Senior Bad S17D Bedienungsanleitung

1
Assembly Instructions Whirlpool Bath
S17D (08v22) eng
Attention: The assembly of this tub
should be done by two people!
Senior
BadGmbH

2
Foreword
Dear customer, we are pleased that you have chosen this product. Please observe all
instructions before assembly and use and strictly follow the procedure below!
Please check the product for completeness rst. If there is any damage, please send us a
message with a short description and photos of the aected area. A responsible employee
will contact you as soon as possible and nd a solution together with you.
You have a 2-year legal warranty on all products.
Important information
Please note: The product is designed exclusively for private use. Our products are sub-
ject to constant further development. This may result in changes to the design and the
use of other components. We try to keep the following pages up to date. If you have any
questions regarding the design, please contact us at +49 35795 - 179 600 or by e-mail at
kundenservice@seniorbad.de. We are very grateful for any suggestions for improvement.
Please read the operating instructions carefully rst!
If you still have questions about the assembly, we will be happy to help you personally.
Complaints resulting from incorrect installation or use are excluded from the warranty!
Seals, hand showers, shower hoses and castors are wearing parts, therefore a warranty
period of 6 months applies here. The costs for replacement are not covered. Illuminants are
completely excluded from the warranty.
• Installation and assembly work should only be carried out by a skilled worker.
• Make sure that the bathtub is properly earthed. We recommend that any electrical
connections be made by trained professionals.
• The permissible water pressure should be approx. between 4 and 6 bar.
• From a hardness level of 10° (German hardness) we recommend the installation of a
softening device.
• Complaints based on limescale deposits are excluded from the warranty!

3
Sealing areas under/behind the bathtub
Sealing is compulsory - silicone is not enough!
The areas behind and under the bathtub must be tiled. Sealant joints - like silicone joints
- are not waterproong, but only maintenance and beauty joints! Only the use of bathtub
sealing tapes or e.g. sheet sealants comply with this DIN.
Waterproong according to DIN 18534
„This standard is therefore not only addressed to the waterproong specialist, but also to
those who are responsible for the overall planning and execution of the building and its
components, because the eect and durability of the waterproong depend on the coordi-
nated planning of all those involved.“
You as the installer are responsible for reliable waterproong alongside the planner and
tiler. „The waterproong must full its function for the intended service life with sucient
reliability.“
Waterproong must be planned so that it functions for the entire duration of use. In a
domestic bathroom, this can be an average of 20 to 25 years. In practice, this means laying
tiles or a membrane waterproong under the bath is mandatory. Note that the sealing area
at the transition from the oor to the wall must be at least 10 cm high.
Please note:
• The pool must not be permanently installed. It must be ensured that it can be moved
away from the wall for maintenance work.
• The pool should be connected by an approved tradesman.
• The pool should be installed by a professional in accordance with these installa-
tion instructions. The electrical connection for the pool must be made by a certied
electrician. This person must also ensure sucient earthing to prevent accidents and
malfunctions.
• Please have an electrician check the function of the residual current circuit breaker
regularly.
• The statics of the oor must ensure that it can withstand the total weight of the pool,
including water and one person.
• The feet of the pool must stand on a rm, stable surface. The oor must be level.
• Any damage found during unpacking must be reported to the dealer immediately; it is
best to take photos and send them to the dealer.

4
Technical data
Outside dimensions of the pool 150 cm Length
75 cm Width
54 cm High
Hot and cold water connection ½ Inch max. 4 Bar
Waste water HT 40mm
Power connection 220-240 V
50 Hz
max. 4 A
Massage pump water 900 W
Max. water ll level 38 cm
Tools for the construction
Tools are not included in the package.
Check completeness!
Please check for completeness. If you do not nd something immediately, please check
again carefully. Small parts in particular are easily overlooked due to the large number of
parts and the mass of the packaging. Please do not dispose of the packaging until you are
sure that it does not contain any small parts.
Spirit level Drill/screwdriver Measuring
tape
Phillips / slotted
screwdriver
Open-end spanner

5
Product components
A
ASanitary acrylic bathtub with door
BWall rail
CShower door
B
C
C
B
Door seal
Wall plug Screws Wall rail
Connecting
screw to the
wall rail
Washers and
Cover caps

