Scinomix Sci-Print VX2 Bedienungsanleitung
TS-1021
8/25/2015 Scinomix, Inc.
How to Adjust Air Pressure
Purpose
This guide will show how to adjust air pressure for the Sci-Print VX2/VXL. It is intended
for an end user. It is important to make sure you have the correct air pressure- if too high
it may crush or break the tube, and if set too low it will not grip the tube tight enough.
There are 3 different types of air pressure that will be explained below- gripper air
pressure, roller close pressure, and peel blow pressure.
For the correct air pressure setting for your tube, please contact Scinomix Service at 314-
298-9800 ext. 208.
Who Should Use This Troubleshooting Guide?
End user
Instructions
Gripper Air Pressure- this air pressure controls the strength of the gripper and can be
controlled by the tiny knob inside of the VX2/VXL located on the underside of the upper
gantry.
1. The air pressure gauge is located on the underside of the upper gantry
2. Tighten this knob by turning it to the right to increase the air pressure for the
grippers so that the grip becomes tighter
TS-1021
8/25/2015 Scinomix, Inc.
3. Loosen the knob by turning it to the left to decrease the air pressure for the
grippers so that the grip becomes looser
Roller Close Pressure- this air pressure controls how tight the rollers clamp together to
label the tube. This air pressure should be adjusted fairly often depending on the size of
tube you are working with. It is located just behind the roller block assembly on the left
side of the VX2 (see image below)
Left view of VX2
1. To increase air pressure, tighten the knob by turning it to the right
2. To decrease air pressure, loosen the knob by turning it to the left
Peel Blow Pressure- the peel blow pressure is also located behind the roller block
assembly and is right next to the roller close pressure. This air pressure does not need to
be adjusted as frequently as the other two. The peel blow pressure should only be
adjusted if you change the label.
1. To increase air pressure, tighten the knob, by turning it to the right
2. To decrease air pressure, loosen the knob by turning it to the left
TS-1021
8/25/2015 Scinomix, Inc.
Version Number
Change
Date Effective
Approved by:
A
New
8/2015
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Scinomix Etikettendrucker Handbücher
