SAMSys MP9320 Bedienungsanleitung

ser’s

Guide MP9320

UHF Long-Range Reader

SAMSys

MP9320 UHF Long-Range Reader

Owner’s Manual

Third Edition (January 2004)

Disclaimer and Limitation of Liability

The content of this manual is for information use only and is subject to change without notice. SAMSys assumes

no responsibility or liability for any errors or inaccuracies that may appear in this publication. No part of this

manual may be reproduced in any form or by any means, electronic, mechanical, recording, or otherwise, without

the prior written permission of SAMSys.

SAMSys products are not designed, intended, authorized or warranted to be suitable for life support applications

or any other life critical applications which could involve potential risk of death, personal injury, property damage,

or environmental damage.

About SAMSys

SAMSys is the world leader in the design and supply of radio frequency identification (RFID) hardware solutions

for high volume pallet and reusable container tracking applications in global logistics management, materials

handling, and supply chain industries. SAMSys is a public company listed on the Canadian Venture Exchange

under the symbol SMY.

SAMSys Technologies, Inc.

44 East Beaver Creek Rd., Unit 11

Richmond Hill, Ontario L4B 1G8 Canada

Phone: (905) 707-0404

Toll Free: (877) 463-6546

Fax: (905) 707-9944

E-mail: [email protected]

Web: www.samsys.com

Part Number: HI46932-01-OM-V3.2

Federal Communications Commission (FCC) Notice (Preliminary)

This device was tested and found to comply with the limits set forth in Part 15 of the FCC Rules. Operation is

subject to the following conditions: (1) this device may not cause harmful interference, and (2) this device must

accept any interference received including interference that may cause undesired operation. These limits are

designed to provide reasonable protection against harmful interference when the equipment is operated in a

commercial environment.

This device generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with

the instruction manual, the product may cause harmful interference to radio communications. Operation of this

product in a residential area is likely to cause harmful interference, in which case, the user is required to correct

the interference at their own expense.

The authority to operate this product is conditioned by the requirements that no modifications be made to the

equipment unless the changes or modifications are expressly approved by SAMSys Technologies.

Trademarks

SAMSys is a trademark of SAMSys Technologies, Inc.

HyperTerminalis a registered trademark of Hilgraeve, Inc.

Other company, product or service names appearing in this manual may be trademarks or service marks of their

respective owners.

MP9320 User’s Guide

Contents

Chapter 1 – Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

Unpacking the Reader . . . . . . . . . . . . . . . . . . . . . . . . . . . 2

About the MP9320 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Physical Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

