Sangean Pocket Radio R16 Bedienungsanleitung

Version 1

Pocket Radio R16

DT-160

Controls

Earphone jack

Memory button 1/Time setting button

Memory button 2/STEP button

Memory button 3

Memory button 4/Mono/Stereo button

Memory button 5/DBB button

POWER/BAND button

LCD display

TUNE/SET jog wheel

Strap holder

Volume button

Lock switch

Battery compartment

Display

Selected band

Battery power indicator

Signal level indicator

FM stereo indicator

90 minutes auto shut off

Key lock function

Memory presets

SET indicator

DBB indicator

NARR indicator

Frequency and time display

Battery Installation

The Battery cover is located on the back of the unit. Slide the

cover downwards to gain access to the battery compartment.

Insert two AA (UM-3) batteries into the compartment. Make

sure that the battery is positioned in accordance with the

indicated diagram. Replace cover.

Press and release the POWER/BAND button will turn on the

radio.Press and hold the POWER/BAND button until “off”

symbol appears on the LCD display. The radio will turn off.

Note:

1. You can always monitor the battery power from the LCD

display battery icon when battery power becomes very low

and unable to operate the radio. The low battery indicator

icon will ash together with an “E” appearing on the LCD

display. The radio will shut off.

2. Make sure to replace the batteries within 3 minutes. This

will prevent any memory presets from being lost during the

battery replacement.

Time setting

Press in the TUNE/SET jog wheel, the “SET” symbol will appear

on the LCD display. Press and release the Time setting button.

Hour will ash, turn the jog wheel up/down to choose your desired

time and then press the Time setting button to select the desired

hour. After completion of the hour setting the minutes digits will

then ash, follow the above setting steps to set the minutes.

Antenna/Earphone

Insert the earphone into the earphone jack. The cord

connecting the earphone to the receiver acts as an antenna

during FM audio reception and should be extended as much

as possible to increase the sensitivity.

A built-in ferrite bar antenna is provided for AM reception,

it is only necessary to rotate the radio for maximum signal

strength during AM listening.

Note:

To prevent possible hearing damage, do not listen at

high volume levels for long periods.

Volume Control

Use the volume control to adjust volume level. Display will

show the changes when you operate the volume control.

Tuning the radio

Band AM

Frequency 522-1710 kHz (9 kHz)

520-1710 kHz (10 kHz)

Antenna Internal/rotate radio for best reception

Band FM

Frequency 87.50-108 MHz

Antenna External/Make sure the earphones are

plugged into earphone jack

AM/FM Bandwidth narrowing

In order to obtain better reception of weaker AM/FM stations,

your radio has a function to narrow the AM/FM bandwidth to

reduce high frequency noise.

1. Select the AM or FM band by pressing the POWER/BAND

button.

2. Press in the jog wheel, the “SET” symbol will appear on the

LCD display. Press Volume up button, display will appear

“NARR” symbol to enter the auto bandwidth narrowing adjustment

for improved sound quality. Press in the jog wheel, the “SET”

symbol appears again, then press Volume up button will

cancel the “NARR”.

Note:

Sangean suggests activating the “NARR” when listening to

talk Radio programs. This may improve sound quality. Please

note that activation of the "NARR" may cause Stereo invalid

and produce mono sound.

90 Minutes auto shut off feature

For saving battery power, this radio is designed to auto shut

off after 90 minutes of operation. The LCD display will show

icon when pressing the POWER/BAND button to turn on the

radio.

For continuous listening if necessary, pressing the POWER/

BAND button for more than 2 seconds when the radio is in

power off mode. The icon will disappear.

Scan Tuning

Turn on the radio, select the required band by pressing the

POWER/BAND button. Turn and hold the jog wheel up/down

for more than half a second and release the jog wheel

to commence Scan Tuning. The radio will scan and stop

automatically when a station is found.

Manual Tuning

Turn on the radio, select the desired band by pressing the

POWER/BAND button. Desired station may be selected by

turning the jog wheel up/down repeatedly until the desired

station is reached.

Memory Tuning (Station preset)

Turn on the radio by pressing and releasing POWER/BAND

button. Select the required band by pressing POWER/BAND

button. Tune to the desired station using the Scan or Manual

tuning steps described above. When the desired station is

reached, press and hold Memory button (1-5) for more than

2 seconds until display M x stops flashing followed with a

beep (via earphone). You may store 5 memory stations in

each band (AM, FMI, FMII). Stations which are already stored

in the presets may be over written by following the above

procedure.

Recall memory stations

Turn on the radio, select the required band, then simply press

and release the Memory station button. The LCD display will

show the Memory preset and radio frequency.

Stereo/Mono switch

The radio is designed to receive FM stereo broadcastings.

For weak FM signal, press in the jog wheel, the “SET” symbol

will appear on the LCD display. Then press MO/ST button

to switch Stereo/Mono to Mono position. The LCD display

Stereo icon will disappear.

