Sentiotec Onni Mini Bedienungsanleitung
User manual
02/2022
1/10
EN
ENDE
FR
IT
SV
FI
RU
ET
Infrared cabin
Onni Mini (1-053-078)
Table of Contents
1. About this instruction manual 3
2. Important information for your safety 3
2.1. Intended use 3
2.2. Safety information 4
3. Product description 5
3.1. Technical data 5
3.2. Floor plan 5
3.3. Scope of delivery 6
3.4. Parts list 6
4. Preparation for assembly 7
5. Assembly illustrations (following the last language
of the instructions) 11
6. Circuit diagram 8
7. Operation 9
7.1. Commissioning 9
7.2. Temperature settings 9
7.3. Time settings 9
7.4. Light 10
7.5. Music 10
8. Guarantee card 14
9. Spare parts 16
EN
Instructions for installation and use p. 3/10
These installation and operating instructions can also be found in
the downloads section of our website: www.sentiotec.com/downloads.
1. About this instruction manual
Read these installation and operating instructions carefully and keep them within
reach of the infrared cabin. This ensures that you can refer to information on
safety and operation at any time.
2. Important information for your safety
The infrared cabin has been produced in accordance with the applicable safety
regulations for technical units. However, hazards may arise during use. Therefore
adhere to the following safety information and the specific warning notices in the
individual chapters.
2.1. Intended use
The infrared cabin is used for the heating of the human body.
The cabin location must be protected against splashing water. For optimal
operation, the location should have an ambient temperature of at least 20 °C.
The maximum air humidity in the surroundings should not exceed 95%.
The cabin must be erected on a level surface. A distance of at least 5 cm from
the wall must be maintained.
Any use exceeding this scope is considered improper use. Improper use can
result in damage to the product, severe injuries or death.
Instructions for installation and use p. 4/10
2.2. Safety information
●Installation and connection of the electrical parts (control unit, heater, etc.)
may only be performed when the power supply is disconnected.
●Also comply with the regulations applicable at the installation location.
●For your own safety, consult your supplier in the event of problems that are
not explained in sufficient detail in the installation instructions.
●The cabin may not be used by children under 8 years old.
●The cabin may be used by children over 8 years old, by persons with lim-
ited psychological, sensory or mental capabilities or by persons with lack of
experience/knowledge only under the following conditions:
– They are supervised.
– They have been shown how to use the device safely and are aware
of the hazards that could occur.
●Children may not play with the cabin.
●Children under 14 years of age may only clean the cabin if they are super-
vised.
●The cabin may not be cleaned with steam cleaners, high-pressure cleaners
or splashed water.
●For health reasons, do not use the sauna when under the influence of alco-
hol, medication or drugs.
●Before the control unit is switched on, make sure that no combustible ob-
jects have been placed on the heating elements.
EN
Instructions for installation and use p. 5/10
3. Product description
3.1. Technical data
Cabin material Abachi
Cabin dimensions (L x W (depth) x H) 1000 x 1043 x 2000 mm
Voltage supply 230 VAC 50 Hz
Total output 1400 Watt; 6.1 A
IR radiator, dimmable 1 × 400 W
Heating elements, sides 2 × 300 W
Heating element, calves 1 × 200 W
Heating element, floor 1 × 200 W
3.2. Floor plan
200W
400W
300W
550
1043
1000
300W 300W
400W
200W
Instructions for installation and use p. 6/10
3.3. Scope of delivery
No. NAME DIMENSIONS PIECES
1 Roof cover 914 x 954 x 5 mm 1
2 Roof element 914 x 954 x 65 mm 1
3 Rear wall 914 x 1980 x 59 mm 1
4 Right side wall 1013 x 1980 x 46 mm 1
5 Left side wall 1013 x 1980 x 46 mm 1
6 Glass front 1000 x 2000 x 67 mm 1
7 Heating element, side 460 x 878 x 40 mm 2
8 IR radiators 250 x 780 x 65 mm 1
9 Ergonomic bench 914 x 550 x 80 mm 1
10 Bench support 914 x 510 x 60 mm 1
11 Heating element, calves 914 x 390 x 40 mm 1
12 Heating element, floor 670 x 340 x 55 mm 1
13 Ergonomic backrest 800 x 870 x 111 mm 1
14 Door handle 1960 x 80 x 32 mm 1
15 Floor grid 914 x 954 x 46 mm 1
Screws 4 x 35 mm 14
Screws 5 x 60 mm 4
Screws 4 x 35 mm 6
3.4. Parts list
EN
Instructions for installation and use p. 7/10
4. Preparation for assembly
Before you begin work, check the parts list to ensure that all the individual parts
have been delivered. If you discover any missing parts, notify your dealer within
14 days of receiving the sauna cabin.
