Sanyo ECD-T1137S Bedienungsanleitung

PLL Synthesized Stereo Radio with

Digital Compact Disc Player

1pair of RCA output

CD-R/CD-R W Compatibility

4 preset Equalization

Auxiliary Input

OWNER'S

MANUAL

ECD-T1137S

INSTALLATION

Notes:

•Choose the mounting location where the unit will not interfere with the normal

driving function of the driver .

• Before finally installing the unit, connect the wiring temporarily and make sur e it is

all connected up properly and the unit and the system works properly.

• Use only the parts included with the unit to ensure proper installation. The use of

unauthorized parts can cause malfunctions.

• Consult with your nearest dealer if installation requires the drilling of holes or other

modifications of the vehicle.

• Install the unit where it does not get in the driver's way and cannot injure the

passenger if there is a sudden stop, like an emergency stop.

•If installation angle exceeds 30 from horizontal, the unit might not give its optimum

performance.

Avoid installing the unit where it would be subject to high temperature, such as from

direct sunlight, or from hot air, from the heater,or where it would be subject to dust,

dirt or excessive vibration.

DIN FRONT/REAR-MOUNT

This unit can be properly installed either from "Front" (conventional DIN Front-mount)

or "Rear"(DIN Rear -mount installation, utilizing threaded screw holes at the sides of

the unit chassis). For details, refer to the following illustrated installation methods.

DIN FRONT-MOUNT (Method A)

Installation of the unit

1. Dashboard

2. Holder

After inserting the holder into the

dashboard, select the appropriate tab

according to the thickness of the

dashboard material and bend them

inwards to secure the holder in place.

3. Screw

182

(Fig. 1)

•

1. Dashboard

2. Nut (5mm)

3. Spring washer

4. Screw (5 x 14mm)

5. Screw

6. Strap

Be sure to use the strap to secure the

back of the unit in place. The strap can

be bent by hand to the desired angle.

Removing the unit

1. Frame

2. Insert fingers into the groove in the front

of frame and pull out to remove the

frame. (When reattaching the frame,

point the side with a groove downwards

and attach it.)

3. Lever

Insert the levers supplied with the unit

into the grooves at both sides of the unit

as shown in figure until they click.

Pulling the levers makes it possible to

remove the unit from the dashboard.

DIN REAR-MOUNT (Method B)

Installation using the screw holes on the sides of the unit.

Fastening the unit to the factory radio

mounting bracket.

1. Select a position where the screw holes

of the bracket and the screw holes of

the main unit become aligned (are fitted),

and tighten the screws at 2 places on

each side.

Use either truss screws (5 x 5mm) or

flush surface screws (4 x 5mm),

depending on the shape of the screw

holes in the bracket.

2. Screw

3. Factory radio mounting bracket

4. Dashboard or Console

5. Hook (Remove this part)

Note: The mounting box, outer trim ring,

and half-sleeve are not used for method B

installation.

(Fig. 2)

HOW TO REMOVE AND INSTALL THE FRONT PANEL

(OPTIONAL)

1. Press the release button and pull-of f the front panel.

Store front panel in the case.

2. Toinstall the front panel, insert the panel into the housing and make sure the panel

is properly installed, otherwise, abnormalities may occur on the display or some

keys may not function properly.

REMOVING THE FRONT PANEL

INSTALLING THE FRONT PANEL

Front Panel

Release Button

WIRING CONNECTION

GREEN

GREEN/BLACK

GREY

GREY/BLACK

VIOLET

VIOLET/BLACK

MAIN UNIT

WHITE

WHITE/BLACK

FRONT Lch

SPEAKER

REAR Lch

SPEAKER

FRONT Rch

SPEAKER

REAR Rch

SPEAKER

Rch RED

Lch WHITE

(GREY)

RCA CABLE

ANTENNACONNECTOR

RED

YELLOW

BLACK

BLUE

POWER

ANTENNA

GROUND (B-)

MEMORY

BACK-UP

IGNITION

SWITCH (B+)

2526

7 31 4

1420

11 9198

15241012

2 5 18 13

21 22 23 6 16 17

OPERATION

GENERAL OPERATION

ON/OFF

Switch on the unit by pressing any button [except button (7) and eject button

(4)]. When system is on, press PWR button (9) to turn off the unit.

