Sangean ATS-303 Bedienungsanleitung

ATS-303

TUNING

POWER

STAND BY

DISPLAY

TIME SET

STEREO

MONO

TUNING

MEMO

PRESET TUNING

FM MW Sw1 Sw2

6V DC6V DC

VOLUMEVOLUME MINMIN WTAND BYWTAND BY

MAXMAX

2 3

LCD DISPLAY Frequency, time and function displays

MEMO1-5 Entering commands

STAND BY Alarm standby

DISPLAY Time display and time input

TIME SET

STEREO/MONO Switching from Stereo/Mono

10-90 Sleep

PRESET TUNING 1-5 Station keys

TUNING< > Setting stations manually

Automatic station search

Entering clock time and alarm time

POWER

sleep function

FM/MW/SW1/SW2 Frequency range key

VOLUME Volume

MIN MAX

STAND BY Radio alarm or beeper alarm

6V DC

Stereo headphone socket

Battery compartment

Telescopic antenna

Stand

TUNING Tuning display

Elements of operation

Locking key for locking the operation setting

Socket for an external mains-supply-unit

On/off key,Switching off the alarm and the

SW FREQ Switching over the automatic tuner

METER Searching through the SW metric channels

FULL Searching through all frequencies

9K/10K Tuning steps 9kHz/10kHz

Displays

Selecting a frequency range

Frequency and time displays

kHz for MW/MHz for FM and SW

Radio alarm

HWS beeper alarm

Sleep

Mode of operation locked

FM stereo (only with headphones)

Memory slots 1-5

Battery condition

This appliance can be operated with:

4 Mignon batteries 1.5 Volt,Type IEC R6/UM3/AA or

Open the battery compartment by pressing on the finger groove on

the lid of the battery compartmint and pulling it down.lnsert4,

1.5 Volt Mignon-batteries taking care that the polarity of the batteries

corresponds with that shown next to the battery compartment.

The battery symbol blinks when the batteries are empty.The chan-

ging of the batteries must not take more than three minutes so that

the stored values(time/alarm time/station keys)are not lost.

Power supply

Changing the batteries

Remove exhausted batteries

from the appliance immediately

to avoid their leaking into the

appliance.

Batteries are also to be removed

when not using the appliance for

longer periods of time.

Slide the lid of the battery compratment back until it clicks into place.

In accordance with the world standard,the time is displayed on a 24

hour basis(Greenwich mean time).

The clock is ready for operation after four 1.5 volt Mignon batteries

have been inserted into the battery compartment.

Press the DISPLAY/TIME SET key a little longer than half a se-

cond.0:00 blinks in the display.

RADIO

Setting the clock

Selecting a frequency range

FM MW Sw1 Sw2

Enter the time using the TUNING

keys while the display is bin-

king.

The < key adjusts the hours and

the > key adjusts the minutes.

To start the time display press

DISPLAY/TIME SET once

again.

If DISPLAY/TIME SET is not pressed after entering the time,the

time you have set becomes valid automatically after approx.5 se-

conds.

By opening the stand the appliance can be operated on a slant.

The selection of a frequency ran-

ge is made using the frequency

range switch

FM/MW/SW1/SW2 while this is

shown in the display.

FM 87.5-108MHz FM

MW 522-1620kHz Medium wave with 9 kHz tuning steps

MW 520-1710kHz Medium wave with 10 kHz tuning steps

SW1 2.3-7.3MHz Short wave 120-41m

Sw2 9.5-26.1MHz Short wave 31-11m

After switching on the appliance using the POWER key ,the fre-

quency range and frequency which were last used are shown in the

display.After switching the wave range switch,the channel and fre-

quency selected appear in the display.

The station search in the SW range can be altered as a basicsetting

using the SW FREQ:METER/FULLswitch .

You can choose between:

METER = search the SW metric channels.

FULL = search all frequencies,including those outside the

SW metric channels.

RADIO

Channel Frequency range Wavelength

SW frequency

(switching over the automatic tuner)

In-built antennae

To make this choice,the SW FREQ:METER/FULL switch has to be

moved using a small screwdriver or similar instrument.

Important note:

The SW FREO: METER/FULL switch also has a RESET function.

