Siemens Signia easyTek Administratorhandbuch

easyTek®how-to guide

For primax hearing instruments

signiausa.com/easytek

Bluetooth®Power Battery

➊Multi-function button

➌Neckloop (antenna)

➍Built-in mic

➎Micro-USB

➏Reset

➐FM input

➑Port for audio

devices

➒Volume

up/down

easyTek

➊Multi‑function button

➋LED status indicator (orange, green, blue)

➌Neckloop (acts as the antenna)

➍Microphone openings

➎USB port for charging

➏Reset button

➐Port for FMreceiver

➑Port for audio devices (standard 3.5mm audio jack)

➒Volume buttons 

➋LED status indicators:

Wearing easyTek properly

In order to function correctly, the easyTek must be worn with the

neckloop around the neck. The neckloop is also the antenna.

uUnplug one neckloop plug and place the neckloop loosely around

your neck ➊.

uInsert both neckloop plugs all the way ➋.

Turning easyTek on/o

uTo power on: press until the green LED turns on.

This takes approximately 2 seconds

uTo power o: press until the green LED fades o.

This takes approximately 2 seconds.

easyTek out of the box pairing

The hearing instruments must be paired with the easyTek. After

the pairing process is completed, the connection is automatically

established when the hearing instruments and easyTek are turned on.

Pairing

uOpen battery doors of hearing instruments. Place easyTek around

neck with neckloop. easyTek should be “o”.

uPress Multi-Function Button (MFB) on easyTek until green LED

is ﬂashing

૝૝

૜

uWhile green LED is ﬂashing , close battery door of hearing

instruments

uPairing is complete when green LED stops ﬂashing (audible alert) –

easyTek is ready to use

Note with initial activation only: Blue light will now ﬂash to

allow for pairing of Bluetooth phone. If phone is not present, press

MFB to stop blue light ﬂashing and end pairing search.

Pairing Siemens transmitters

Before ﬁrst use

• Charge transmitter before ﬁrst use by connecting the transmitter

with the power plug to a power supply.

• The LED shines red while charging.

• Charging time is about 5 hours.

• Make sure that a hearing aid that has been paired is turned on.

• Every Siemens transmitter must be paired once with easyTek.

You can use up to two Siemens transmitters.

uTurn on easyTek and Siemens transmitters.

uPress MFB , and simultaneously for about 5 seconds;

and LED’s ﬂash

ueasyTek LED ﬂashing, then “on” – transmitter LED ﬂashing, then

solid blue . Your easyTek has been paired to the transmitter.

Remote control functions

uVolume changes: Press or <1 second to adjust step

by step or press and hold until desired volume is reached.

uHearing program changes: Press and release 1-2 seconds until

desired program is reached. (This function is not available during

audio streaming, for example when you are using easyTek to listen

to the TV or to music through your MP3 player.)

uTurn on/o (standby): Press and simultaneously

for >3 seconds. easyTek will then turn o.

Audio streaming functions

uTo begin streaming for:

•Bluetooth audio devices: Turn Bluetooth connection on device.

Select ‘play’ on the audio device.

•For standard line-in devices: Plug in the device to the audio line-in

port of easyTek. Select ‘play’ on the audio device.

•For FM: Plug in the FM receiver to the FM input port of the easyTek.

Turn on the FM transmitter.

•For Siemens transmitters: Double-press .

uTo change volume: Press for volume up or for volume

down.

uTo mute hearing instrument microphones: Press and

simultaneously for <1 second.

uTo stop audio streaming: Press for 1-2 seconds until blue LED

turns o.

uTo toggle between two Siemens transmitters: Double press .

Using easyTek with cell

and landline phones

easyTek allows the hearing instruments to act as a wireless headset

when using a Bluetooth technology-enabled phone.

The easyTek microphones convey wearers voice to the other party.

Pairing

Bluetooth

devices

uTurn on Bluetooth device and easyTek

uPress MFB and simultaneously for about 5 seconds

blue LED ﬂashes

uUse Bluetooth device to search for other Bluetooth devices –

select easyTek

uPairing is complete when LED turns solid blue , then turns

o – easyTek is now ready for audio streaming

Further information:

Accept /

end call Press for 1-2 seconds

Alternative: Use phone's accept/end function.

■Incoming calls:

□Hearing instrument plays a ring tone and blue LED ﬂashes.

□easyTek cannot be turned o during a phone call.

■Outgoing calls:

Hearing instruments automatically connect with phone

when placing a call.

Some phones do not support this function. In this case:

□Stop or disconnect all other audio devices.

□Press and together brieﬂy to establish the

connection manually.

Reject a call Press >3 seconds

Alternative: Use your phone's reject function.

This function is not supported by all phones.

Volume or

Press to increase volume; to decrease

volume.

Sound mixer and

Press both buttons simultaneously to switch

between the following input signals:

■Caller’s voice and hearing instrument microphone

– you hear both the call and ambient noise

■Caller's voice only – the ambient noise is turned o

Transfer call double-press

■Transfers phone call from easyTek to the phone –

conversation comes through the phone

■From the phone to the easyTek – for hands free

conversation using easyTek and the hearing aid

Audio streaming

mp3

Connect the audio device with easyTek – directly or wirelessly.

easyTek wirelessly transmits (streams) the audio signal to your hearing

instruments.

