®
CABLE SET FOR PROGRAMMING
DEVICES WITH RS-232 TTL PORT
DB9FC/RJ-KPL
db9fcrj_en 08/08
The DB9FC/RJ-KPL cable set includes the DB9FC/RJ main cable, RJ/PIN3 adapter,
PIN3/RX adapter and connector with two RJ (6-pin) sockets. The first two cables are marked
by yellow cable flag labels with suitable symbol printed on them.
This set replaces the two cables manufactured earlier under the name of DB9FC/PIN3 (or
RS-CA5/6/R-2/4) and DB9FC/RJ. It enables computer to be connected to devices with
RS-232 TTL port, irrespective of what type of socket is used in them (PIN3 or RJ).
The DB9FC/RJ cable has a built-in data converter from RS-232 (-12V, +12V) into RS-232
TTL (0V, +5V) standard.
The set is designed for use with the following devices:
−CA-6, CA-5 alarm control panels (all electronics board versions);
−RX-2K, RX-4K, RE-4K radio controllers;
−INT-RX 433MHz keyfobs receiver expansion module
−ACCO-KP, ACCO-KP-PS access control modules.
Note: The cables designated DB9FC/RJ, manufactured up to 2007 (including 2007) and sold
individually (without adapters), do not allow programming the CA-5, CA-6 control
panels with PIN3 socket, as well as the radio controllers (even when using the
adapters described herein).
The figures below show connection diagrams.
Figure 1. Connection diagram – DB9FC/RJ cable
1
2
3
4
5
to control panel
(view of RJ plug )
DB9F
to computer
(view of converter board located in
DB9F female connector)
654321
