Sharp FP-J40E Bedienungsanleitung
Free standing type
Jenis berdiri sendiri
Kiểu máy có chân tự đứng
站立式
R
FP-J40E
FP-J40L
FP-J40M
“Plasmacluster” and “Device of a cluster of grapes”
are registered trademarks of Sharp Corporation in
Japan, Philippines and elsewhere.
*The number in this technology mark indicates an
approximate number of ions supplied into air of 1 cm3,
which is measured around the center of a room with
using the high-density plasmacluster ion evolving
device is placed close to a wall. This product is
equipped with a device corresponding to this capacity.
AIR PURIFIER
OPERATION MANUAL
ENGLISHMALAYSIA
PEMBERSIH UDARA
BUKU PANDUAN OPERASI
HƯỚNG DẪN SỬ DỤNG MÁY
NĂNG BẮT MUỖI
空气净化器操作手册
中文
OM_FP-J40E_40L_EN.indd 1 2018/06/25 11:42:52
Pre-Filter
HEPA Filter
Deodorizing Filter
NOTE
The air purifier draws in room air from the air intake, passes the air through a Pre-Filter, a
Deodorizing Filter and a HEPA Filter inside of the main unit, then discharges the air through the
air outlet. The HEPA Filter can remove 99.97% of dust particles as small as 0.3 microns that pass
Some odors absorbed by the filters may break down over time, resulting in additional odor.
Depending on the usage environment, especially when the product is used in extreme environments
remove the odor.
Please read before operating your new Air Purier
OM_FP-J40E_40L_EN.indd 2 2018/06/25 11:42:53
EN-1
ENGLISH
ENGLISH
Thank you for purchasing the SHARP
Before using this product, be sure to read the
section: “Important Safety Instructions.”
After reading this manual, keep it in a convenient
location for future reference.
For your reference, we recommend to keep this
manual in the place where you can read at any time.
IMPORTANT SAFETY INSTRUCTIONS
.............EN-2
PART NAMES ...................................................EN-4
FILTER INSTALLATION ...................................EN-5
OPERATION .....................................................EN-6
CARE AND MAINTENANCE ............................EN-8
REPLACEMENT ...............................................EN-9
TROUBLESHOOTING....................................EN-10
SPECIFICATIONS........................................... EN-11
CONTENTS
FEATURES
Unique Combination of Air Treatment
Technologies
Triple Filtration System + Plasmacluster
TRAPS DUST*
Pre-Filter traps dust and other large airborne
particles.
DECREASES ODORS
household odors.
REDUCES POLLEN & MOLD*
0.3 microns.
FRESHENS
Plasmacluster treats the air similar to the way
nature cleans the environment by emitting a
balance of positive and negative ions.
Sensor Technology continuously monitors air
quality, and automatically adjusting operation
based on detected air purity.
OM_FP-J40E_40L_EN.indd 1 2018/06/25 11:42:55
EN-2
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic safety precautions should be followed, including the
following:
WARNING
• Read all instructions before using the main unit.
• Use only a 220-240 volt outlet.
• Do not use the main unit if the power cord or plug is damaged or the connection to the wall
outlet is loosened.
• Periodically remove dust from the power plug.
• Do not insert ngers or foreign objects into the intake or air outlet.
• When removing the power plug, always hold the plug and never pull the cord.
•
• Do not remove the plug when your hands are wet.
• Do not use this unit near gas appliances or replaces.
• Remove the power plug from the wall outlet before cleaning the main unit and when not using
the main unit.
•When cleaning the main unit, or when the main unit is not in use, be sure to unplug the main unit.
• If the power cord is damaged, it must be replaced by the manufacturer, its service agent, Sharp
Approved Service Center or similarly qualied person in order to avoid a hazard.
• Do not operate when using aerosol insecticides or in rooms where there is oily residue, incense, sparks
from lit cigarettes, chemical fumes in the air or in very high humidity conditions, such as a bathroom.
• Be cautious when cleaning the main unit. Corrosive cleansers may damage the exterior.
•
Center for any problems, adjustments, or repairs.
• This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure they do not play with the appliance.
NOTE
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
OM_FP-J40E_40L_EN.indd 2 2018/06/25 11:42:56
EN-3
ENGLISH
CAUTIONS CONCERNING OPERATION
• Do not block the intake and/or air outlet.
