
Step #5—Plugging in the Blower Motor
The plug from the blower motor should be plugged into
the power strip mounted on the underside of the table.
The plug from the power strip should then be plugged
into a standard 110/120 volt wall socket. Turn power on
and off using the power switch located on the side of
the table.
Step #2—Attach the Legs
Install the right and left legs using four carriage bolts
per leg. Fasten the leg bolts using a washer and nut.
Tighten until bolt heads are snug with the table surface.
Over tightening could damage the side walls.
G5
© Copyright 2001-2005, Shelti Inc., Bay City • Michigan SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
333 Morton Street
Bay City, Michigan 48706
Phone: 989-893-1739
Fax: 989-893-1809
www.shelti.com
Member of:
Step #6—Attach the Electronic Scoring Unit
Remove the three plastic caps located on the side of the
table. Thread the two wires from the infrared sensors
through the bigger hole. The AC adapter should plug in
to the power strip attached to the bottom of the table.
Thread the smaller end through the same hole as the
other wires. Plug all three wires into the scoring unit
as shown. If scored goals credit the wrong team, simply
switch the two identical wires as they were plugged into
the wrong position.
Line up the holes of the scoring unit with the smaller
holes on the side rail. Fasten with a bolt in each hole
with a Philips head screw driver.
Step #3—Attach the Manual Scoring Units
Carefully flip the table over. Install the two scoring units
using the phillips head bolts, score posts, score rods, and
score beads. These scoring units should be assembled
and installed in the pre-drilled holes located on the top
rail.
Step #7—Operating the Scoring Unit
Turn the power switch to “on”. Select desired game op-
tion. By default, it begins with the 15 minute game op-
tion. To change the game option, push the “select” but-
ton. There are seven total options including “Free play”
which has no time limit or scoring limit. After choosing
a game option, push the “Start” button to begin. To
start over, press the” Reset / Start” button again. The
volume switch has three settings: High, Low and Off.
Step #4—Level the Table
Level the air hockey game by placing a
level across, lengthwise, and diagonally into the four
corners and raise or lower the appropriate leg leveler.