Sime Format System 25 HE Bedienungsanleitung

Format System

25 HE

User instructions

ENSURE THAT THESE INSTRUCTIONS ARE LEFT

FOR THE USER AFTER COMPLETION OF THE

BENCHMARK SECTION

Please read the Important Notice within

this guide regarding your boiler warranty

199838

All descriptions and illustrations provided in this manual have been carefully prepared but we reserve the right to make changes

and improvements in our products that may affect the accuracy of the information contained in this manual.

IMPORTANT NOTICE

For the first year all of our appliances are protected by our manufacturer’s guarantee which covers both parts and

labour.

As you would expect from Sime Ltd, it is our aim to provide our valued customers with the best in after sales and

service.

To take advantage of any extended warranty offered, all you have to do is to adhere to these 3 simple conditions:

• The installation must be carried out to Manufacturers/Benchmark Standards by a Gas Safe Registered

Engineer, and recorded in the installation manual.

• The appliance must be registered with both Sime Ltd and Gas Safe within 30 days of installation.

• The appliance must be serviced annually, by either Sime Ltd or a Gas Safe registered engineer- ensuring that the

Benchmark service record in the installation manual is completed.

Failure to comply with the above will result in only the 12 month warranty being offered.

In the absence of any proof of purchase, the 12 month warranty period will commence from the date of manufacture

of the boiler as shown on the appliance data plate.

The Benchmark Scheme

Sime Ltd is a licensed member of the Benchmark Scheme which aims to improve the standards of installation and

commissioning of domestic heating and hot water systems in the UK and to encourage regular servicing to optimi-

se safety, efficiency and performance.

Benchmark is managed and promoted by the Heating and Hotwater Industry Council.

For more information visit www.centralheating.co.uk

Please ensure that the installer has fully completed the Benchmark Checklist on the inside back pages of the

installation instructions supplied with the product and that you have signed it to say that you have received a full

and clear explanation of its operation.

The installer is legally required to complete a commissioning checklist as a means of complyng with the appropria-

te Building Regulations (England and Wales).

All installations must be notified to Local Area Building Control either directly or through a Competent Persons

Scheme.

A Building Regulations Compliance Certificate will then be issued to the customer who should, on receipt, write the

Notification Number on the Benchmark Checklist.

This product should be serviced regularly to optimise its safety, efficiency and performance.

The service engineer should complete the relevant Service Record on the Benchmark Checklist after each service.

The Benchmark Checklist may be required in the event of any warranty work and as supporting documentation

relating to home improvements in the optional documents section of the Home Information Pack.

OPERATING INSTRUCTIONS FOR THE USER

1.1 INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

1.2 OPERATING INSTRUCTIONS

1.3 MINIMUM CLEARANCES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7

1.4 ROUTINE SERVICING

1.5 GENERAL INFORMATION

1.6 SAFETY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8

These appliances comply with the S.E.D.B.U.K. scheme, band “D”

CONTENTS

VERY IMPORTANT!

PLEASE MAKE SURE YOUR BENCHMARK CHECKLIST IN THE

INSTALLATION GUIDE, IS FILLED IN CORRECTLY.

ALL GAS SAFE REGISTER INSTALLERS CARRY A ID CARD.

THE REGISTRATION NUMBER SHOULD BE

RECORDED ON THE CHECK LIST.

YOU CAN CHECK YOUR INSTALLER IS GAS SAFE

REGISTERED BY CALLING ON 0800 408 5577

A EC

OPERATING INSTRUCTIONS FOR THE USER

Fig. 1

KEY

A Temperature/pressure gauge

B Time clock (optional)

C Rotary switch

E C.H. thermostat

THE GAS SAFETY (INSTALLATION AND USE) REGULATIONS

1996. It is the law that all gas appliances are installed by a

registered person, in accordance with the above regulations.

Failure to install appliances correctly could lead to prosecu-

tion.

It is in your own interest, and that of safety, to ensure that the

law is complied with.

It is essential that the appliance is correctly earthed. An

electricity supply of 240 V - 50 Hz fused at 3 A is required.

Read these instructions carefully before attempting to oper-

ate the appliance.

1.1 INTRODUCTION

The Sime “FORMAT SYSTEM 25 HE” family is a fully auto-

matic, wall mounted, room sealed, fan assisted range of com-

bination boilers.

The appliance provides central heating as required.

The heat output is automatically controlled by the fully modu-

lating gas valve (within its pre-set limits), and there are user

adjustable potentiometers to control the temperature of cen-

tral heating.