• Do not use the unit near or on hot objects, such as stoves or heaters or where it may come into contact
with steam.
• Do not lay the unit down when using.
• Always hold the handle on the back of the unit when moving it.
• Do not wash and reuse the HEPA lter and the deodorizing lter.
INSTALLATION GUIDELINES
• When using the unit, place it away from equipment utilizing electric waves such as televisions or
radios to avoid electrical interference.
• Avoid use in locations where furniture, fabrics or other items may come in contact with and
restrict the air intake and/or air outlet.
• Avoid use in locations where the unit is exposed to condensation or drastic temperature
changes. Appropriate conditions are when room temperature is between 0 – 35 ºC.
• Place on a stable surface with sufcient air circulation.
When placing the unit on a heavily carpeted area, the unit may vibrate slightly.
• Avoid locations where grease or oily smoke is generated.
The unit surface may crack as a result.
• The dust collecting ability of the unit is effective even when the unit is as close to 3 cm from the wall,
The wall directly behind the air outlet may become dirty over time. When using the unit for an extended
period of time at the same location, periodically clean the walls adjacent to it.
FILTER GUIDELINES
OM_FP-J40E_40L_EN.indd 3 2018/06/25 11:42:56
EN-4
PART NAMES
18
17
2
1
1Main Unit 10 Cleanliness Monitor
2Air Outlet 11 Handle
3OFF TIMER Button, Indicator Light (white)
(Press 3 sec.) Filter Reset Button, Indicator Light (orange)
12 Dust Sensor Filter
13 HEPA Filter
4MODE Button, Indicator Light (white)
(Press 3 sec.) Plasmacluster Ion ON/OFF Button
14 Deodorizing Filter
15 Back Panel
5HAZE Button, indicator Light (white16 Bottom Tabs
6POWER ON/OFF Button 17 Plug
7Light Sensor
8Odor Sensor 18 Power Cord
9Plasmaclustor Ion Light (blue)
FRONT
BACK
16
13
14
10
11
12
15
Cleanliness Monitor
Indicates the air purity of the room
in 3 levels with color changes.
Blue
Orange
Red
Clean
Impure
8
7
3456
9
OM_FP-J40E_40L_EN.indd 4 2018/06/25 11:43:03
EN-5
ENGLISH
FILTER INSTALLATION
To maintain the quality of the lter, it is installed in the main unit and packed in plastic bag.
Be sure to the remove plastic bag from the lter before using the unit.
• Do not operate the unit without the lter.
Be sure to remove the power plug
from the wall outlet.
3 Place the Filter within the main unit.
will not operate properly.
4Replace the Back Panel to the main
unit.
HEPA Filter
Deodorizing Filter
1 Remove the Back Panel.
2 Remove the plastic bag from the
Filter.
Click
Pull
OM_FP-J40E_40L_EN.indd 5 2018/06/25 11:43:14
EN-6
OPERATION
AUTO SLEEP MED MAX
The unit operates at HIGH fan speed for 60 minutes and then alternates between Low and High level for 20 minutes
each.
START
• Select the desired fan speed.
•When the main unit starts operation, the operation
starts in the previous mode it was operated in.
STOP
HAZE
START
10 minutes: Max High fan level
50 minutes: High fan level
20 minutes: Low fan level
20 minutes: High fan level
• The Plasmacluster Ion can not be turnes ”OFF”.
• It is possible to switch this mode to another while
operating. However, the HAZE mode will not func-
tion after switching mode.
FAN SPEED
OFF TIMER
Select the length of time you want, with the main unit on. The main unit automatically stops once the selected time is
reached.
START/STOP
NOTE
NOTE
AUTO
The fan speed is automatically switched depending on the amount of
impurities in the air.
SLEEP
The unit will operate very quietly, and the fan speed is automatically
switched depending on the amount of impurities in the air.
Cleanliness Monitor/Plasmaclustor Ion Light go off automatically.
Even though the indicator is off, Plasmacluster Ion is dispersed into air
unless Plasmacluster Ion is turned off by
2h 4h 8h OFF
2hour 4hour 8hour CANCELLATION
OM_FP-J40E_40L_EN.indd 6 2018/06/25 11:43:41
EN-7
ENGLISH
Light Control
Plasmacluster Ion ON/OFF
You can set the Cleanliness Monitor / Plasmaclustor Ion Light to OFF when their SIGN is bright.
more than 3 sec.