FACEPLATE RELEASE

Press button (7) to detach the removable faceplate.

The adjustment mode will change in the following order:

By pressing VOL button + (11) or VOL button - (12), it is possible to adjust the

desired sound level.

LOUDNESS

Press BND/LOU button (13) for several seconds to reinforce the bass output and

display will show "LOUD". Press it for several seconds again to release this function.

SET THE CLOCK

Press the DSP button (15), the clock is shown on the LCD display. Then hold down

the button until the clock flashes. Then press the MANU/SKIP button (17) to

change hours or MANU/SKIP button (16) to change minutes.

SELECT MODE

Press MOD button (6) shortly to choose desired listening mode.

[e.g. radio mode to CD mode to AUX mode]

MUTE

Press MUT button (3) to mute the sound instantly . If any button is pr essed in the

mute state, the mute mode is released.

LIQUID CRYSTAL DISPLAY

Exhibit current frequency and activated functions on the display (8).

EQUALIZATION

Press EQ button (19) to turn on equalization function and to select desired audio

mode. There are five kinds of mode as below:

AUXILIARY INPUT

The unit can be connected to a portable audio player through the AUX IN jack (24).

To hear the i nput signal, press MOD (6) button several times until the display shows

“AUX”.

FLASHING LED

If the front panel is not installed in the main unit, the LED (25) will be flashing.

RESET

RESET button (26) can be activated with either a ball point pen or thin metal

object. RESET button (26) is to be activated for the following reasons:

- Initial installation of the unit when all wiring is completed.

- All the function buttons do not operate.

- Error symbol on the display.

FLAT CLASSICS POP M ROCK M DSP OFF

Volume Bass Treble Balance Fader

RADIO OPERATION

BAND SELECTION

At tuner mode, press BND/LOU button (13) to select the desired band.

The reception band will change in the following order:

STATION SELECTION

Press MANU/SKIP button (16) or MANU/SKIP button (17) to activate

automatic seek function. To select manual tuning mode, press for several seconds

until "MANUAL" appears on the display. If both buttons are not pressed for several

seconds, the tuner will return to seek tuning mode and "AUTO" will appear on the

display.

LOCAL/DISTANCE

Press LOC button (2) to select between local and distant stations.

Local setting for reception of strong station, and a distant setting for reception of

weaker stations. This function is in effect during AUTO SEEK operation.

AUTOMATIC MEMORY STORING & PROGRAM SCANNING

- Automatic Memory Storing

Press ATP button (18) for several seconds, the radio will search from the current

station and check the signal strength until one cycle search is finished. The 6

strongest stations detected will be stored into the corresponding preset button.

- Program Scanning

Press ATP button (18) shortly to scan preset station.

STATION STORING

Press any one of the preset buttons (14) (M1 to M6) to select a station which had

been stored in the memory. Press this button for several seconds to store the

current station into that preset button.

SEEK FUNCTION

Press SEEK button (1) to scan and hear all tunable stations for a few seconds.

Press SEEK again to stop at current station.

FM1 FM2 FM3 AM

CD OPERATION

SELECT TRACKS

Press MANU/SKIP button (16) or MANU/SKIP button (17) to move to the

previous track or the following track. Track number shows on display.

Hold MANU/SKIP button (16) or MANU/SKIP button (17) to fast reverse or

fast forward. CD play starts from when you release the button.

PAUSE PLAYING

Press PAUbutton (20) to pause CD player. Press it again to resume play.

REPEAT THE SAME TRACK

Press RPT button (22) to continuously repeat the same track. Press again to stop

repeat.

PREVIEW ALL TRACKS

Press SCN button (21) to play first several seconds of each track on the current

disc. Press again to stop intr o and listen to track.

PLAY ALL TRACKS IN RANDOM

Press SHF button (23) to play all tracks on CD in random or der. Press again to

cancel the function.

EJECT

Press (eject) button (4) to stop CD playing and eject the disc from the disc slot (5).

Note:

A. Notes on discs:

1. Attempting to use non-standar d shape discs (e.g. square, start, heart) may

damage the unit. Be sure to use round shape CD discs only for this unit.

