleitung

Bosch

Bosch DDU 9 Bedienungsanleitung

Acer

Acer A231HL Bedienungsanleitung

Philips

Philips 86BDL4152T Bedienungsanleitung

NEC

NEC AccuSync LCD5V Bedienungsanleitung

Emay

Emay SleepO2 Bedienungsanleitung

IBM

IBM 6360 Montageanleitung