7
SI 460C DIN SIZE WEIGHING CONTROLER
4. Set point setting : Set SP-1 value
5.Test Mode 1 : Analog value check mode
6.Test Mode 2 : Relay out check mode
7.Set up Mode : Enter F-FUNCTION Mode
1. To set the “HOLD”Function (refer F10) [1st input : “HOLD”, 2nd input : “HOLD Reset”]
2.Calibration Mode , F-Function setting : Move to right
3. Under “SETUP”Mode, Enter into the “Calibration”Mode.
4. Set point setting : Set SP-2 value
5.Test Mode 1 : Analog Variation value check mode
6.Test Mode 2 : Check relay output
7.Set up Mode : Enter Calibration Mode.
※Under HOLD setting first digit as “H”
1. Normal Mode : Print out (refer F38, F32)
2.Calibration Mode , F-Function setting :Increase set value
3. Set point setting : Set SP3 value
4.Test Mode 1 : Key/Digital Input check mode
5.Test Mode 2 : Standard Serial I/F check mode
6. Set up Mode : Enter Test Mode.
※If the printer is installed, under “F01-01 setting, when you press this key the current
valued is increased. And the current weight is saved and print out, altogether. (Refer to
CH.5-4)
1.Normal Mode : Press this key 4times, within 2secs, enter to “SET-UP”mode.
2.Calibration Mode : Enter
3.F-Function setting : Save the value go to next step
4. Set point setting : Set SP4 value
5.Test Mode 1 : Go back to Test mode 2
6.Test Mode 2 : Extended Serial I/F check mode
7.Set up Mode : Set point setting Mode.
●Setup Mode :It is a mode can SET UP the calibration, Function of SI 460C. (refer to CH5. SET UP)
3-2-3. Hot key (with F key)
Continuous “TARE”setting
(From the second TARE setting, use this key)
If the Printer is installed,
You can print out the “Grand-total data”.
(GRAND-total data can be checked though Print output).
Max. accumulated weighing count : 999,999times
Over 999,999times return to “0” time
Max. accumulated weight display : 999999999 (g, kg, ton)
Over 999,999,999 (g, kg, ton) return to “0” (g, kg, ton)
