Assembly Instructions
Figure 1
Figure 2
Figure 4
STEP 2
Connecting End frame (#2) to
Bottom Frame (#1).
Lay assembly on the floor as shown in
Figure 1, Slide End Frame (#2) thru the
end bracket welded at the end of Bottom
frame ((#1), secure them with 2 Hex bolts
(#7), 2 Washers (#8) and 2 Lock nuts (#9)
for End frame.
See figure 2 and Detail B.
Repeat this step for the other side.
STEP 1
Connecting Bottom Support Frame together
using 2 Bottom support bracket (#5), 2 Mounting plate
(#6), 8 Hex bolts (#12), 8 Washers (#13), and 8 Lock
nuts (#14). See Figure 1 and Detail A.
5
6
12
13
1
1
14
Detail A
1
1
1
1
7
7
88
9
1
1
1
1
1
1
2
2
Rope
C
Detail B
B
D
Detail D
Detail C
STEP 3
Connecting Slant tube ((#3) to End Frame
(#2).
connect the bottom of Slant tube (#3) to Base
frame (#1) using 4 Hex bolts (#11), 4 Washers
(#13), and 4 Lock nuts (#14). See Detail D.
Tighten all the bolts and nuts.
Place Brace (#4) inside Slant Tube (#3),
and place Slant tube (#3) inside Brace (#4),
Connect them together using 4 Hex bolts (#10),
4 washers (#13) and 4 Lock nuts (#14).
See Detail C.
Tie one Rope(#15) to End frames (#2),rest Rope
on attached Bolts at the top of End frame (#2).
10
13
14
3
4
2
14
13 3
11
1
Figure 3
page 2
#23108/#23110 instructions
10 10 Rev 300 1-.-
STEP 4
Tie Rope(#15) to Side tubes in the front only
(#2),This will make the snow and rain slide off
easy and makes the cover look better on the log
rack.