Chapter 2 – Getting Started . . . . . . . . . . . . . . . . . . . . . . . . 7

Installing the SSTool Application . . . . . . . . . . . . . . . . . . 8

Configuring for Single or Multiple Readers . . . . . . . . . . 8

Configuring the Serial Port . . . . . . . . . . . . . . . . . . . . . . . 8

Connecting the Reader to a Terminal . . . . . . . . . . . . . . . 9

Connecting the Reader to the ICCM . . . . . . . . . . . . . . . . 9

Setting the RF Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9

Activating Tag Protocols . . . . . . . . . . . . . . . . . . . . . . . . . 11

Selecting the Number of Antennas . . . . . . . . . . . . . . . . . 12

Reading tags . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12

Chapter 3 – Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13

Antenna Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14

Reader Mechanical Installation . . . . . . . . . . . . . . . . . . . . 17

Standalone Reader/PC Communication Setup . . . . . . . . 21

Standalone Reader/PC Verification . . . . . . . . . . . . . . . . . 22

Standalone Reader/ICCM Communication Setup . . . . . . 23

Standalone Reader/ICCM Verification . . . . . . . . . . . . . . 24

Networked Reader Communication Setup . . . . . . . . . . . 25

Networked Reader Verification . . . . . . . . . . . . . . . . . . . . 26

Digital (TTL) Input/Output Setup . . . . . . . . . . . . . . . . . . 27

Main I/O Connector Modification . . . . . . . . . . . . . . . . . . 28

Transmit Power Calibration . . . . . . . . . . . . . . . . . . . . . . . 28

MP9320 User’s Guide

Chapter 4 – Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29

Reader Power Up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30

Reading Tags . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32

Operation with the ICCM . . . . . . . . . . . . . . . . . . . . . . . . 33

Chapter 5 – Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . 35

General Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . 36

Chapter 6 – Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . 31

Reader Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . 42

Environmental Specifications . . . . . . . . . . . . . . . . . . . . . 42

Battery Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . 42

Power Supply Specifications . . . . . . . . . . . . . . . . . . . . . . 43

RS-232 Connector Specifications . . . . . . . . . . . . . . . . . . 43

Main I/O Connector Specifications . . . . . . . . . . . . . . . . . 44

Antenna Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . 45

Regulatory Standards . . . . . . . . . . . . . . . . . . . . . . . . . . . . 46

Appendix A – Reader Configuration . . . . . . . . . . . . . . . . . 49

Operating Modes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50

Default Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . 51

Changing Reader Configuration . . . . . . . . . . . . . . . . . . . 52

Updating Reader Firmware . . . . . . . . . . . . . . . . . . . . . . . 54

MP9320 User’s Guide

iii

Figures

MP9320 Reader and Accessories . . . . . . . . . . . . . . . . . . 2

SAMSys Reader Network . . . . . . . . . . . . . . . . . . . . . . . . 4

MP9320 LED Status Indicators . . . . . . . . . . . . . . . . . . . . 5

MP9320 Active Antenna LED Indicators . . . . . . . . . . . . 6

MP9320 End-Panel Connectors . . . . . . . . . . . . . . . . . . . . 6

MP9320 Antenna Configurations . . . . . . . . . . . . . . . . . . 14

MP9320 Reader Installations . . . . . . . . . . . . . . . . . . . . . . 17

MP9320 Base Plate with Mounting Keyholes . . . . . . . . . 18

MP9320/PC Standalone RS-232 Communication Setup .21

MP9320/ICCM Standalone RS-232 Comm Setup . . . . . 23

MP9320 RS-485 Communication Setup . . . . . . . . . . . . . 25

Digital Input and Output Port Configuration . . . . . . . . . . 27

LED Startup Sequence . . . . . . . . . . . . . . . . . . . . . . . . . . . 30

Power LED On – Reader Operational . . . . . . . . . . . . . . . 30

Active Antenna LED Indicators - Ant 2 Transmitting . . 31

LED Indicators - Tag Successfully Read . . . . . . . . . . . . . 32

RS-232 Connector . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43

Main I/O Connector . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44

Optional Communication Cable Pinout . . . . . . . . . . . . . . 45

Firmware Upload System Configuration . . . . . . . . . . . . . 54

MP9320 User’s Guide

Chapter 1

Introduction

This chapter provides a general description of the MP9320.

Topics discussed in this chapter include the following:

•Unpacking the Reader

•About the MP9320

•Physical Description

MP9320 User’s Guide

Unpacking the Reader

After opening the shipping container perform the following:

1. Unpack the contents of the shipping container.

2. Inspect the shipping container for damage. If damaged, notify

the carrier and SAMSys Technologies. Keep the shipping

materials for inspection by the carrier.

3. Verify your reader package includes the following items:

•MP9320 UHF Long-Range Reader

•Power cord

•15Vdc power supply with cable

•Sample RFID tags

•RS-232 communication cable

•System documentation CD

•Antennas (optional)

Figure 1–MP9320 Reader and Accessories

Inhaltsverzeichnis

Andere SAMSys RFID-System Handbücher

SAMSys

SAMSys MP9210 Bedienungsanleitung

Beliebte RFID-System Handbücher anderer Marken

Chainway

Chainway R1 Bedienungsanleitung

IFM

IFM DTC600 Bedienungsanleitung

Elatec

Elatec TWN4 MULTITECH NANO LEGIC 63 M Bedienungsanleitung

RHOMBUS

RHOMBUS DR20 Bedienungsanleitung

Sirit

Sirit IDentity 6204 Bedienungsanleitung

SOREX

SOREX FLEX Bedienungsanleitung

Omron

Omron V780-HMD68-EIP-KR Bedienungsanleitung

IDENTEC SOLUTIONS

IDENTEC SOLUTIONS iPOINT Si Gebrauchsanweisung

Shuttle

Shuttle BR06 Gebrauchsanweisung

Digilock

Digilock Curve Keypad Basic Bedienungsanleitung

Atid

Atid AT870 Bedienungsanleitung

Chacon

Chacon 34958 Bedienungsanleitung

Paxton

Paxton PROXIMITY architectural reader Bedienungsanleitung

CipherLab

CipherLab 1800 series Bedienungsanleitung

Brady

Brady FR22 Bedienungsanleitung

Kronotech

Kronotech BLUEBOX GEN2 M30 UHF Bedienungsanleitung

Unitech

Unitech RH767 Bedienungsanleitung

Honeywell

Honeywell 026366.00 Bedienungsanleitung