GS001M0000SE 034926 220720
7
SWITCH IOT OPERATION MODE
With the SwitchON WiFi IoT mode (remote switch) it is possible, using the Seitron Smart app, to switch on and off two loads, one for each relay
with which the product is equipped; the loads can be, for example, an irrigation system or an automatic garage door.
The app sends out special signals via WiFi to the SwitchON depending on the user’s needs. These WiFi signals are received and decoded by the
SwitchON, which is normally installed in the same room where the controlled loads are. On the SwitchON, the output relay is turned on or off
depending on the commands the user sends it through the app Seitron Smart; the outputs, for example, can be also connected to a valve which
controls the hot/cold water flow inside the related heating/cooling system in the room.
Before installing the device on its nal position, make sure there is enough WiFi signal covering the area.
OPERATION AND MECHANICAL DESCRIPTION
The device is featured with 2 buttons and 2 LEDs placed on the front; the buttons are used when pairing the App Seitron Smart with the SwitchON
and during normal operation, while the LEDs are used to give information on the status of the outputs and on the status of the device itself.
The functions and indications provided by the product are listed below in detail:
BUTTONS OPERATION
Long press puts the device in pairing mode; if the device is already in this mode, a long press switches off the pairing mode and
returns the device to normal operation mode.
Short press switches relay n°1.
Short press switches relay n°2.
Long press at the same time reboot the device.
LED OPERATION
Red/green blinking, the device is in pairing mode.
Green blinking, the device is searching for the last WiFi network it has been connected to.
Steady green-lit, relay n°1 is Normally Closed.
Steady red-lit, relay n°1 is Normally Open.
Steady green-lit, relay n°2 is Normally Closed.
Steady red-lit, relay n°2 is Normally Open.
A
B
A B
C D
C
D
Fig.1
C
D
A
B
