7
USING BLENDER:
Assembly:
This appliance is equipped with a safety system. It will not work unless all
the parts have been mounted correctly. Place the Blender assembly over the
Main Power Base.
Usage:
IMPORTANT: Do not operate the juicer or blender for more than
1 minute continuously per use and allow the unit to cool between
use, otherwise unit will overheat and burn out its fuse, damaging
unit permanently.
1. If previously used Juicer, bring both Safety Locking Bars down. Remove
the Pusher, Lid, Blade/Filter and Bowl assembly.
2. See Diagrams on right. Keep front Lock Bar UP while placing blender
Base onto Main Power Unit. Make sure Blender Base is secured before
lowering the Locking Bar. Lower front Locking Bar to interlock with small
protrusion on Blender Base (should go inside Locking Bar).
3. Place already cut up fruits or vegetables, add desired amount of liquid. Make sure overall amount
within
minimum 8 oz/250 ml and maximum 60 oz/1800ml capacity, marked on the Blender container.
Add ice, if using.
4. Insert the plug into the power outlet. Move the Power Dial to P (Pulse) the first 3-4 times to mix the
ingredients. Then turn to 1 (Low Speed) or 2 (High Speed) depending on your preference. If only crushing
ice, use P (pulse) setting.
5. Vented lid can be removed to add extra ingredients or liquid. IMPORTANT: Always make sure the unit is completely
turned off before removing lid, and the lid completely seals the canister before turning on the unit.
6. Vented cover can be removed to add small ingredients or liquid and used as a measuring cup. Just turn it counterclockwise
and pull up to remove from lid. Align the small protrusion on cover with groove inside the lid, then push down and turn clockwise
to secure back onto lid. IMPORTANT: Always make sure unit is off when removing and securing vent cover.
USING JUICER:
Assembly:
Assemble Juicer, use previous page as a guide. This appliance is equipped with a safety system. It will not work unless
all the parts have been mounted correctly.
1. Place the Large Capacity Bowl on the Main Power Base.
2. Place the Removable Pulp Container into the appliance by tilting it slightly forward and pushing into position.
For easier clean-up, you may place a plastic bag inside the Removable Pulp Container.
3. Put the Stainless Steel Blade/Filter in the appliance, ensure it locks into place.
4. Lower the Lid into position.
5. Bring both Safety Locking Bars UP to secure the assembly, they will click when correctly placed.
6. Slide the Pusher into the Feeder by aligning the groove in the pusher with the small protrusion on the inside of the Feeder.
Usage:
IMPORTANT: Do not operate the juicer or blender for more than 1 minute continuously per use and allow the unit to
cool between use, otherwise unit will overheat and burn out its fuse, damaging unit permanently.
CAUTION: NEVER INSERT YOUR FINGERS OR ANY OTHER OBJECT INTO THE FEEDING TUBE.
1. Wash the fruit or vegetables and cut them into pieces small enough to fit it through the feeding tube.
CAUTION: To prevent damage to the appliance, when using large carrots or any other large hard fruit or
vegetable, always cut lengthwise in half to reduce the thickness of the vegetable/fruit.
2. Once all the parts are assembled, insert the plug into the power outlet. Make sure to place a container under the
spout of the Juicer to collect the juice.
3. Move the power dial and the motor will start running. Push the precut food pieces in the feeding tube and gently push them down
towards the rotating filter using the pusher supplied. NOTE: To achieve the best juicing results, do not press Pusher down too fast.
ATTENTION: While the juicer is in operation, DO NOT place hands or any other foreign object into the Feeder.
4. When the juice flow has stopped, switch the appliance off and wait until the filter has stopped rotating.
5. After each juicing session, always rinse out the Lid and clean the Stainless Steel Blade/Filter so the food particles do
not dry on its surface and the filter doesn’t get clogged. Empty out the Removable Pulp Container.
USAGE-BLENDER / CLEANINGUSAGE-JUICER
(Refer to p. 6 for Parts Identification)
8
