Silent Gliss 3000 Bedienungsanleitung

2. Cleat 3. Tie cord

to itself

4. Cord tidy

(Silent Gliss

part No. 3799)

1. Clothes peg

or bulldog

clip

WARNING Parents should realise that children could accidentally strangle in window blind

cords. Keep the cords out of the reach of children using one of these devices.

Silent Gliss®

3000 Cord Drawn Curtain Track

Fitting Instructions

Firmly screw 3630 brackets to

wall or ceiling. The two outside

brackets should be located

12.5cm (5”) in from the ends

of track to provide stability.

Remaining brackets should be

equally spaced along track

(approx. every 60cm/2’).

Screw for wall or

ceiling with

universal bracket.

To install track

simply locate as

shown and press

onto bracket in

direction

indicated. Removal: Push upwards

and forwards.

3EXTRA SUPPORT FOR CORD DROP

It is often desirable when the track is wall-fixed to make an extra fixing point over the end

where the cord is pulled to give greater rigidity. A special tubular spacer and 11/2” No. 8 screw

are supplied with all systems pre-packed by Silent Gliss.

P. T. O. These instructions are continued on reverse side.

TRIMMING AND/OR ADJUSTING INSTRUCTIONS

If it is necessary to shorten your 3000 curtain track follow all instructions (1-8 overleaf) for

pair stacking. For single stacking follow steps 1, 2, 4, 5, 6 & 7 only. To adjust the point where

the curtains meet, follow steps 3 and 8 only. If cord drop is required at opposite ends to that

supplied, simply follow step 3, pull cord through and the follow step 8.

1. Unscrew

nylon cover.

2. Drill hole in wall

directly behind the ‘X’,

insert screw through hole

and spacer and screw

firmly into position.

Replace nylon cover.

3000

Where the track is slotted to allow insertion of

extra gliders without removing end pieces,

remove spingstops and insert gliders equally

at each side, replace springstops.

1. Place track face down on bench or floor

and operate to take gliders to centre.

2. Slacken screws and pull end piece free.

3. Carefully prise out cord retaining pin

from visible pilot runner.

4. Measure amount to be trimmed off

exposed end of track and mark. Where the

track is slotted the slot will no longer be

usable. Discard springstops.

5. Pull cords through

into glider channel and

clear of cutting point.

6. Cut track squarely with

junior hacksaw and carefully

de-burr with sharp knife or

small file, paying particular

attention to ends of cord

channels.

7. Pull cords back into cord

channels and check that they

operate freely – replace end

piece.

8. Move both pilot runners to

the extreme ends of the track

(i.e. in a fully open position) –

hold cords in tension and

press fully home cord

retaining pin into pilot runner.

(The pin must go through

cord and if inserted correctly

a ‘click’ will be heard.)

Two gliders plus overlap or, if

no overlap fitted, four gliders

should remain between pilot

runners.

Extras/Accessories (not supplied)

Two lengths of 3000 can be joined with a 3620

connecting bridge. Fixed or adjustable extension

brackets are also available to enable you to use

your 3000 track with a second Silent Gliss track to

hold nets, etc. Ask your dealer. 3000 can be bent

to order for bay windows, etc. from your stockist.

THIS TRACK CANNOT

BE BENT AT HOME.

Silent Gliss Limited

Star Lane, Margate, Kent CT9 4EF, England

Telephone: 01843 863571 Fax: 01843 864503

E-mail: [email protected] www.silentgliss.co.uk

12/02

Inhaltsverzeichnis

Andere Silent Gliss Jalousie Handbücher

Silent Gliss

Silent Gliss SG 2345 Bedienungsanleitung

Silent Gliss

Silent Gliss SG 1014 Bedienungsanleitung

Silent Gliss

Silent Gliss 2350 Bedienungsanleitung

Silent Gliss

Silent Gliss SG 3000 Bedienungsanleitung

Silent Gliss

Silent Gliss SG 6035 Bedienungsanleitung

Silent Gliss

Silent Gliss 4907 Bedienungsanleitung

Silent Gliss

Silent Gliss SG 1011 Bedienungsanleitung

Silent Gliss

Silent Gliss Silent Gliss 7630 Bedienungsanleitung

Silent Gliss

Silent Gliss SG 1032 Bedienungsanleitung

Silent Gliss

Silent Gliss SG 1012 Bedienungsanleitung

Silent Gliss

Silent Gliss 5100 Autoglide Bedienungsanleitung

Silent Gliss

Silent Gliss DUETTE Installationsanleitung

Silent Gliss

Silent Gliss 5100 Autoglide Bedienungsanleitung

Silent Gliss

Silent Gliss 2304 Bedienungsanleitung

Silent Gliss

Silent Gliss SG 1060 Bedienungsanleitung

Silent Gliss

Silent Gliss SG 5100 Bedienungsanleitung

Beliebte Jalousie Handbücher anderer Marken

Jysk

Jysk ROGEN Bedienungsanleitung

SOMFY

SOMFY 1241752 Bedienungsanleitung

Rollos

Rollos S-Nanorollo V2 Planungshandbuch

Teptron

Teptron Move Bedienungsanleitung

Renson

Renson Outdoor Loggia Sicherheitsleitfaden

Project Source

Project Source CDLF2342W Bedienungsanleitung

Domondo

Domondo PureNight Installationsanleitung

rollease acmeda

rollease acmeda Easy Spring Air Einrichtungshandbuch

IKEA

IKEA KADRILJ Bedienungsanleitung

Hallis Hudson

Hallis Hudson Rolls Super glide Bedienungsanleitung

Benthin

Benthin P1614 Bedienungsanleitung

MV LINE

MV LINE CLARA 015 Bedienungsanleitung

Current

Current E-WAND Leitfaden

weinor

weinor VertiTex ZipR Handbuch

Roto

Roto ZAR M R4/R7 Bedienungsanleitung

SOMFY

SOMFY Movelite WT Series Bedienungsanleitung

Acmeda

Acmeda RF400 Series Bedienungsanleitung

Motura

Motura Pli_353/3 Bedienungsanleitung