The audio signal is streamed through the hearing instruments turning

the hearing instruments into a personal headset.

Supported devices

The following devices can be connected:

Bluetooth-enabled phones (up to two).

Bluetooth audio devices, such as tablet,PC, stereo, etc.

Audio devices (with standard 3.5mm audio jack).

Siemens transmitters (up to two). Enable wireless audio

streaming for devices that do not support Bluetooth.

FMreceiver. Enables use of FM system even if hearing

instruments do not have audio input.

Connecting easyTek

transmitter to your television

Transmitter 2.5mm to 3.5mm

Stereo Plug

Transmitter

RCA Stereo Plugs

Use the RCA adapters with the

analog outputs on your TV,

cable to satellite dish console,

or A/V receiver to connect the

transmitter.

If needed, a digital-to-analog

converter can be purchased.

Using the Transmitter

Off

Sound level

Transmitter

Aux in

Power

૜

૝

૞

૟

ૠ

➊On/o switch

➊Sound level

➊Socket for power plug

➊2.5 mm stereo socket

➊LED

easyTek App

easyTek App.

Turn your smartphone into an easyTek

control center.

The easyTek App™ provides

convenient operation of the

the hearing instruments via an

Android smartphone, iPhone,

or tablet.

Whether watching TV,

listening to a favorite song,

or talking to a friend on the

phone – control is right at

your ﬁngertip.

Prerequisites for using the

app:

■The easyTek app works

with the easyTek.

■The smartphone/tablet

must be within Bluetooth

operating range

approximately 32 ft (10 m).

Prerequisites for download

and installation:

■Smartphone or tablet must

have access to the Internet.

■Create or use established

account for the Google

Play Store (Android

smartphone/tablet) or for

the App Store

(iPhone or iPad).

Inhaltsverzeichnis

Andere Siemens Hörgerät Handbücher

Siemens

Siemens PRISMA 2 K Bedienungsanleitung

Siemens

Siemens Pure Bedienungsanleitung

Siemens

Siemens REFLEX DP Bedienungsanleitung

Siemens

Siemens BestSound Ace micon Bedienungsanleitung

Siemens

Siemens Vibe Bedienungsanleitung

Siemens

Siemens CIELO Bedienungsanleitung

Siemens

Siemens Pure Binax Bedienungsanleitung

Siemens

Siemens miniTek Bedienungsanleitung

Siemens

Siemens BTE Bedienungsanleitung

Siemens

Siemens ePen Bedienungsanleitung

Siemens

Siemens MUSIC Pro Bedienungsanleitung

Siemens

Siemens P Bedienungsanleitung

Siemens

Siemens BTE series Bedienungsanleitung

Siemens

Siemens Pure Binax Bedienungsanleitung

Siemens

Siemens eCharger Bedienungsanleitung

Siemens

Siemens Orion RIC Bedienungsanleitung

Siemens

Siemens INFINITI Pro Bedienungsanleitung

Siemens

Siemens INTUIS Bedienungsanleitung

Siemens

Siemens Orion SP Bedienungsanleitung

Siemens

Siemens Motion 701 BTE Bedienungsanleitung

Siemens

Siemens ConnexxLink Bedienungsanleitung

Siemens

Siemens artis Bedienungsanleitung

Siemens

Siemens Aquaris 701 BTE Bedienungsanleitung

Siemens

Siemens Octiv Custom+ Bedienungsanleitung

Beliebte Hörgerät Handbücher anderer Marken

Sonic

Sonic Bliss miniBTE Bedienungsanleitung

Lexie

Lexie B1 Stücklistenhandbuch

Widex

Widex FM+DEX Bedienungsanleitung

Camplicomms

Camplicomms HC-200 Bedienungsanleitung

Widex

Widex SUPER 220 S2-VSD Bedienungsanleitung

Phonak

Phonak Q90 Bedienungsanleitung

Williams Sound

Williams Sound SoundPlus WIR 237 Leitfaden

Oticon Medical

Oticon Medical Ponto SoundConnector Bedienungsanleitung

Starkey

Starkey Destiny Bedienungsanleitung

Audicus

Audicus The Icon Bedienungsanleitung

Advanced Bionics

Advanced Bionics Slim HP Standard Bedienungsanleitung

Widex

Widex DREAM440 THE DREAM SERIES Bedienungsanleitung

Phonak

Phonak myPilot Bedienungsanleitung

NIKEN

NIKEN NK-401 Bedienungsanleitung

ON Semiconductor

ON Semiconductor Ezairo 7111 Pre Suite Bedienungsanleitung

Sonetik

Sonetik GOHEAR Bedienungsanleitung

Widex

Widex FL-9 Bedienungsanleitung

Panasonic

Panasonic WH-216KZ Montageanleitung

Siemens signia easyTek Administratorhandbuch

Beliebte Hörgerät Handbücher anderer Marken