Occupancy Sensor 24V Contact QRG | 009-1919-02 45 Perseverance Way, Hyannis, MA 02601
Copyright 2021 Savant Systems, Inc | 210312 2 of 4 Savant.com | 508.683.2500
Occupancy Sensor Adjustment
Remove the control cover to adjust occupancy sensor settings. Refer to the diagram and table below for details:
Timer Adjustment 30 Seconds 5 minutes 10 minutes 20 Minutes 30 Minutes
Ambient Light
Sensitivity 20 Lux 40 Lux 80 Lux 160 Lux 320 Lux
Ultrasound Range
O Low Medium High Maximum
Infrared Range
Sensor Modes
The Occupancy / Motion Sensor can be configured to meet the requirements of the deployment. To do this, remove the sensor cover and
configure the DIP Switch banks as described below.
Switch O On
A
ON OFF ON OFF
12 3 4
ON DIP
B
12 3 4
ON DIP
A1 Multi-Tech Mode Single Tech Mode
A2 PIR Mode Ultrasonic Mode
A3 Auto-Adapting Enabled Auto-Adapting Disabled
A4 Walk-Through Enabled Walk-Through Disabled
B1 Light Mode Enabled Light Mode Disabled
B2 LEDs Enabled LEDs Disabled
B3 OFF > ON > OFF: Enter/Exit Test Mode
B4 N/A
Multi-Tech Mode 1: (A1 OFF, A2 ON) If motion is detected in PIR or Ultrasonic, the relay is closed.
Multi-Tech Mode 2: (A1 OFF, A2 OFF) If motion is detected by the PIR, both PIR and Ultrasonic sensors will be activated. If motion is detected
by either in this state, the relay is closed.
Single-PIR Mode: (A1 ON, A2 OFF) If motion is detected by PIR Sensor, the relay is closed.
Single-Ultrasonic Mode: (A1 ON, A2 ON) If motion is detected by Ultrasonic sensor, the relay is closed.
Auto-Adapting Mode: When room lights are turned on, sensor enters the Walk-Through mode. If occupancy is detected for longer than 2.5
minutes, the occupancy sensor will exit Walk-Through mode and treat the room as occupied. The length of time.
Walk-Through Mode: Lights will be turned o shortly after no occupancy is detected.
Light Mode: Ambient Light sensing is enabled.
Timer Mode: The output signal to attached relays will last 2.5 minutes when this mode is enabled. If occupancy is sensed during this time, the
relay will be closed.
Test Mode: Sets the Delayed-O Time Adjustment to 5 seconds. This mode will persist for 15 minutes or until the OFF-ON-OFF command
sequence is entered again.
