Sanjet BP-106 Bedienungsanleitung
Editing you message on the Sanjet BP-106
1.The “Settings” tab.
A. “Systems Setting”
1.Language change to desired language and press OK
2. Adjust to day dates if needed.
3. Voltage: This is set at the factory, however if you plan to use white or
yellow ink you will need to change this value. The voltage
value is printed on the ink cartridge.
4. Pulse Width: This is set by the factory, however if you plan to use white
or yellow ink., you will need to change the pulse width.
pulse width is printed on the ink cartridge.
5. Brightness: Brightness of the screen
6. AutoSelected: will automatically set the voltage and pulse width of the
Ink cartridge installed.
7. Sound: will beep when prints.
8. Calibrate: for trouble shooting purpose.
2. Print Settings
1. Under “style”
1. Print Mode there are 4 settings. to use as a manual printer Key
Trigger should be highlighted. You can purchase a conversion kit stand
and convert this manual printer into an in-line automatic printer. You
would change the setting to External Sensor.
2. Speed This control the spacing between the letters. The lower the
number the faster the print (text squeezes in) The higher the
number the slower the print (the text spaces out further).
3. Interval Controls how long the printer waits once it gets a signal from
the sensor before it prints. The higher the number the longer
the printer waits to printer after a sensor trigger.
4. Directions determines which direction the printer prints. This will be
determined by direction of the conveyor.
5.Nozzle The ink cartridge has two line of nozzle but prints with 1 line at
a time. This feature is used for trouble shooting.
6. Sync Encoder if using BP-106 as a handheld printer this box should be
checked.
7. Print Width does basically the same function as speed when printer is
operating manually.
8. Gray this controls one of the darkness features of the text or barcode.
Factory default is 1 you should not go over 2 especially if printing
barcodes. For every digit you increase this value you double the
ink usage.
DPI Screen the BP-106 can print up to 300DPI. The higher the DPI the
Ink you use.
Remote Upgrade. When software is revised this it where you revise it.
About: information about printer, Serial number, software version, how
much ink is left in the cartridge, Ink I.D., ink type., remaining
count.
Inhaltsverzeichnis
Andere Sanjet Drucker Handbücher
