Sharp PG-M10SU Bedienungsanleitung
1
PG-M10SU/SE
PG-M10XU/XE
SHARP CORPORATION
DLP PROJECTOR
DLP PROJEKTOR
In the interests of user-safety (Required by safety regulations in some countries) the set should be restored
to its original condition and only parts identical to those specified should be used.
Im lnteresse der Benutzersicherheit (erforderliche Sicherheitsregeln in einigen Ländern) muß das Gerät in seinen
Originalzustand gebracht werden. Außerdem dürfen für die spezifizierten Bauteile nur identischeTeile verwendet
werden.
MODELS
MODELLE
CONTENTS / INHALT
• SPECIFICATIONS.............................................. 2
• NOTE TO SERVICE PERSONNEL....................3
• OPERATION MANUAL ...................................... 4
• DISASSEMBLYAND REASSEMBLY ...............10
• REPLACING THE LAMP.................................. 15
• BLOCK DIAGRAM OF OPTICAL SYSTEM
PRINCIPLE ...................................................... 16
• OPTICALADJUSTMENT AND MEASURING ..17
• SAFETY DEVICE............................................. 20
• TROUBLE SHOOTING TABLE ........................21
• BLOCK DIAGRAM ........................................... 43
• PARTS LIST ..................................................... 44
• PACKING OF THE SET ................................... 51
Page
• TECHNISCHE DATEN ..................................... 22
• HINWEISE FÜR DAS
WARTUNGSPERSONAL ................................. 23
• BEDIENUNGSANLEITUNG .............................24
• ZERLEGUNG UND ZUSAMMENBAU .............30
• AUSWECHSELN DER LAMPE........................35
• BLOCKDIAGRAMM FÜR OPTISHES
SYSTEMPRINZIP ............................................ 36
• OPTISCHE EINSTELLUNGEN UND
MESSUNG ....................................................... 37
• SICHERHEITSEINRICHTUNG ........................40
• FEHLERSUCHTABELLE ................................. 41
• BLOCKSCHALTBILD ....................................... 43
• ERSATZTEILLISTE.......................................... 44
• VERPACKEN DES GERÄTS ...........................51
Seite
S90i7PG-M10SU
SERVICE MANUAL
SERVICE-ANLEITUNG
PG-M10SU/SE
PG-M10XU/XE
2
PG-M10SU/SE
PG-M10XU/XE
Specifications
3
PG-M10SU/SE
PG-M10XU/XE
NOTE TO SERVICE
PERSONNEL
UV-RADIATION PRECAUTION
The light source, metal halide lamp, in the DLP
projector emits small amounts of UV-Radiation.
AVOID DIRECT EYE AND SKIN EXPOSURE.
To ensure safety please adhere to the following:
1. Be sure to wear sun-glasses when servicing the
projector with the lamp
turned “on” and the top
enclosure removed.
2. Donot operate the lamp outside of the lamp housing.
3. Do not operate for more than 2 hours with the
enclosure removed.
UV-Radiation and Medium Pressure
Lamp Precautions
1. Be sure to disconnect the AC plug when replacing
the lamp.
2. Allow one hour for the unit to cool down before
servicing.
3. Replace only with same type lamp. Type BQC-
PGM10X//-1 rated 85V/130W.
4. Thelampemitssmall amounts ofUV-Radiation, avoid
direct-eye contact.
5. The medium pressure lamp involves a risk of
explosion. Be sure to follow installation instructions
described below and handle the lamp with care.
12345678901234567890123456789012123456789012345
12345678901234567890123456789012123456789012345
12345678901234567890123456789012123456789012345
12345678901234567890123456789012123456789012345
12345678901234567890123456789012123456789012345
1
234567890123456789012345678901212345678901234
5
12345678901234567890123456789012123456789012345
1234567890123456789012345678901212345678901234
1234567890123456789012345678901212345678901234
1
2
DANGER ! –– Never turn the power on without the
lamp to avoid electric-shock or damage of the
devices since the stabilizer generates high voltages
at its start.
UV-RADIATION PRECAUTION (Continued)
Lamp Replacement
Note:
Since the lamp reaches a very high temperature
during units operation replacement of the lamp
should be done at least one hour after the power
has been turned off. (to allow the lamp to cool off.)
Installing the new lamp, make sure not to touch the
lamp (bulb) replace the lamp by holding its reflector
2.
[Use original replacement only.]
