Sapphire Audio BP-FP6 Bedienungsanleitung

User’s Manual
AMD V2000 4x4 Board
BP-FP6
TRADEMARK
All products and company names are trademarks or registered
trademarks of their respective holders.
These specifications are subject to change without notice.
Manual Revision 1.0
ovember 17, 2021

~ ii ~
Federal Communications Commission (FCC) Statement
This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of FCC Rules These limits are designed to
provide reasonable protection against harmful interference in a residential
installation This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with instructions contained
in this manual, may cause harmful interference to radio and television
communications However, there is no guarantee that interference will not occur
in a particular installation
If this product does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the product into an outlet on a circuit different from that to which
the receiver is connected
Consult the dealer or an experienced radio/TV technician for help
Note1: Connecting this device to peripheral devices that do not comply
with Class B requirements, or using an unshielded peripheral data
cable, could also result in harmful interference to radio or television
reception
Note2: The user is cautioned that any changes or modifications not
expressly approved by the party responsible for compliance could
void the user’s authority to operate this product
Note3: To ensure that the use of this product does not contribute to
interference, it is necessary to use shielded I/O cables
CE: Radiation of EN 55022 & Immunity of EN 55024

~ iii ~
aste Electrical and Electronic Equipment ( EEE) Statement
To protect the global environment, this product must be sent to separate collection
facilities for recovery and recycling.
DISPOSAL
Do not dispose of this product as unsorted municipal waste. Collect such
waste separately for special treatment.
Manufacturer
Sapphire Technology Limited
Unit 909- 9 9, 9/F., Tower 2 Grand Central Plaza
38 Shatin Rural Committee Road
Shatin, Hong Kong

~ iv ~
Table of Contents
Chapter 1 Introduction .............................................................................1
1-1 Mainboard Specifications ................................................................1
1-2 Mainboard Layout ...........................................................................4
1-3 Mainboard Dimension .....................................................................8
Chapter 2 Installation .............................................................................10
2-1 Installing System Memory .............................................................10
Memory Configuration ...................................................................10
Memory Installation .......................................................................10
2-2 Installing Expansion Cards ........................................................... 11
M.2 E-Key Slot ..............................................................................11
M.2 M-Key Slot ..............................................................................12
2-3 Connecting Cables and Jumper Settings ......................................15
Front Panel Header .......................................................................15
4-pin 12V ATX Power Connector ...................................................16
SATA3 Connector ..........................................................................16
SATA Power Header ......................................................................16
Case Open Header .......................................................................17
GPIO Header ................................................................................17
USB2.0 Header (10-pin) ................................................................17
USB2.0 Header (4-pin) ..................................................................17
COM Header .................................................................................18
SPI Header ....................................................................................18
Fan Header ...................................................................................18
Auto Power ON Jumper ................................................................19
Clear CMOS Jumper .....................................................................19
Chapter 3 Configuring the BIOS ............................................................21
3-1 Select Boot Device .......................................................................21
3-2 Enter BIOS Setup .........................................................................21
3-3 Main Menu ....................................................................................23
3-4 Advanced Menu ............................................................................24
Trusted Computing ........................................................................24
ACPI Settings ................................................................................26

~ v ~
F81803 Super IO Configuration ....................................................27
Hardware Monitor ..........................................................................28
RTC Wake Settings .......................................................................30
CPU Configuration ........................................................................31
SATA Configuration .......................................................................32
PCI Subsystem Settings ................................................................33
USB Configuration ........................................................................34
Network Stack Configuration .........................................................35
CSM Configuration ........................................................................36
NVMe Configuration ......................................................................38
Onboard Devices ..........................................................................38
AMD CBS ......................................................................................40
AMD PBS ......................................................................................44
3-5 Chipset Menu ................................................................................45
South Bridge .................................................................................45
North Bridge ..................................................................................46
3-6 Security Menu ...............................................................................47
3-7 Boot Menu ....................................................................................49
3-8 Save & Exit Menu .........................................................................50
Chapter 4 Driver Installation ...............................................................51
4-1 Driver Install ..................................................................................51