You need an assistant for assembly.
We also advise you to pre-drill the holes for the screws
60 cm
80 cm
100 cm
Check the right angle:
Handle glass with care: Special care must be taken with the edges of
the glass – hardened glass can shatter into small pieces in the event of
impact. Insert protective cushioning (e.g: cardboard box) under the edge
of the glass.
Tools required
5. Assembly illustrations
(following the last language of the instructions) page 11
Pencil
Spirit level
Twist drill bit
Screwdriver
Utility knife
Tape measure Drill
Step ladder
Instructions for installation and use p. 8/10
6. Circuit diagram
Power Line
AC100V-240V 50-60Hz
Heating Rod
Light Rod(220V)
A B C
Heating Rod
D E F
N
N
L
L
AC230V/300W
左侧发热管
AC230V/300W
AC230V/200W
AC230V/200W
右侧发热管
挡板发热管
底部发热管
AC230V/400W
背部发热管
Control
Mp3 USB
70°C
Temperature Control
Speaker 8Ω5W
Speaker 8Ω5W
L
L
Color Light(DC12V)
Antenna
Power Line
AC100V-240V 50-60Hz
Heating Rod
Light Rod(220V)
A B C
Heating Rod
D E F
NN
LL
AC230V/300W
左侧发热管
AC230V/300W
AC230V/200W
AC230V/200W
右侧发热管
挡板发热管
底部发热管
AC230V/400W
背部发热管
Control
Mp3 USB
70°C
Temperature Control
Speaker 8Ω5W
Speaker 8Ω5W
L
Antenna
AC230V/400W
背部发热管
单人 双人
L
Color Light(DC12V)
Speaker 8Ω 5W
Speaker 8Ω 5W
Temperature sensor
Antenna
Coloured light
IR radiators
Heating element,
left
Heating element,
floor
Heating element,
calves
Heating element,
right
Reading light, 220 V
Control unit
Supply line
AC230V 50 Hz
MP3 USB
400 W
300 W
300 W
200 W
200 W
Control unit
Power unit
Fuse 1
2
3
5
6
7
8
9
a
b
a
5
1 - bNumbering Spare parts list
EN
Instructions for installation and use p. 9/10
7. Operation
7.1. Commissioning
Connect all connectors according to the cir-
cuit diagram and then connect the control
unit (power unit) to the wall socket.
On/off lights up on the display.
Press On/off to switch the control unit on. The heating elements start to heat.
The cabin temperature and the operating time are displayed. The time is auto-
matically activated for 60 minutes or to the last selected time. If you press On/off
again,
all functions (heating elements, light and music) are switched off.
Settings can be made for 10 seconds (flashing display), then it switches
to display mode.
7.2. Temperature settings
The desired temperature can be set with the Temperature +/- keys (30-70 °C).
If you press and hold the “Temperature +” key (for three seconds), you can
choose between °C and °F.
When the temperature is reached, all heating elements are automatically
switched off. If the temperature drops 2 °C below the previously set tempera-
ture, the heating elements are automatically switched on again.
If the cabin temperature exceeds 80 °C, “HH” flashes in the display. All functions
are automatically switched off. Wait until the temperature drops below 70 °C,
and restart the cabin with ON/OFF.
