Sanyo VA-80BW Bedienungsanleitung

About this manual

This bracket is designed for ceiling mounting installation.

Before installing and using this unit, please read this manual carefully.

Be sure to keep it handy for later reference.

CAUTION:

Install this bracket securely according to this

installation manual. Be aware that allowing the

bracket to fall with the camera on it may cause

personal injury.

bSpecifications

Color: Beige

Material: Metal

Waterproof Standard: Conforming to IP66

Weight: Approx. 750 g (1.7 lb)

Allowable Load: Max. 20 kg (44.1 lb)

Dimensions:

Example of

indoor use

Example of

outdoor use

☞P1 ☞P2

Important

• Be careful when opening holes for installing the

unit. Work with the power and video cables pulled

out for easy installation.

• Make sure to properly perform waterproofing for the

wall where you are installing the unit.

• Make sure that the surface in the installation

location has no unevenness and is strong enough

to bear the total weight of the unit.

• Install this unit in an environment where the

temperature range stays between -30°C and +50°C

(-22°F and +122°F) (no condensation allowed).

Ǿ97 (3.8)

75 (3.0)

105 (4.1)

240 (9.4)

192 (7.6)

161 (6.3)

56 (2.2)

17(0.7)

191 (7.5)

4-Ǿ10.8 (0.4)

Unit: mm (inch)

INSTRUCTION MANUAL

Wall Mounting Bracket

VA-80BW

Features and specifications are subject to change without

prior notice or obligations.

English

日本語

Bolts, washers Rubber band

Accessories (For outdoor housing)

This installation should be made by a qualified service

person and should conform to all local codes.

L9BHM_WA(VA-80BW)(GB_JP).book 0 ページ２００６年１２月２７日　水曜日　午前１１時１９分

Indoor Type

Make sure to also consult the relevant instruction manuals.

1Mark the locations on the wall and drill the

holes for the cables and screws.

And pull out the cables from the wall hole and

pass them through the bracket as shown in

the figure.

2Fix the bracket to the wall using commercially

available screws (A) in 4 places.

3Mount the power board unit onto the

attachment.

(1)Pass the screws supplied with the

attachment through each of the power board

unit screw holes (B) and fasten them loosely

using washers (4 places).

(2) Align the blue sticker (C) on the attachment

and the arrow (C) of the same color on the

power board unit, and tighten firmly the

screws loosely fastened in the previous

step.

4With sticker (D) facing toward you, fix the

attachment onto the bracket using the 4 bolts

(E) supplied with the attachment.

• To fix the attachment, use the hexagonal

wrench supplied with the attachment.

• Make sure that the attachment is fixed, then

peel-off the sticker.

5Connect the cables to the power board unit

and mount the camera unit onto it.

☞For details, please refer to Installation Manual that

comes with the camera unit.

“Connections and Settings”

“Surface Mount”

• Be sure to fix the bracket securely using M8 (5/16”)

screws. Using other bolt sizes may cause the

bracket to fall together with the camera on it.

• Route the connected cables so that they do not

touch the power board unit and other parts.

Attachment accessories

Screws, washers

(for power borad

unit)

Hexagonal

wrench

Bolts (10 mm/0.4”)

M8 (5/16”): 40 mm (1.6”) or more

Video cable

Connection cables

Power Board Unit:

VA-84S/80S

Attachment: VA-80A

C; Blue

L9BHM_WA(VA-80BW)(GB_JP).book 1 ページ２００６年１２月２７日　水曜日　午前１１時１９分

Make sure to also consult the relevant instruction manuals.

1Mark the locations on the wall and drill the

holes for the cables and screws.

And pull out the cables from the wall hole and

pass them through the bracket as shown in

the figure.

2Fix the bracket to the wall using commercially

available screws (A) in 4 places.

3Mount the dome cover and the power board

unit onto the housing.

☞For details, please refer to the Outdoor Housing

Instruction Manual.

“1. Attaching the dome cover”

“2. Mounting the power board unit”

4Attach the supplied rubber bands (B) to the

housing as shown in the figure.

5With sticker (C) facing toward you,

temporarily mount the housing on the

bracket.

6Fix the housing onto the bracket using 4 sets

of supplied bolts and bolt washers (D).

• To fix the housing, use the hexagonal wrench

supplied with the housing.

• Make sure that the housing is fixed, peel off the

sticker, then remove the rubber band.

