Samsung SRP-250 Series Bedienungsanleitung

Operator’s Manual

All specifications are subjected to change without notice

SRP-250

SERIES

1 STATION PRINTER

All manuals and user guides at all-guides.com

all-guides.com

Warning -U.S.

This equipment has been tested and found to comply with the limits for a Class A digital device

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment is operated in a commercial

environment. This equipment generates uses, and can radiate radio frequency energy and if

not installed and used according to the instruction manual, may cause harmful interference to

radio communications. Operation of this equipment in a residential area is likely to cause

harmful interference in which case the user will be required to correct the interference at his

own expense.

Notice -Canada

This Apparatus complies with class “A” limits for radio interference as specified i n the

Canadian department of communications radio interference regulations.

Get appareil est conforme aux normes class “A” d’interference radio tel que specifier par

ministre canadien des communications dans les reglements d’interference radio.

Caution

Some semiconductor devices are easily damaged by static electricity. You should turn the

printer “OFF”, before you connect or remove the cables on the rear side, in order to guard the

printer against the static electricity. If the printer is damaged by the static electricity, you should

turn the printer “OFF”.

INTRODUCTION

The SRP-250 and SRP-250P Roll Printer are designed for use with electronic instruments

such as system ECR, POS, banking equipment, computer peripheral equipment, etc.

The main features of the printer are as follows:

1. High speed printing : 3.5 lines per seconds.

2. 2 color dot-matrix printer.

3. RS-232 serial interface (SRP-250). Parallel interface (SRP-250P)

4. The data buffer allows the unit to receive print data even during printing.

5. Peripheral units drive circuit enables control of external devices such as

cash drawer.

6. Characters can be scaled up to 64 times compared to it’s original size.

7. Bar code printing is possible by using a bar code command.

8. Different print densities can be selected by DIP switches.

Please be sure to read the instruction in this manual carefully before using your new

SRP-250/SRP-250P.

NOTE : The socket-outlet shall be near the equipment and it

shall be easy accessible.

All manuals and user guides at all-guides.com

Table of Contents

CHAPTER 1. UNPACKING...................................................................3

1-1. CHECKING THE CONTENTS OF THE PRINTER BOX...............................3

1-2. LOCATING THE PRINTER .................................................................3

1-3. FUNCTIONS ..................................................................................4

CHAPTER 2. CONNECTING THE CABLES.........................................5

2-1. CONNECTING THE AC ADAPTER TO THE PRINTER..............................5

2-2. CONNECTING INTERFACE CABLE AND DRAWER

CABLE TO THE PRINTER ................................................................6

CHAPTER 3. INSTALLING THE ROLL PAPER...................................7

3-1. RIBBON CASSETTE INSTALLATION ...................................................7

3-2. ROLL PAPER INSTALLATION ............................................................8

CHAPTER 4. SETTING THE DIP SWITCHES....................................12

CHAPTER 5. HEXADECIMAL DUMPING...........................................15

CHAPTER 6. THE SELF TEST...........................................................16

CHAPTER 7. CODE TABLE...............................................................17

CHAPTER 8. CONTROL COMMANDS...............................................22

APPENDIX A ......................................................................................39

CONNECTORS....................................................................................39

Interface Connector......................................................................40

Drawer Connector ........................................................................42

APPENDIX B ......................................................................................43

SPECIFICATION ..................................................................................43

APPENDIX C ......................................................................................44

REMOVING JAMMED PAPER (A)............................................................44

REMOVING JAMMED PAPER (B)............................................................46

All manuals and user guides at all-guides.com

Chapter 1. Unpacking

1-1. Checking the Contents of the printer box

After unpacking the unit, check that all the necessary accessories are included in the

package.

1-2. Locating the printer

lAvoid locations in direct sunlight or subject to excessive heat.

lAvoid using or storing the printer in the places subject to excessive moisture.

lDo not use or store the printer in a dusty or dirty area. Avoid places subject to

intense vibration or shock.

lChoose a stable and horizontal place for proper use of the printer.

lMake sure that there is enough space around the printer so that it can be used

easily.

All manuals and user guides at all-guides.com

1-3. Functions

lThe power switch is used to turn the printer on and off.

lThe FEED button is used to feed roll paper.

lThe POWER light (green) is on when the printer is turned on and is off when the

printer is turned off.

lThe ERROR light (red) is on when the printer cover is opened.

All manuals and user guides at all-guides.com

Chapter 2. Connecting the cables

2-1. Connecting the AC adapter to the printer

1). Make sure that the printer is turned off.

2). CHECK the label on the AC adapter to make sure the voltage required by the AC

adapter matches that of your electrical outlet.

3). Plug the DC cord connector into the printer’s power connector.

4). Plug the AC adapter power cord into the wall outlet.

All manuals and user guides at all-guides.com

all-guides.com

2-2. Connecting Interface Cable and Drawer

Cable to the printer

Connect the Host Computer(POS/ECR) to the printer using an interface cable that matches

the specifications of the printer and the Host computer(POS/ECR). Be sure to use a drawer

that matches the printer's specification.