•When the main unit starts operation, the
operation starts in the previous mode it
was operated in.
NOTE
ON OFF
ADJUSTMENT OF SENSOR DETECTION SENSITIVITY
You can change the sensitivity of the Dust sensor / Odor sensor and the Light sensor .
• If the power OFF Button is not pushed within 8 seconds of
adjusting sensor sensitivity, the setting will be saved automatically.
• The sensor sensitivity setting will be saved even if the main unit is
unplugged.
NOTE
1
2
3
more than 3 sec. more than 3 sec.
more than 3 sec.
AUTO DIM OFF
1
2
Standard High Low
4h 8h 2h
Standard High Low
Dust sensor / Odor sensor Light sensor
•When the main unit starts operation, the
operation starts in the previous mode it
was operated in.
NOTE
OM_FP-J40E_40L_EN.indd 7 2018/06/25 11:44:13
EN-8
Gently remove dust from the back panel, using a vacuum cleaner
attachment or similar tool.
BACK PANEL
To maintain optimum performance of this air puri er, please clean the unit including the lter periodically.
Be sure to disconnect the power cord from the wall outlet before performing any maintenance.
CARE AND MAINTENANCE
Be sure to remove the power plug from the wall outlet.
SENSORS
1. Remove the Back Panel.
2. Remove the Dust Sensor Filter.
3. If it is very dirty, wash it with water and dry it thoroughly.
Dust sensor
Do not apply excessive pressure, when scrubbing the back panel.
Gently remove dust from the odor sensor,
using a vacuum cleaner attachment or similar tool.
Dust sensor
Odor sensor
FILTERS
Tag
HEPA Filter
Deodorizing Filter
CAUTION
Gently remove dust from HEPA Filter and Deodorizing Filter with a vacuum
cleaner attachment or similar tool.
Do not WASH in water and DRY in the sun.
• HEPA Filter
Apply the maintenance only on the side with the tag.
• Deodorizing Filter
The maintenance can be applied to the both sides.
NOTE How to clean hard to remove dirt
1. Add a small amount of kitchen detergent to water and soak for about 10
minutes.
2. Rinse off the kitchen detergent with clean water.
Back
Panel
Odor sensor
Back Panel
CAUTION
OM_FP-J40E_40L_EN.indd 8 2018/06/25 11:44:22
Dieses Handbuch passt für folgende Modelle
2
Inhaltsverzeichnis
Andere Sharp Luftreiniger Handbücher
Sharp
Sharp Plasmacluster KC-6400E Bedienungsanleitung
Sharp
Sharp FP-JM30E Bedienungsanleitung
Sharp
Sharp FZ-80SEF Bedienungsanleitung
Sharp
Sharp FP-GM50E Bedienungsanleitung
Sharp
Sharp FX-S120 Bedienungsanleitung
Sharp
Sharp KI-N51R Bedienungsanleitung
Sharp
Sharp Plasmacluster FU-A80E Bedienungsanleitung
Sharp
Sharp Plasmacluster FP-P30U Bedienungsanleitung
Sharp
Sharp UJ-GC20E Bedienungsanleitung
Sharp
Sharp IG-CL15B Bedienungsanleitung
Sharp
Sharp FP-E50TA Bedienungsanleitung
Sharp
Sharp KC-JG20A Bedienungsanleitung
Sharp
Sharp KC-A60Y Bedienungsanleitung
Sharp
Sharp FU-W43E Bedienungsanleitung
Sharp
Sharp IG-A40UW Bedienungsanleitung
Sharp
Sharp Plasmacluster KC-C70U Bedienungsanleitung
Sharp
Sharp Plasmacluster FU-W25AW Bedienungsanleitung
Sharp
Sharp FP-H30A Bedienungsanleitung
Sharp
Sharp FP-A60UW Bedienungsanleitung
Sharp
Sharp Plasmacluster KC-830U Bedienungsanleitung
Beliebte Luftreiniger Handbücher anderer Marken
Winix
Winix NK300 Bedienungsanleitung
Friedrich
Friedrich C-90A Bedienungs- und Montageanleitung
Surgically Clean Air
Surgically Clean Air JADE2.0 Bedienungsanleitung
Base aire
Base aire 555 Pro Bedienungsanleitung
Champion
Champion CP25 Bedienungsanleitung
vollara
vollara Air & Surface Pro+ Bedienungsanleitung