Sealey LED100WS Bedienungsanleitung

20W COB LED R/CHARGE WIRELESS

SPEAKER WORK LIGHT+POWER BANK

MODEL NO: LED100WS

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these

instructions, and properly maintained, give you years of trouble free performance.

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE

THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR

PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

1. SAFETY

9Inspect the cable and connector for wear and damage to ensure items are safe before connecting to the power supply. If worn or

damaged DO NOT use.

9Ensure the lamp is fully charged before initial use.

8DO NOT charge in damp conditions.

8DO NOT turn the lamp on when it is being charged.

8DO NOT shine directly into your, another person’s or an animal’s eyes.

8DO NOT allow children to use the lamp.

8DO NOT handle or move the lamp whilst it is being charged.

8DO NOT use the lamp if you suspect that the battery or the lamp casing is damaged.

8DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently

recharge the battery at least once every six months of non-use.

8DO NOT attempt to open, disassemble, modify or service the battery pack.

8DO NOT crush, puncture, short external contacts or dispose of in re or water.

8DO NOT expose to temperatures above 60°C (140°).

9Replace only with the battery pack designated for this product.

9Recycle or dispose of used battery as stipulated by local regulation.

9If the electrolyte in the cells gets on your skin or eyes, rinse thoroughly with water.

8DO NOT connect your small devices to charge while the power bank is in the process of charging.

8DO NOT immerse in water.

8DO NOT place near a re or any other source of intense heat – battery could explode if heated.

9Battery must be recycled or disposed of according to local regulations.

2. INTRODUCTION

3-in-1 Function work light made of a strong nylon plastic with thermoplastic rubber edges for durability. Features an ultra bright 20W COB LED

light producing up to 1100 lumens with three light settings: High 1100lm, Mid 580lm, Low 350lm (working time: 3, 5 and 15 hours respectively).

Work light also includes two good quality wireless speakers which can be easily linked to your tablet or smartphone. Fixed to the rear is a

sturdy 180° adjustable stand which can also be used as a carry handle. Has four strong magnets on the back for easy mounting to metal

applications such as a tool chest. Built-in power bank with a USB output and LED charge indicator. Micro USB charging lead included.

3. SPECIFICATION

Model No: ............................................................LED100WS

Battery: ........................................................3.7V 8Ah Li-poly

Charging Time:.............................................................8-10hr

LED Qty: ........................................................ 20W COB LED

Lumen Output: ............................................................1100lm

Nett Weight: ................................................................... 790g

Running Time:..............................................................3-15hr

Speaker Output:............................................................. 85db

USB Output:............................................................... 5V / 1A

SpeakerLight

g.1

LED100WS Issue 1 20/02/19

Original Language Version

Refer to

instructions

4. OPERATION

NOTE: Charge before rst use, see section 4.5.

4.1. TO TURN ON THE LIGHT: (FIG.2)

4.1.1. Short press the main power button

to turn the light On/O󰀨.

4.1.2. There are 3 lighting modes: high, mid

and low. Keep pressing the

button until you reach the desired

setting.

4.2. TO CONNECT A WIRELESS

ENABLED DEVICE (FIG.2)

4.2.1. Press and hold the wireless activation

button for a couple of seconds until

wireless-on tone is heard.

4.2.2. You can connect and play music

from your mobile phone, tablet or other portable audio device. Keep the button pressed to turn o󰀨.

4.3. TO ADJUST VOLUME: (FIG.2)

4.3.1. Press and hold plus (+) button to increase volume. Press and hold minus (-) button to reduce volume.

4.4. TO MOVE FORWARD OR BACKWARD IN YOUR PLAYLIST: (FIG.2)

4.4.1. Short press plus (+) button to move to the next song. Short press minus (-) button to go to the previous song.

4.5. TO CHARGE THE LIGHT: (FIG.3)

4.5.1. Open the transparent cover on the back of the

device. Plug a micro USB cable into the ‘5V’ input

and connect it to a power adaptor, home

computer, laptop, etc. The indicator light will

be on to show the power capacity. 3 blue LEDs are

on when it is fully charged.

4.6. TO CHARGE YOUR SMALL DEVICES: (FIG.3)

4.6.1. Plug a USB cable into the ‘5V’ Output at the base

of the light and connect it to your mobile phone,

camera, etc.

WARNING! DO NOT connect your small devices to charge while the power bank is being charged.

Light On/Off

Wireless Activation

(Hold)Volume up

(Press) Forward Skip (+)

(Press) Backwards Skip (-)

(Hold) Volume Down

g.2

5V Charger Input

Indicator lights

USB Output Socket

g.3

Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR

01284 757500 01284 703534 sales@sealey.co.uk www.sealey.co.uk

ENVIRONMENT PROTECTION

Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to

a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely

unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids

according to local regulations.

WEEE REGULATIONS

Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment

(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid

waste authority for recycling information.

Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior

notice.

Important: No Liability is accepted for incorrect use of this product.

Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.

LED100WS Issue 1 20/02/19

Original Language Version

Inhaltsverzeichnis

Andere Sealey Sprecher Handbücher

Sealey

Sealey LED100WS.V2 Bedienungsanleitung

Beliebte Sprecher Handbücher anderer Marken

argon audio

argon audio IE20 Bedienungsanleitung

Denon

Denon SC-N7 Bedienungsanleitung

Gemline

Gemline Ace 3952 Bedienungsanleitung

Focal

Focal ON WALL 300 Bedienungsanleitung

HEADRUSH

HEADRUSH Maximus HRSP 5024 Bedienungsanleitung

SoundLogic

SoundLogic BCCS-6/6395 Bedienungsanleitung

Peavey

Peavey DTH 218 Bedienungsanleitung

Avantree

Avantree Pluto Air Bedienungsanleitung

Morel

Morel Integra Series INTEGRA OVATION 4 Bedienungsanleitung

Oppo

Oppo SONICA Bedienungsanleitung

Bose

Bose SoundLink Wireless Music System Bedienungsanleitung

Rocksteady

Rocksteady Stadium Bedienungsanleitung

Bowers & Wilkins

Bowers & Wilkins 4 Bedienungsanleitung

Sonance

Sonance SONOS OUTDOOR Series Bedienungsanleitung

Electro-Voice

Electro-Voice EVID FM4.2 Bedienungsanleitung

Pioneer

Pioneer XW-HTD630 Bedienungsanleitung

Onn

Onn BWA16AA002 Bedienungsanleitung

HP GL313AA - USB Speakers PC Multimedia Bedienungsanleitung