Since small amounts of UV-Radiation are emitted
from an opening between the duct cover and the
lamp housing, it is recommended to place the LENS
CAP on the opening during servicing to avoid eye
and skin exposure (Fig. 1).
Notes:
»Please obtain a lens cap before servicing a model
PG-M10SU/SE, PG-M10XU/XE that is received
without one.
»The color wheel is running at high speed. Do not
touch it nor bring anything nearby.
Lamp
Reflector
COLOR WHEEL LENS CAP
Figure 1.
4
PG-M10SU/SE
PG-M10XU/XE
Location of Controls
5
PG-M10SU/SE
PG-M10XU/XE
6
PG-M10SU/SE
PG-M10XU/XE
Reomte Control
7
PG-M10SU/SE
PG-M10XU/XE
Connections
8
PG-M10SU/SE
PG-M10XU/XE
9
PG-M10SU/SE
PG-M10XU/XE
Pin Assignments
Dimensions
10
PG-M10SU/SE
PG-M10XU/XE
Louver
Screw
Top Cover
S-8
Louver
Screw
DISASSEMBLY AND REASSEMBLY
1.Preparations and precautions
● Tools required
1. Phillips screwdriver, Nos. 1 and 2
2. Phillips and bladed precision screwdrivers
3. Anti-static wrist band
4. Hexagonal wrench (opposite side: ___ mm)
● Precautions for disassembly and reassembly
1. Before starting the procedure, unplug the power cable.
2. Some parts are still hot immediately after operation. Wait until they have cooled down.
3. Restore the components, screws and wires in their original positions.
4. Follow the important notes in handling the components and carrying out the job.
5. Be careful not to confuse the specific component parts for different models.
6. Do not tamper with the unit to ensure safety.
2.Disassembly and reassembly
1) Front panel (See Fig. 1 and Fig. 1-A.)
Remove the two screws (S-8) shown in Fig. 1.
Remove the front panel as shown in Fig. 1-A.
Note: Take care not to damage the IR cable.
Fig. 1
S-8
Front Panel
1
2
Fig. 1-A
2) Top cover (See Fig. 2.)
Remove the two louver screws (S-8) shown in Fig.
2.
Remove the top cover as shown in Fig. 2.
Note: Take care not to damage the speaker cable.
Fig. 2
Dieses Handbuch passt für folgende Modelle
3
Inhaltsverzeichnis
Andere Sharp Projektor Handbücher
Sharp
Sharp Notevision PG-C45S Bedienungsanleitung
Sharp
Sharp PGF310X - Notevision XGA DLP Projector Bedienungsanleitung
Sharp
Sharp XR-20X - Notevision XGA DLP Projector Bedienungsanleitung
Sharp
Sharp Notevision XG-C335X Bedienungsanleitung
Sharp
Sharp PG-A10X - Notevision XGA LCD Projector Bedienungsanleitung
Sharp
Sharp XG-P25X - Conference Series XGA LCD... Bedienungsanleitung
Sharp
Sharp XG-NV6XE Bedienungsanleitung
Sharp
Sharp XV-C100A Bedienungsanleitung
Sharp
Sharp PG-M20XU Bedienungsanleitung
Sharp
Sharp PG-F320W - Notevision WXGA DLP Projector Benutzerhandbuch
Sharp
Sharp Notevision PG-B10S Bedienungsanleitung
Sharp
Sharp Notevision PG-M25X Bedienungsanleitung
Sharp
Sharp PG-D2500X Bedienungsanleitung
Sharp
Sharp Notevision XR-50S Bedienungsanleitung
Sharp
Sharp DT-100 Bedienungsanleitung
Sharp
Sharp Notevision PG-M17X Bedienungsanleitung
Sharp
Sharp Notevision PG-C20XA Bedienungsanleitung
Sharp
Sharp XG-PH70X - XGA DLP Projector Benutzerhandbuch
Sharp
Sharp XV-Z90E Bedienungsanleitung
Sharp
Sharp XV-Z10000 Bedienungsanleitung
Beliebte Projektor Handbücher anderer Marken
Panasonic
Panasonic PTL735NTU - LCD PROJECTOR-NETWORK IB Bedienungsanleitung
NEC
NEC NP600S EDU Bedienungsanleitung
BenQ
BenQ SH753P Bedienungsanleitung
Eiki
Eiki EK-623U series Bedienungsanleitung
Epson
Epson PowerLite Pro Cinema 6020UB Bedienungsanleitung
Epson
Epson PowerLite Home Cinema 705HD Bedienungsanleitung
