Siemens D1085-A Bedienungsanleitung

Additional Technical Manual

A26361-D1085-Z180-2-7619 Page 1

Introduction

This technical manual applies for the mainboard D1085. This system board is available in different

configuration levels. Depending on the hardware configuration of your device, it may be that you

cannot find several options in your version of the system board, even though they are described.

Further information e. g. the complete Technical Manual for the D1085 and the Reference Manual

for the BIOS Setup are provided on the "Drivers & Utility" CD. For detailed information please

look at chapter 3.

1 Features

Function Version Version

D1085-A D1085-E

Processor Intel PentiumII,

233 - 333 MHz

Intel Celeron

Intel PentiumII,

233 - 333 MHz

Intel Celeron

Chipset Intel 440LX Intel 440EX

AGP connector X X

Wake on LAN (WOL) connector X -

USB X X

IrDA connector X -

Chipcard reader X -

Keyboard on X -

BIOS Fax - -

Quiet Boot X X

DMI X X

Systemmonitoring X -

DIMM 3 2

Memory ECC Support X -

FAX On - -

PCI Slots* 4 4

ISA Slots* 3 3

* = 1 PCI/ISA slot is shared

2 Mechanics

!Computer mainboards and components contain very delicate IC chips. To protect

them against damage caused from electric static, you have to follow some

precautions:

• Unplug your computer when you work inside.

• Hold components by the edge, don’t touch their leads.

• Use a grounded wrist strap.

Place the mainboard and the components on a grounded antistatic pad whenever

you work outside the computer.

Once you have installed the system board, you should remove the battery

protection (i.e. the thin plastic plate between battery and contact spring).

Additional Technical Manual

Page 2 A26361-D1085-Z180-2-7619

2.1 Layout

ATX 12’’ x 7,3’’ (305 mm x 185,4 mm)

Some of the following connectors are optional and may therefore not be included on your

mainboard.

ISA 1

ISA 3

ISA 2

PCI 2

PCI 1

PCI 3

PCI 4

3 2 1

45 6

1 = Serial port 2

2 = Serial port 1

3 = PS/2 mouse port

4 = PS/2 keyboard port

5 = Parallel port

6 = USB ports

Additional Technical Manual

A26361-D1085-Z180-2-7619 Page 3

ISA 1

ISA 3

ISA 2

PCI 2

PCI 1

PCI 3

PCI 4

3 2 1

1 = System fan

2 = Chipcard reader

3 = Power supply

4 = Infrared receiver (IrDA)

5 = Cover detection

6 = Power supply monitor

7 = IDE drives 3 and 4 (secondary)

8 = IDE drives 1 and 2 (primary)

9 = Floppy disk drive

10 = Processor fan

11 = Control panel

12 = Intrusion plug

13 = Power On

14 = Wake-up on LAN

The connectors marked do not have to be present on the system board.

Additional Technical Manual

Page 4 A26361-D1085-Z180-2-7619

2.2 Assembling Slot 1

iBefore inserting the CPU, you have to assembly the including stabilisators. Please be

carefully to avoid a damage of the mainboard.

2.3 Connectors, DIP-Switch, Jumpers

!Some of the following connectors are optional!

2.3.1 Power supply ATX connector

Pin Signal Pin Signal

11 + 3.3V 1 + 3.3V

12 - 12V 2 + 3.3V

13 GND 3 GND

14 PS on (low

asserted) 4 + 5V

15 GND 5 GND

16 GND 6 + 5V

17 GND 7 GND

18 - 5V 8 Powergood (high

asserted)

