2 6' aluminum bunks
2 6' bunk covers Insert 3/8" x 1 1/4" bolts into trac on top of lifting bed.
8 bunk brackets Place bunk brackets over bolts and start nuts on them.
8 3/8" x 1 1/4" hex head bolts Measure frame side for bunk placement, place bunks
8 3/8" brass nylock between brackets and insert 5/16" x 3" thru predrilled
8 3/8" washers holes in the bunk. Make sure the heads of the bolts
4 5/16" x 3" machine bolts are on the inside of the lift. Slide covers over the bunks
4 5/16" brass nylock and attach w/ 12 x 3/4" s.s. screws.
8 5/16" washer
32 12 x 3/4" s.s. screws
1200# PWC LIFT HARDWARE
LEG KIT WINCH & WHEEL KIT
2 welded side frames 1 1200# D/L winch
4 12" legs 1 19 X 7 s.s. 3/16 cable, 15'
8 3/8" x 1" hex head bolt 2 3/8" x 2 3/4" hex head bolt
8 3/8" square galv. Nut 2 3/8" brass nylock
2 2" x 2" caps 4 3/8" washer
CROSS BAR KIT 1 24" winch wheel
2 62" cross bar 1 5/16" x 2 machine bolt
8 3/8" x 2 1/2" hex head bolt 8 5/16 washers
4 3/8" x 1 1/ 4" hex head bolt 1 5/16 X 1 fender washer
12 3/8" brass nylock 1 spring in winch box
20 3/8" flat washer 1 spacer in winch box
FRONT BRACE KIT 1 spinner konb w/ jam nut
2 2" x 1" x 36" angle brace
4 3/8" x 2 3/4" hex head bolts 2 6' aluminum bunks
4 3/8" brass nylock 2 6' bunk covers
8 3/8" washer 8 bunk brackets
LIFTING ARM KIT 8 3/8" x 1 1/4" hex head bolts
8 white 1/2" bushings 8 3/8" brass nylock
4 1/2" x 4" hex head bolt ( bottom lifting legs ) 8 3/8" washers
4 1/2" x 5" hex head bolt ( top lifting legs ) 4 5/16" x 3" machine bolts
8 1/2" brass nylock 4 5/16" brass nylock
16 1/2" washer 8 5/16" washer
PULLEY KIT 32 12 x 3/4" s.s. screws
2 pulley block w/ 2 links
1 pulley block w/ 3 links
4 3/8" x 3" hex head bolt
4 3/8" brass nylock
12 3/8" washer
R J INDUSTRIES
SHORESIDEDOCKS.COM
