10
HEATING
THE SAUNA ROOM
Before using the Saunum Air for the rst
time, make sure that:
• the electrical connections meet the
requirements
• the supply voltage corresponds to
the nominal ratings allowed for the
Saunum Air
• the grounding (GND) is in working
order
• the attachments of the sauna cli-
mate device housing are in order
• the Saunum Air is properly attached
to the wall
• the over-current fuses are in working
order the fan rotor rotates smoothly
• there are no tools or materials left
after mounting the device in the
housing.
When switching the Saunum Air on, check:
• the direction of the air ow – the air
intake from the upper and the out-
put from the lower opening
• that there is no vibration or excessive
noise when the fan is running.
When the Saunum Air is switched on for
the rst time, the heating elements and the
stones will emit an odor. The sauna room
must be properly ventilated to remove the
anticipated initial smell.
Presuming proper insulation of the room
and that the power of the heater is suitable
for the sauna size, it takes 45–90 minutes to
reach the desired temperature.
The stones are usually heated to proper
temperature for water usage at the same
time as the sauna room. Turn the Saunum
Air fan on just before entering the sau-
na room; this will help prevent the sauna
bench from overheating and using exces-
sive energy.
Saunum’s recommended temperature
for sauna operation is 149°F to 176 °F.
USING THE SAUNA
CLIMATE DEVICE
Before switching the Saunum Air
on, always make sure that nothing
is above or near it.
The operating time of the sauna climate de-
vice model Sauna Air may be adjusted by a
separate control device.
• Do not connect the device directly to
the utilities and/or power!
• The Saunum Air must not be used if
the components of its housing have
been removed and/or the wiring dia-
gram has been changed.
• Children should not be allowed to
access or play with the Saunum Air.
DIRECTION FOR USE