7Connect the cables to the power board unit

and mount the camera unit onto it.

☞For details, please refer to the Outdoor Housing

Instruction Manual.

“3. Connecting cables”

“4. Mounting the camera unit”

• Be sure to fix the bracket securely using M8 (5/16”)

screws. Using other bolt sizes may cause the

bracket to fall together with the camera on it.

• Route the connected cables so that they do not

touch the power board unit and other parts.

Outdoor Type

This mounting bracket can be installed on a pole or a wall

corner by using the appropriate mounting adaptor. For

installation details, refer to the instruction manual for the pole

mounting adaptor (VA-80AP) or the corner mounting adaptor

(VA-80AC).

M8 (5/16”): 40 mm (1.6”) or more

Video cable

Connection cables

Outdoor Housing: VA-80EX

Dome Cover:

• VA-CM8C (Clear)

• VA-CM8S (Smoked)

Video cable

Power Board Unit:

VA-84S/80S

1. Attaching the dome cover

2. Mounting the power board unit

L9BHM_WA(VA-80BW)(GB_JP).book 2 ページ２００６年１２月２７日　水曜日　午前１１時１９分

Andere Sanyo Kamerazubehör Handbücher

Sanyo

Sanyo ML621 Lithium Bedienungsanleitung

Sanyo

Sanyo VA-80LAN Bedienungsanleitung

Sanyo

Sanyo Cadnica N-3000CR Bedienungsanleitung

Sanyo

Sanyo Cadnica N-600AAC Bedienungsanleitung

Sanyo

Sanyo VA-LANC100 Bedienungsanleitung

Sanyo

Sanyo UR18650V Bedienungsanleitung

Sanyo

Sanyo CR15270 Bedienungsanleitung

Sanyo

Sanyo Twicell HR-4U Bedienungsanleitung

Sanyo

Sanyo KR-CH(2.5) Cadnica Bedienungsanleitung

Sanyo

Sanyo VA-60H Bedienungsanleitung

Sanyo

Sanyo Cadnica KR-2000C Bedienungsanleitung

Sanyo

Sanyo Cadnica N-270AAK Bedienungsanleitung

Sanyo

Sanyo Lithium ion Bedienungsanleitung

Sanyo

Sanyo Twicell HR-4/5FAUP Bedienungsanleitung

Sanyo

Sanyo UF612248P Bedienungsanleitung

Sanyo

Sanyo Twicell HR-4/5AAUC Bedienungsanleitung

Sanyo

Sanyo VA-80BP Bedienungsanleitung

Sanyo

Sanyo Cadnica N-600AAK Bedienungsanleitung

Sanyo

Sanyo VPC-TH1BL Bedienungsanleitung

Sanyo

Sanyo UR-611 Bedienungsanleitung

Sanyo

Sanyo UR14650P Bedienungsanleitung

Sanyo

Sanyo N-270AA Cadnica Bedienungsanleitung

Sanyo

Sanyo Cadnica KR-1200SCL Bedienungsanleitung

Sanyo

Sanyo KR-7000F Cadnica Bedienungsanleitung

Beliebte Kamerazubehör Handbücher anderer Marken

Viltrox

Viltrox EF-NEX Montageanleitung

Calumet

Calumet 7100 Series CK7114 Bedienungsanleitung

Ropox

Ropox 4Single Series Bedienungsanleitung

Cambo

Cambo Wide DS Digital Series Betriebsanleitung

Samsung

Samsung SHG-120 Bedienungsanleitung

Ryobi

Ryobi BPL-1820 Bedienungsanleitung

Aegis

Aegis ABL-36020P Bedienungsanleitung

Pentax

Pentax Data Back Fc Bedienungsanleitung

Fantasea

Fantasea EyeGrabber F Series Bedienungsanleitung

Honeywell

Honeywell HDZ20HD Bedienungsanleitung

EGO

EGO BA1400T Bedienungsanleitung

Sima

Sima SRW-62 Bedienungsanleitung

Shape

Shape A7SSMKIT Bedienungsanleitung

Slide Kamera

Slide Kamera HST-2 Bedienungsanleitung

Power works

Power works 2902613 Bedienungsanleitung

SES

SES SE-2047-2 Bedienungsanleitung

Olympus

Olympus PT-EP05L Bedienungsanleitung

Starlite

Starlite OctoDome nxt Bedienungsanleitung