1). Turn off the printer and the Host computer(POS/ECR).

2). Plug the serial interface cable connector into the printer’s interface connector, then

tighten the screws on both sides of the connector. In case of the parallel interface,

squeeze the wire clips on the printer together until they lock in place on both sides

of the connector.

3). Plug the drawer cable into the drawer kick-out connector on the back of the printer

next to the serial/parallel connector. Do not connect a telephone line to the drawer

kick-out connector; otherwise the printer and the telephone line may be damaged.

All manuals and user guides at all-guides.com

Chapter 3. Installing the roll paper

3-1. Ribbon Cassette Installation

1). Before inserting the ribbon cassette, turn the knob counterclockwise to prevent

twisting the ribbon.

2). Insert the ribbon cassette as shown below and pay particular attention to the

placement of the ribbon behind the Print Head.

3). During inserting the ribbon cassette, turn the knob counterclockwise again to

make sure the ribbon moves freely in the cassette.

NOTE : Malfunctions and other problems may arise if other than the ribbon

cassette samsung supplied is used. Samsung does not warrant

against problems arising from the use of other than the ribbon

cassette samsung supplied

All manuals and user guides at all-guides.com

3-2. Roll Paper Installation

Be sure to use roll paper that matches the printer's specifications.

1). Make sure that the printer has no received data. Otherwise, data may be lost.

2). Open the printer cover and remove the used paper roll core if there is one.

3). To use a new roll paper, unroll the paper and tear off the end of the paper correctly.

All manuals and user guides at all-guides.com

4). Insert the Shaft-Pulley into the hole of roll paper core and load the roll paper on

the paper holder. Don't forget to turn the printer's POWER on at this time.

All manuals and user guides at all-guides.com

Andere Handbücher für SRP-250 Series

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Samsung Drucker Handbücher

Samsung

Samsung ML-1750 Lazett Benutzerhandbuch

Samsung

Samsung CLP-600 Series Bedienungsanleitung

Samsung

Samsung SCX 4500W - Personal Wireless Laser Multi-Function... Bedienungsanleitung

Samsung

Samsung SRP-270 Series Bedienungsanleitung

Samsung

Samsung Color & Monochrome Laser Printers & MFPs Bedienungsanleitung

Samsung

Samsung CLP 610ND - Color Laser Printer Bedienungsanleitung

Samsung

Samsung CLX-6260FD Benutzerhandbuch

Samsung

Samsung ML-1430 Bedienungsanleitung

Samsung

Samsung ML-4050N Bedienungsanleitung

Samsung

Samsung STP-102P Bedienungsanleitung

Samsung

Samsung Xpress C1810 series Bedienungsanleitung

Samsung

Samsung ML-1440 Bedienungsanleitung

Samsung

Samsung CLP 300N - Network-ready Color Laser Printer Bedienungsanleitung

Samsung

Samsung Xpress M3065 Series Bedienungsanleitung

Samsung

Samsung ML-4550 Series Referenzhandbuch

Samsung

Samsung CLP 500 Bedienungsanleitung

Samsung

Samsung ML-5050G Series Bedienungsanleitung

Samsung

Samsung ML-2525 Bedienungsanleitung

Samsung

Samsung SL-M3320ND Bedienungsanleitung

Samsung

Samsung CLX-4195FN Bedienungsanleitung

Samsung

Samsung ML-4551NR Bedienungsanleitung

Samsung

Samsung SCX-5315F Bedienungsanleitung

Samsung

Samsung ProXpress M458x Series Bedienungsanleitung

Samsung

Samsung Xpress C51 Series Bedienungsanleitung

Beliebte Drucker Handbücher anderer Marken

Lexmark

Lexmark 1400 Series Handbuch

Canon

Canon i70 Series Bedienungsanleitung

Evolis

Evolis Elypso Bedienungsanleitung

Kyocera

Kyocera FS-9530DN Bedienungsanleitung

Canon

Canon LASER SHOT LBP-1210 Bedienungsanleitung

Canon

Canon PIXMA PRO-1 Series Bedienungsanleitung

Canon

Canon PIXMA G3560 Einrichtungshandbuch

Dell

Dell Color Laser Printer 2130cn Bedienungsanleitung

Tektronix

Tektronix Phaser 840 Bedienungsanleitung

Epson

Epson ET-7750 Betriebsanleitung

Canon

Canon CLBR 460ps Bedienungsanleitung

Eltron

Eltron P210 Guide Bedienungsanleitung

Ricoh

Ricoh MD-P1 Bedienungsanleitung

Epson

Epson SC-F7100 series Bedienungsanleitung

Epson

Epson Stylus C40UX Bedienungsanleitung

Canon

Canon imagePASS-A2 Bedienungsanleitung

Canon

Canon S820D Bedienungsanleitung

IRA3D

IRA3D POETRY4 Bedienungsanleitung