After switching over switch and then switching the appliance

off and on, all of the stored values are erased.

Therefore, switch should be set before setting the time and the

alarm or programming the station keys.

The in-built ferrite antenna ensures high quality reception in the MW

range.By adjusting the position of the appliance the best reception

quality can be found.

The telescopic antenna is for FM and SW reception.Extend it and

adjust its alignment to find the best reception.

Switch the appliance on,select a wave range and find your desired

station by pressing the TUNING keys repeatedly.The perfect set-

ting and the strength of the reception of the station is shown by the

signal lamp TUNING.

By pressing and holding one of

the keys ,you can manually

tune up to a desired frequency

display.

The tuning process takes place as follows:

FM 100 kHz

MW 9 kHz or 10 kHz*

SW1/SW2 5 kHz

* Europe 9 kHz /USA and Canada 10 kHz

The tuning grid for the medium wave can be adjusted to 9 kHz or

10 kHz using the 9K/10K Switch inside the battery compartment.

RADIO

Manual tuning

MW tuning grid

This switch can be found inside the battery compartment and must

be moved using a small screwdriver or similar instrument.

Inhaltsverzeichnis

Andere Sangean Radio Handbücher

Sangean

Sangean WR-15 Bedienungsanleitung

Sangean

Sangean dpr-39 Bedienungsanleitung

Sangean

Sangean DT-120 Bedienungsanleitung

Sangean

Sangean PR-D7 Bedienungsanleitung

Sangean

Sangean ATS 909 Bedienungsanleitung

Sangean

Sangean CL-100 - REV 1 Bedienungsanleitung

Sangean

Sangean HD Radio HDT-20 Bedienungsanleitung

Sangean

Sangean WFR-1 - DATASHEET 3 Bedienungsanleitung

Sangean

Sangean DCR-89+ Bedienungsanleitung

Sangean

Sangean PR-D1 Bedienungsanleitung

Sangean

Sangean H201 Bedienungsanleitung

Sangean

Sangean HDR-1 Betriebsanleitung

Sangean

Sangean DDR-66BT Bedienungsanleitung

Sangean

Sangean SR-2 Bedienungsanleitung

Sangean

Sangean U4 DBT+ Bedienungsanleitung

Sangean

Sangean WFR-20 Bedienungsanleitung

Sangean

Sangean DDR-31+ Bedienungsanleitung

Sangean

Sangean ProTravel PT-80 Bedienungsanleitung

Sangean

Sangean ATS-404 Betriebsanleitung

Sangean

Sangean PR-D3L Bedienungsanleitung

Sangean

Sangean ATS-818 CS Bedienungsanleitung

Sangean

Sangean SR-25 Bedienungsanleitung

Sangean

Sangean EUPHONIC 450 Bedienungsanleitung

Sangean

Sangean MMR-77 Bedienungsanleitung

Beliebte Radio Handbücher anderer Marken

EisSound

EisSound KBSound iSelect Bedienungsanleitung

Midland

Midland 1001LWX Bedienungsanleitung

Konig

Konig HAV-SR41 Bedienungsanleitung

Roberts

Roberts exprssion Bedienungsanleitung

VDigi

VDigi DD3.0 Bedienungsanleitung

Radio Shack

Radio Shack 21-1863 Bedienungsanleitung

Roberts

Roberts Stream 207 Bedienungsanleitung

Sony

Sony Walkman SRF-M97 Bedienungsanleitung

Stanley

Stanley FatMax FMC770 Bedienungsanleitung

auna

auna DAB-Radio 10026947 Bedienungsanleitung

SOUNDMASTER

SOUNDMASTER UR190 Bedienungsanleitung

HYT

HYT TC-320 Bedienungsanleitung

B-Tech

B-Tech GMRS-V2 Bedienungsanleitung

Weierwei

Weierwei VEV-V8 Bedienungsanleitung

SOUNDMASTER

SOUNDMASTER DAB750 Bedienungsanleitung

Telefunken

Telefunken TF-1505 Bedienungsanleitung

Makita

Makita LXRM03 Bedienungsanleitung

PRESIDENT

PRESIDENT TEDDY R. Bedienungsanleitung