DBB (Dynamic Bass Boost)

Press in the jog wheel, the “SET” symbol will appear on the

LCD display. Press and release DBB button to activate the

Deep Bass Boost function to have stronger bass sound, the

display will appear the “DBB” symbol. Press in the jog wheel,

the “SET” symbol will appear again, pressing the DBB button

will cancel the DBB function.

Note:

Sangean suggests activating the DBB when using earphones.

Software version

The software display cannot be altered and is just for your

reference.

1. Press in the jog wheel, the “SET” symbol will appear on the

LCD display. Press and hold the STEP button when your

radio is in power off mode, the screen will show the software

version (e.g. A03).

2. Continue pressing and holding the STEP button and the

radio will enter FM/AM step setting.

FM/AM step setting

3. The screen will show FM tuning step (i.e. FM1 50 or 100).

Turn the jog wheel up/down to choose between 50 kHz or

100kHz and then press the STEP button to confirm your

setting.

4. After your completion of FM tuning step, the screen will show

AM tuning step (i.e. 9 or 10). Turn the jog wheel up/down to

choose between 9 kHz or 10 kHz and press the STEP button

to conrm your selection.

Important:

Resetting the frequency range and tuning step will erase all

the preset stations stored in your radio.

North America FM: 100 KHz

AM: 10 KHz

Rest of the World FM: 50 KHz

AM: 9 KHz

Key Lock Function

The key lock function is used to prevent unintentional

operation of the radio. The Key Lock switch is located on the

rear of the radio. When the key lock is set to LOCK, every

button will be disabled and a key lock icon will appear on

the screen. To disable the key lock function, switch the key

lock button to the off position. The key lock function will be

disabled.

Reset the radio

If your radio fails to operate correctly or some digits on the

display are missing or incomplete, reset the product as

described below to resume normal operation. The system

reset can be carried out while the unit is powered off.

1. Make sure your radio is switched off.

2. Press in the jog wheel, the “SET” symbol will appear on the

LCD display. Then press and hold the Volume down button

more than 2 seconds, the “dEF”symbol will appear and ash.

Continue holding down this button until all the icons show

on the display. Now all conguration settings will be stored

to their defaults, preset stations will be erased and the clock

will be reset.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Sangean Radio Handbücher

Sangean

Sangean WFR-28BT Bedienungsanleitung

Sangean

Sangean DPR-2 Bedienungsanleitung

Sangean

Sangean WFT-1D+ Bedienungsanleitung

Sangean

Sangean WR-1 Bedienungsanleitung

Sangean

Sangean DDR-7 Bedienungsanleitung

Sangean

Sangean Vocal 170 Bedienungsanleitung

Sangean

Sangean WFR-28C Bedienungsanleitung

Sangean

Sangean SR-25 Bedienungsanleitung

Sangean

Sangean ProTravel PT-80 Bedienungsanleitung

Sangean

Sangean HDR-1 - 04-2007 Bedienungsanleitung

Sangean

Sangean WFR-20 Bedienungsanleitung

Sangean

Sangean Pocket 640 Bedienungsanleitung

Sangean

Sangean H201 Bedienungsanleitung

Sangean

Sangean WFR-20 Bedienungsanleitung

Sangean

Sangean WFR-1 - DATASHEET 3 Bedienungsanleitung

Sangean

Sangean WR-2 Bedienungsanleitung

Sangean

Sangean U2 Bedienungsanleitung

Sangean

Sangean WR-3 Betriebsanleitung

Sangean

Sangean MMR-88 Bedienungsanleitung

Sangean

Sangean DT-110 Bedienungsanleitung

Sangean

Sangean PR-D18 Bedienungsanleitung

Sangean

Sangean DPR-77 Bedienungsanleitung

Sangean

Sangean ProTravel PT-80 Bedienungsanleitung

Sangean

Sangean SR-32 Bedienungsanleitung

Beliebte Radio Handbücher anderer Marken

EisSound

EisSound KBSound iSelect Bedienungsanleitung

Midland

Midland 1001LWX Bedienungsanleitung

Konig

Konig HAV-SR41 Bedienungsanleitung

Roberts

Roberts exprssion Bedienungsanleitung

VDigi

VDigi DD3.0 Bedienungsanleitung

Radio Shack

Radio Shack 21-1863 Bedienungsanleitung

Roberts

Roberts Stream 207 Bedienungsanleitung

Sony

Sony Walkman SRF-M97 Bedienungsanleitung

Stanley

Stanley FatMax FMC770 Bedienungsanleitung

auna

auna DAB-Radio 10026947 Bedienungsanleitung

SOUNDMASTER

SOUNDMASTER UR190 Bedienungsanleitung

HYT

HYT TC-320 Bedienungsanleitung

B-Tech

B-Tech GMRS-V2 Bedienungsanleitung

Weierwei

Weierwei VEV-V8 Bedienungsanleitung

SOUNDMASTER

SOUNDMASTER DAB750 Bedienungsanleitung

Telefunken

Telefunken TF-1505 Bedienungsanleitung

Makita

Makita LXRM03 Bedienungsanleitung

PRESIDENT

PRESIDENT TEDDY R. Bedienungsanleitung