19 + 5V 9 + 5V SB

20 + 5V 10 + 12V

2.3.2 Power control connector

Pin Signal

1 Monitor on

2 SV FAN off request (low asserted)

3 SV FAN full on (low asserted)

4 SV FAN pulse

5 SMB CLK

6 SMB DATA

7 VCC EEPROM

8 GND

Pin 1Pin 11

Pin 1

Additional Technical Manual

A26361-D1085-Z180-2-7619 Page 5

2.3.3 Power on switch connector

Pin Signal

1 GND

2 Power on pulse (low asserted)

2.3.4 Wake on LAN (WOL) connector (stuffing option)

Pin Signal

1 + 5 V SB

2 GND

3 Wake pulse (high asserted)

2.3.5 CPU-FAN connector

Pin Signal

1 GND

2 FAN power supply

3 FAN sense

2.3.6 Internal serial port 1 for chip card reader

Pin Signal Pin Signal

1 DCD 2 (low asserted) 2 DSR 2 (low asserted)

3 SIN 2 (high asserted) 4 RTS 2 (low asserted)

5 SOUT 2 (high asserted) 6 CTS 2 (low asserted)

7 DTR 2 (low asserted) 8 PC_ON_Strobe

9 GND 10 VCC SB

11 12 VCC

13 RESETDRV

(high asserted) 14 GND

15 GND 16 Key

Pin 1

Pin 1 Pin 2

Pin 1

Additional Technical Manual

Page 6 A26361-D1085-Z180-2-7619

2.2.7 Internal infrared (IrDA) connector

Pin Signal

1 VCCHELP

2 Key

3 IRDA_RX

4 GND

5 IRDA_TX

2.2.8 Internal speaker connector

Pin Signal

1 VCC

2 GND

3 Key

4 Speaker output

2.3.9 System management SM-BUS

Pin Signal

1 VCC

2 SM Clock

3SM Data

4 GND

Pin 1

Additional Technical Manual

A26361-D1085-Z180-2-7619 Page 7

2.3.10Front panel connector 1

Pin Signal Pin Signal

1 Boot Lock

(high asserted) 2 Speaker

3 Stand By LED

(high asserted) 4 Key

5 Key 6 GND

7 Power On LED

(high asserted) 8 VCC

9 Speaker 10 Key Pin

11 Power On &

Stand By LED

(low asserted)

12 Key

13 Message LED

(high asserted) 14 Key

15 Message LED

(low asserted) 16 Key Pin

17 Key 18 Key

19 VCC 20 Key

21 HD LED

(low asserted) 22 Key

23 Sleep Button

(low asserted) 24 Not connected

25 Power Button

(low asserted) 26 SCSI LED

(low asserted)

27 Sleep Button

(low asserted) 28 SCSI LED

(low asserted)

29 Reset Button

(low asserted) 30 Not connected

Pin 1 Pin 2

Additional Technical Manual

Page 8 A26361-D1085-Z180-2-7619

2.3.11PCI-IDE Connector

Pin Signal Pin Signal

1 Reset Drive 2 GND

3 Data 7 4 Data 8

5 Data 6 6 Data 9

7 Data 5 8 Data 10

9 Data 4 10 Data 11

11 Data 3 12 Data 12

13 Data 2 14 Data 13

15 Data 1 16 Data 14

17 Data 0 18 Data 15

19 GND 20 Key

21 DRQ 22 GND

23 I/O Write 24 GND

25 I/O Read 26 GND

27 IORDY 28 N.C.

29 DACK 30 GND

31 IRQ 32 N.C.

33 ADR 1 34 N.C.

35 ADR 0 36 ADR 2

37 Chip Select 1 38 Chip Select 3

39 IDE-LED 40 GND

2.3.12AUX Audio IN Connector (e. g. MPEG, TV-Cards)

Pin Signal

1 GND

2 MPEG Audio In LEFT

3 GND

4 MPEG Audio In RIGHT

Pin 1

Additional Technical Manual

A26361-D1085-Z180-2-7619 Page 9

2.3.13Infrared Connector

Pin Signal

1 VCC

2 key

3 IRDA_RX

4 GND

5 IRDA_TX

2.3.14Front Panel Connector 1

Pin Signal

1 Boot Lock

2 + Standby LED

3 Key

4 + Power LED

5 Key

6 - Standby/ Power LED

7 Keylock

8 GND

9 Key

10 + HD LED

11 HD LED

12 HD LED

Pin 1

Additional Technical Manual

Page 10 A26361-D1085-Z180-2-7619

2.3.15Configuration SWITCH-Block (DIP-Switch)

For Frequency selection, Reserved, Password clear, Recovery and Floppy write.