2. Do not stick paper or tape etc., onto the label side or the recording side of

any discs, as it may cause a malfunction.

3. Dirt, dust, scratches and warping discs will cause misoperation.

B. Notes on CD-Rs (recordable CDs)/ CD-RWs (rewritable CDs):

1. Be sure to use discs with following marks only for the unit to play:

2. The unit can only play a CD-R and CD-RW that is finalized. (Please refer to the

manual of your CD-R/CD-RW recorder or CD-R/CD-RW software for more

information on finalization process).

3. Depending on the recording status, conditions of the disc and the equipment

used for the recording, some CD-Rs/CD-RWs may not play on this unit. (See *1)

*1: To have more reliable play back, please see following recommendations:

- Use CD-RWs with speed 1x to 4x and write with speed 1x to 2x.

- Use CD-Rs with speed 1x to 8x and write with speed 1x to 2x.

- Do not play a CD-RW which has been written for mor e than 5 times.

Recordable Rewritable

Inhaltsverzeichnis

Andere Sanyo Autoempfänger Handbücher

Sanyo

Sanyo FXD-680GD Bedienungsanleitung

Sanyo

Sanyo FX-02 Bedienungsanleitung

Sanyo

Sanyo FXR-100LD Bedienungsanleitung

Sanyo

Sanyo FXD-803LDS Bedienungsanleitung

Sanyo

Sanyo FXCD-1350 - Radio / CD Bedienungsanleitung

Sanyo

Sanyo FXR-61GB Bedienungsanleitung

Sanyo

Sanyo FXCD-500 Bedienungsanleitung

Sanyo

Sanyo CDF-M200 Bedienungsanleitung

Sanyo

Sanyo CDF-201G Bedienungsanleitung

Sanyo

Sanyo ECD-T1780DV Bedienungsanleitung

Sanyo

Sanyo CDF-R800 Bedienungsanleitung

Sanyo

Sanyo F-8501 Bedienungsanleitung

Sanyo

Sanyo FXD-780GDSS Bedienungsanleitung

Sanyo

Sanyo EX-W22 Bedienungsanleitung

Sanyo

Sanyo CDF-R800 Bedienungsanleitung

Sanyo

Sanyo FXCD-1100 - Radio / CD Bedienungsanleitung

Sanyo

Sanyo ECD-T1540 Stücklistenhandbuch

Sanyo

Sanyo ECD-T1560 Gebrauchsanweisung

Sanyo

Sanyo FXC-503LD Bedienungsanleitung

Sanyo

Sanyo FXD-770GD Bedienungsanleitung

Sanyo

Sanyo FXR-100LD Bedienungsanleitung

Sanyo

Sanyo ECD-T1820 Bedienungsanleitung

Sanyo

Sanyo FXCD-1100 - Radio / CD Bedienungsanleitung

Sanyo

Sanyo FXD-780GD Bedienungsanleitung

Beliebte Autoempfänger Handbücher anderer Marken

Motorola

Motorola VWA63 Bedienungsanleitung

Nextar

Nextar D3201 Bedienungsanleitung

Alpine

Alpine CDE-163BT Bedienungsanleitung

Pioneer

Pioneer DEH-P645R Bedienungsanleitung

Axxera

Axxera XDMA7600 Betriebsanleitung

XM OnyX Bedienungsanleitung

Sound Storm

Sound Storm STM93R Bedienungsanleitung

Soundstream

Soundstream VIR-5000 Bedienungsanleitung

Avson

Avson MKT Platform Bedienungsanleitung

Sony

Sony MEX-1HD - Audio Library System Bedienungsanleitung

Pioneer

Pioneer DVH-P500UB Bedienungsanleitung

JVC

JVC KD-AHD69 Bedienungsanleitung

Blaupunkt

Blaupunkt SANTIAGO CR 87 Bedienungsanleitung

Sony

Sony CDX-4160 - Cd Receiver Bedienungsanleitung

XFIRE AUDIO

XFIRE AUDIO BMW42S Bedienungsanleitung

VDO

VDO CD 2253 Bedienungsanleitung

Volvo

Volvo 13 84 580 Bedienungsanleitung

ZENEC

ZENEC ZE-160DVD Bedienungsanleitung