The maximum temperature that can be reached in the cabin may be
lower than the desired temperature. This depends on the temperature
outside the cabin.
7.3. Time settings
The desired heating time from 5 to 60 min. can be set with the Time +/- butto
n
(each press of the button = 1 minute). There is then a countdown of the minutes
and at “00” all functions are automatically switched off.
Instructions for installation and use p. 10/10
7.4. Light
Pressing the Light button switches on the reading light and the coloured light.
You can enter the setting mode by pressing and holding the “Light” button for
three seconds (“Lx” (x = 1-9) in the temperature display and “2n” in the time
display). The following settings are possible:
“Time +”: Reading light on/off
“Time -”: Coloured light on/off
“Temperature + / -”: Colour selection
L1 = white, L2 = pink, L3 = blue, L4 = sky blue, L5 = green, L6 = yellow,
L7 = red, L8 = rotate colours, L9 = slow change of colour
7.5. Music
By pressing the Music button you can switch between the FM radio, Bluetooth,
USB and external input AUX functions.
Volume +/- can be used to control the volume in the range of 1 to 30.
Press Track / to select the previous/next track/radio station.
FM radio
Press the Music button until FM is displayed and then press and hold the Music
button for three seconds. The radio will automatically search for and store sta-
tions (stations from 87.5 MHz to 108.5 MHz). Press Track / to select the
previous or nextradio station.
Bluetooth
Press the Music button until BLU is displayed, in order to activate the Bluetooth
connection to your mobile phone. Turn on the Bluetooth search function of the mo-
bile phone and search for the “BT Sauna” Bluetooth device (match time = 7 sec.).
After successfully connecting with the phone, you can play the music from the
mobile phone.
USB
Press the Music button until USB is displayed. Music (MP3) is played from
the inserted USB stick.
AUX
Press the Music button until AU is displayed. The music from the connected
device plays.
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Sprachen:
Andere Sentiotec Heizung Handbücher
Sentiotec
Sentiotec HOME Premium Fin Bedienungsanleitung
Sentiotec
Sentiotec Concept R Bedienungsanleitung
Sentiotec
Sentiotec HWO-035NS-P Bedienungsanleitung
Sentiotec
Sentiotec Concept R combi Bedienungsanleitung
Sentiotec
Sentiotec Qube Series Bedienungsanleitung
Sentiotec
Sentiotec IKI Monolith MLT-138NS Bedienungsanleitung
Sentiotec
Sentiotec Concept R mini CP-RM-75 Bedienungsanleitung
Sentiotec
Sentiotec IR-WP-175 Bedienerhandbuch
Sentiotec
Sentiotec Concept R mini Series Bedienungsanleitung
Sentiotec
Sentiotec DIR-350-R Bedienungsanleitung
Sentiotec
Sentiotec VITAE 350 Bedienungsanleitung
Sentiotec
Sentiotec TH6-VR Leitfaden
Sentiotec
Sentiotec Concept R mini combi CP-RMC-35 Bedienungsanleitung
Sentiotec
Sentiotec CP-RM-HSR-4S Leitfaden
Sentiotec
Sentiotec Concept R CP-RC-AF Bedienungsanleitung
Sentiotec
Sentiotec Concept R Bedienungsanleitung
Sentiotec
Sentiotec Home fin HOME-F45 Bedienungsanleitung
Sentiotec
Sentiotec ECO-350-G Bedienungsanleitung
Sentiotec
Sentiotec 145 Bedienungsanleitung
Sentiotec
Sentiotec HOME Premium Combi Bedienungsanleitung
Beliebte Heizung Handbücher anderer Marken
Empire Heating Systems
Empire Heating Systems WCC65 Bedienungsanleitung
Wetekom
Wetekom 92 86 43 Bedienungsanleitung
Desa
Desa SPC170-F Bedienungsanleitung
Watlow
Watlow Watrod Electric Tubular Heaters Bedienungsanleitung
Haverland
Haverland ECO-DRY GPS Series Stücklistenhandbuch
Stelpro
Stelpro ASILVC2060 Series Bedienungsanleitung