6
Dimensioning
Designations
54 cm
20 cm
194 cm
75 cm
132 cm
55 cm
63 cm
38 cm
37 cm
12 3
4 5
6
78
8
9
10
Warm-/Kaltwasser
Umschalter
Wanneneinlauf - Handbrause
Handbrause
Einstellung Massagedüsen
Massagedüsen ein/aus
Wanneneinlauf
Wasser Ansauger
Massagedüsen
Abuss Öner
Hot/cold water
Switch Bath ller/
Hand shower
Hand shower
Setting massage jets
Massage jets on/o
Bath ller
Water suction
Massage jets
Drain opener
Drain

7
Preparing the connections
S17D right
Hot water 1/2 Inch
Cold water 1/2 Inch
- Connections can also be on the opposite side (possible with hose extension)
Grey area = possible area for the drain pipes, in the wall area the drain can be up
to a max. height of 6 cm from the centre of the hole.
Waste water via a supplied exible connection HT 40.
ATTENTION: leave the 15 cm Ø around the white siphon (dark grey area) under
the tub free.
Socket 230V 16A (or xed socket)
21 cm
15-100 cm
10-45 cm
20 cm 20 cm
33cm
0-6 cm
12
3
4
5
Hot/cold water
Switch Bath ller/
Hand shower
Hand shower
Setting massage jets
Massage jets on/o
Bath ller
Water suction
Massage jets
Drain opener
Drain

8
S17D left
Hot water 1/2 Inch
Cold water 1/2 Inch
- Connections can also be on the opposite side (possible with hose extension)
Grey area = possible area for the drain pipes, in the wall area the drain can be up
to a max. height of 6 cm from the centre of the hole.
Waste water via a supplied exible connection HT 40.
ATTENTION: leave the 15 cm Ø around the white siphon (dark grey area) under
the tub free.
Socket 230V 16A (or xed socket)
21 cm
15-100 cm
10-45 cm
20 cm 20 cm
33cm
0-6 cm
12
3
4
5

9
Alignment
In order for the pool to stand straight, it is necessary to align the pool precisely with the
help of a spirit level. Each foot is individually adjustable, so you can compensate for small
irregularities in the oor. Please make sure that all feet are touching the ground and that the
weight is evenly distributed on the ground. To adjust the feet, the apron of the tub must not
be removed. The front feet can be easily adjusted by tilting the tub slightly. All other feet can
be easily reached from the side.
Installing the drain
The drain is in the oor, but the exible drain hose can also be attached to a drain in the
wall, but not higher than 6 cm so that the drain is still allowed. The exible connection HT 40
used for this purpose is included in the delivery. It is not necessary to remove the apron for
installation.
Tub
Ground
Wall
Tub
Ground
Wall

10
Connecting the cold and hot water
After the drain pipes have been installed, the water is now connected. The cold water con-
nection is on the right and the hot water connection is on the left.
Mounting the wall rail
The wall rail B for fastening the
wall panel is screwed to the wall at
the front right or left corner of the
tub, according to the orientation of
your tub. To do this, align it straight
with a spirit level and mark the
three drill holes (see illustration).
Drill the holes with a 6 mm dia. drill
bit and insert the B1 dowels into
them. Now fasten the rail to the
wall with the screws B2.
Wand
Kaltwasser Warmwasser
Cold water
Wall
Hot water
Inhaltsverzeichnis
Andere Senior Bad Badewanne Handbücher

Senior Bad
Senior Bad K55 Bedienungsanleitung

Senior Bad
Senior Bad F01 Bedienungsanleitung

Senior Bad
Senior Bad W23 Bedienungsanleitung

Senior Bad
Senior Bad W20 Bedienungsanleitung

Senior Bad
Senior Bad W60 Bedienungsanleitung

Senior Bad
Senior Bad T18 Bedienungsanleitung

Senior Bad
Senior Bad W02 Bedienungsanleitung

Senior Bad
Senior Bad S12D Bedienungsanleitung
Beliebte Badewanne Handbücher anderer Marken

Lyons
Lyons Elite ETLxx663219 Series Bedienungsanleitung

Woodbridge
Woodbridge BJ500 Montageanleitung

Whirlpool
Whirlpool Ariel ARL-702 Bedienungsanleitung

TEIKO
TEIKO EXCELLENT DUO Bedienungsanleitung

American Standard
American Standard Colony 5-1/2' x 32" Bedienungsanleitung

American Standard
American Standard 3052OD.X0X Kurzanleitung











