Nepata
Vertrieb
GmbH
Hochstatt
6-8
85283
Wolnzach
Germany
m
[email protected] www
.se
ca
bo.
com
●
Now the transfer press can be closed via the press lever to carry out transfers.
●
When the press is closed, the timer starts to count down, and about half a second later
the magnet is activated, which is indicated by a flashing light at CDL in the display. Only
then is the press locked.
●
After the timer has expired, there is also an acoustic signal, after which the press opens
automatically.
Carry out transfers
●
Switch on the heat press via the main switch.
●
Store the desired parameters for temperature and time and confirm each of them as
described above. For information on how to change the settings on the controller, see
the preceding paragraphs.
●
You can regulate the contact pressure by increasing or decreasing the lever travel by
turning the small hand screw on the underside of the press. Turning clockwise
increases the contact pressure and turning anticlockwise decreases it.
●
Tension the transfer object with the tension lever to the left of the base element as
tightly and flat down as possible to avoid creases in the transfer.
●
No setting can be changed during the pressing process.
Notes
●
Note that the heating plate and the transfer objects are hot and there is a risk
of burns.
●
Switch off the machine when it is not needed.
●
Please note that it takes a certain amount of time for the press to cool down
again after it has been switched off. There is a risk of burns until it has cooled
down completely!
Maintenance and cleaning
All maintenance work must be carried out when the press is switched off and has cooled down. The
plug must be removed from the socket beforehand. Only carry out maintenance work after
consulting our technical support.
The press should be cleaned regularly with a soft cloth and a mild household cleaner to remove
adhesive residues, dust, etc. Do not use scouring pads, solvents or petrol!