~ ~
Chapter 1 Introduction
1-1 Mainboard Specifications
APU
AMD
®
V2000 series APU for FP6 package with Zen 2 core
Graphics
AMD
®
Radeon Vega graphics series
Supports two independent displays with HDMI ports
Port
Supported
resolution
HDMI 2.
1
4096
x
2160
@
6
0Hz
System Memory
Two 260-pin DDR4 SDRAM SO-DIMM (ECC/Non ECC) sockets
Supports 1 2V DDR4-2133/2400/2666/2933/3200 DIMMs with dual channel
architecture
* The memory speed will be depend on CPU specification
Supports 4GB, 8GB, 16GB and 32GB DDR4 SO-DIMMs up to maximum 64GB
Expansion Slots
One M 2 Slot E-key with 2230 type with PCIe x1 and USB2 0 for Wifi/BT
One M 2 Slot M-key with 2242/2280 storage type with PCIe x4 for SSD
USB Ports
Two USB 2 0 ports supported with a 10 pin header and one USB 2 0 supported
with a 4 pin header, supporting transfer speed up to 480Mbps
Two USB3 1 ports at rear panel and two USB3 1 ports at front panel,
supporting transfer speed up to 10Gbps
Supports wake-up from S3 and S4 modes
SATA Port
One SATA3 port with 6Gb/s data transfer rate

~ 2 ~
Supports AHCI (Advanced Host Controller Interface)
Onboard LAN
One Gigabit Ethernet from Realtek
®
RTL8111H Gigabit controller
Onboard TPM
Supports TPM2 0 from Infineon SLB9670
Onboard Audio
Supports 2-channel High-Definition audio from Realtek ALC256 codec
/O
Onboard Fintek F81803U LPC bus I/O controller
Supports Hardware Monitor for fan speed monitoring, CPU and system
temperature
Back Panel /O Ports
1 x RJ45 LAN port
2 x HDMI ports
2 x USB3 1 ports
1 x DC-in 12V~19V Jack, dimension: 5 5x2 5mm
Front Panel /O Ports
2 x USB3 1 ports
1 x 4-conductor 3 5mm Audio jack with Left/Right Audio out and MIC in
nternal /O Connectors
1 x 4-pin 12V ATX Power connector
1 x SATA3 connector
1 x SATA power header, 1 25mm pitch
1 x Front Panel header, 2 00mm pitch
1 x COM header, 2 00mm pitch
1 x USB2 0 10-pin header, 2 54mm pitch
(It can be used to connect to 2 USB 2.0 devices)
1 x USB2 0 4-pin header, 2 54mm pitch

~ 3 ~
1 x Case Open header, 2 54mm pitch
1 x GPIO header, 2 54mm pitch
1 x SPI header, 1 27mm pitch
1 x 4-pin APU Fan header, 1 25mm pitch
Battery header, 1 25mm pitch
Onboard Jumper
Auto Power ON selection jumper, 2 54mm pitch
Clear CMOS jumper, 2 54mm pitch
B OS
128Mb SPI Flash with AMI based BIOS
Supports ACPI (Advanced Configuration and Power Interface)
Onboard jumper to clear the CMOS data
Dimensions
Size: 104 89mm × 109 6mm
Operating systems
Supports Windows 10 (64bit), Ubuntu 20 04 1 (64-bit)
Environmental
Power Requirement: Power adapter of 12V~19V DC OUT, >65W, 5 5/2 5mm
power jack, input voltage tolerance +/- 10%
Operating Temperature: 0°C~50°C (32°F~122°F)
Storage Temperature: -20°C~80°C (-4°F~176°F)
Relative Humidity: 10%~90%

~ 4 ~
1-2 Mainboard Layout
The following figure shows the location of components on the mainboard
See page 5 for component description
Front view of mainboard:
7
8
9
5
1
1
0
3
2
1
1
6
4
1
2
1
3
1
4
1
6
1
8
1
7
22
1
5
1
9
1
9
2
0
2
1

~ 5 ~
Back view of mainboard:
Note:
Picture is for reference only, actual board may be slightly different.
2
4
2
5
2
3
Inhaltsverzeichnis
Andere Sapphire Audio Computerhardware Handbücher
Beliebte Computerhardware Handbücher anderer Marken

EMC2
EMC2 VNX Series Betriebsanleitung

Panasonic
Panasonic DV0PM20105 Bedienungsanleitung

Mitsubishi Electric
Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung

Gigabyte
Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung

Raidon
Raidon iT2300 Bedienungsanleitung

National Instruments
National Instruments PXI-8186 Bedienungsanleitung












