SensAlarm Flex –Universal Gas Detection System
Sensidyne Document No. 360-0257-01 (Rev A) P a g e 7 | 82
THE SELLER SHALL NOT BE LIABLE FOR DIRECT, INDIRECT, CONSEQUENTIAL, INCIDENTAL OR
OTHER DAMAGES RESULTING FROM THE SALE AND USE OF ANY GOODS AND SELLER’S
LIABILITY HEREUNDER SHALL BE LIMITED TO REPAIR OR REPLACEMENT OF ANY GOODS
FOUND DEFECTIVE. THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR
IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY
AND FITNESS FOR USE OR FOR A PARTICULAR PURPOSE WHICH ARE EXPRESSLY
DISCLAIMED.
WARNING: READ AND UNDERSTAND ALL WARNINGS AND INSTRUCTIONS BEFORE USE
Failure to read, understand, and comply with ALL accompanying literature, instructions, product
labels, and warnings may result in property damage, severe personal injury, or death.
Product is tested and calibrated at the factory prior to shipment. However, this product must be calibrated
prior to initial use and at regular intervals in accordance with this User Manual to ensure proper operation.
Failure to calibrate and operate this product in accordance with this User Manual may result in the
malfunction of the product.
Read and understand ALL applicable federal, state, and local environmental health and safety laws and
regulations, including OSHA. Ensure complete compliance with ALL applicable laws, codes, and
regulations before and during use of this product.
The owner, user, and installer must understand Hazardous Area Protection Concepts and Area
Classifications associated with their application.
UNDER NO CIRCUMSTANCES should this product be used except by qualified or certified, trained,
technically competent personnel, and not until the warnings, user manual, labels, and other literature
accompanying this product have been read and understood.
ALWAYS wash your hands thoroughly after handling, calibrating, or servicing this product.
ALWAYS wear eye protection, such as safety goggles or a face shield, chemically resistant gloves, and
chemically resistant clothing when handling chemicals, or calibration gas standard sources.
DO NOT get chemicals, gases, fumes, or vapors in your eyes or on your skin, as they may cause severe
burns to skin and eyes. If chemicals, gases, fumes, or vapors get in your eyes or on your skin, wash the
affected area thoroughly with water and seek immediately medical attention.
ALWAYS avoid contact with acids to your skin or eyes. Seek immediate medical attention for any contact
with acids.
ALWAYS calibrate in a well-ventilated area. Adequate precautions should be taken to prevent the
buildup of ANY calibration sources or vapors. Avoid breathing ANY calibration fumes or vapors as they
may be hazardous to your health.
ALWAYS dispose of chemicals and calibration sources in compliance with ALL applicable safety laws,
codes, regulations, and guidelines for proper disposal. Failure to do so may result in environmental
damage, property damage, personal injury or death.
ALWAYS close ALL containers of chemicals used with this product after use.
ALWAYS ensure that any compressed calibration substance sources are empty prior to disposal.
ALWAYS use clean, dry, inert materials to contain and / or transfer substances used for calibration.
DO NOT remove, cover, or alter any label or tag on this product, its accessories, or related products.