Function SW1

SKP SW2

RCV SW3

FWP SW4

RES SW5

CF1 SW6

CF2 SW7

CF3 SW8

CF4

Password Skip On x x x x x x x

Off Off x x x x x x x

Recovery BIOS x On x x x x x x

Off x Off x x x x x x

Floppy Write Protect x x On x x x x x

Off x x Off x x x x x

Reserved x x x On x x x x

Reserved x x x Off x x x x

Recovering System BIOS - switch 2

Switch 2 enables recovery of the old system BIOS after an attempt to update has failed. To restore

the old system BIOS you need a Flash BIOS Diskette (call customer service).

on The System BIOS executes from floppy drive A: and restores the System BIOS on

the system board.

off The System BIOS is started from the system board (default setting).

Write protection for floppy disks - switch 3

Switch 3 is used to define whether floppy disks can be written or deleted in the floppy disk drive. To

write and delete floppy disks, the write -protection in BIOS setup must be disabled (in menu Security,

the field Diskette Write must be set to Enabled).

on The floppy disk drive is write-protected.

off Read, write and delete floppy disks is possible (default setting).

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Siemens Hauptplatine Handbücher

Siemens

Siemens RWB29 Bedienungsanleitung

Siemens

Siemens D992 Bedienungsanleitung

Siemens

Siemens SIMATIC Field PG M5 Bedienungsanleitung

Siemens

Siemens SIMATIC PG 720 Bedienungsanleitung

Siemens

Siemens SIMATIC Field PG M6 Bedienungsanleitung

Siemens

Siemens SIMATIC PG 760 PII Handbuch

Siemens

Siemens Simatic Field PG Bedienungsanleitung

Siemens

Siemens SIMATIC PG 760 Bedienungsanleitung

Siemens

Siemens D981 Bedienungsanleitung

Siemens

Siemens D1107 Bedienungsanleitung

Siemens

Siemens Simatic PG 740 Bedienungsanleitung

Siemens

Siemens SIMATIC VPU200/560 Betriebsanleitung

Siemens

Siemens DPU Bedienungsanleitung

Siemens

Siemens ERTEC EB 200 Bedienungsanleitung

Siemens

Siemens Simatic PG 740 PIII Bedienungsanleitung

Siemens

Siemens SIMATIC PG 720 P Bedienungsanleitung

Siemens

Siemens SIMATIC EB 200P-3 Technisches Dokument

Siemens

Siemens FPI-32 Bedienungsanleitung

Siemens

Siemens 7LF4941-0 Bedienungsanleitung

Siemens

Siemens MMB-3 Bedienungsanleitung

Siemens

Siemens RWB29Si Bedienungsanleitung

Siemens

Siemens ET 200 Bedienungsanleitung

Siemens

Siemens SITRANS 7ML1930-1BK Administratorhandbuch

Beliebte Hauptplatine Handbücher anderer Marken

DFI

DFI SD170 Bedienungsanleitung

ASROCK

ASROCK ROMED8-2T Bedienungsanleitung

Asus

Asus P2L97A Bedienungsanleitung

Winmate

Winmate IC70 Bedienungsanleitung

Asus

Asus MES-B Bedienungsanleitung

Grantech

Grantech SYS8F377VGGA-3OMN Bedienungsanleitung

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Bedienungsanleitung

Texas Instruments

Texas Instruments ADS8372EVM Bedienungsanleitung

Commell

Commell MS-C73 Bedienungsanleitung

Gigabyte

Gigabyte GA-9IVDT Bedienungsanleitung

IBT Technologies

IBT Technologies MB860 Bedienungsanleitung

Nvidia

Nvidia TEGRA DG-04927-001_V01 Bedienungsanleitung

Intel

Intel D33217CK Bedienungsanleitung

Asus

Asus F1A55-M LX PLUS R2.0 Bedienungsanleitung

EPC

EPC EPC9147C Bedienungsanleitung

Asus

Asus EX-B760M-V5 D4 Bedienungsanleitung

EPOX

EPOX MU-8KHA0010 Bedienungsanleitung

Ski-Doo

Ski-Doo Bombardier MPEM 219 700 090 Bedienungsanleitung