A temperature/pressure gauge is fitted and an overheat ther-

mostat is incorporated to protect against fault conditions.

1.2 OPERATING INSTRUCTIONS

1.2.1 To light the appliance (see fig. 1)

– Turn the selector rotary switch to the WINTER position “ ❄ "

and the burner will light to serve the heating load.

Set the

required temperature for the C.H. by rotating the poten-

tiometer ( E) clockwise to increase or anticlockwise to

decrease the temperature.

1.2.2 To turn off the appliance (see fig. 1)

–For short periods:

Set the selector switch (C) to OFF position. When

required, turn the selector switch to the WINTER position.

–For longer periods:

Set the selector switch (C) to the OFF position, turn off

the gas isolation cock. When required, manually rotate

the pump, open the gas isolation cock and turn the selec-

tor switch to the WINTER position.

NOTE: If frost protection is required-Leave the selector

switch in the winter position, turn then CH thermostat

to minimum (fully anticlockwise), do not isolate the gas

supply.

1.3 MINIMUM CLEARANCES

The following MINIMUM CLEARANCES must be available for

servicing the appliance:

1.4 ROUTINE SERVICING

To ensure continued efficient operation of the appliance, it is

recommended that it is checked and serviced as necessary

at regular intervals.

The frequency of servicing will depend upon the particular

installation conditions and usage but in general once a year

should be adequate. It is the law that any service work must

be carried out by a registerd person (Gas Safe Register).

1.5 GENERAL INFORMATION

1.5.1 Fault finding indicators (LEDS)

The appliance is fitted with a safety cut-out thermostat. In

the event of overheating this will interrupt the power supply

and prevent the appliance from functioning.

If this occurs, allow the appliance to cool, turn the rotary

switch to “ “ position and release it immediately, then turn

it back to the previous position (see fig. 2).

If the cut-out condition is repeated, turn off the electrical sup-

ply and consult your installer or service engineer.

1.5.2 Temperature/pressure gauge

The gauge (A fig. 1) on the facia panel indicates the approxi-

mate system pressure. If the normal running pressure is

seen to decrease over a period of time there is a water leak

and you should consult your installer or service engineer.

1.5.3 Electrical supply

The mains plug used must be a 3 pin type to BS1363, and

fused at 3 A. THIS APPLIANCE MUST BE EARTHED.

NOTE: an interruption in the electricity supply whilst the

burner is alight may cause the overheat thermostat to

operate. If this is suspected, turn the rotary switch to “ “

position and release it immediately, then turn it back to

the previous position.

TO CONNECT A PLUG

As the colour of wires in the mains lead of this appliance may

For ventilation For servicing

ABOVE THE APPLIANCE CASING 200 mm 300 mm

AT THE R.H.S. 15 m m 15 m m

AT THE L.H.S. 15 m m 15 m m

BELOW THE APPLIANCE CASING 200 mm 200 mm

IN FRONT OF THE APPLIANCE 350 mm 500 mm

Fig. 2

Bi-colour led 1

Bi-colour led 2

Operating mode Bi-colour led 1 Bi-colour led 2

Stand-by green ON OFF

Flame presence green ON orange ON

Flame detection

circuit fault green ON flashing orange

Ignition lock OFF red ON

Water flow switch (FL)

or limit stat (TL) flashing orange OFF

intervention

Fan fault flashing green OFF

C.H. sensor (SM)

fault steady orange OFF

Boiler off OFF OFF

not correspond with the coloured markings identifying the

terminals in your plug, proceed as follows:

the wire which is coloured green and yellow must be con-

nected to the terminal in the plug which is marked with the

letter E or by the earth symbol - or coloured green and yel-

low; the wire which is coloured blue must be connected to

the terminal marked with the letter N or coloured black; the

wire which is coloured brown must be connected to the ter-

minal marked with the letter L or coloured red.

1.5.4 Ventilation

If the appliance is installed in a cabinet, the latter MUST NOT

be used for storage purposes.

Any ventilation provided for the appliance during installation

MUST NOT be blocked and a periodic check must be made

to ensure that the vents are free from obstructions.

1.5.5 Cleaning

Use only a damp cloth and mild detergent to clean the appli-

ance outer casing. DO NOT use abrasive cleaners.

1.6 SAFETY

It is essential that the instructions in this booklet are strict-

ly followed for the safe and economical operation of this

appliance. The appliance functions as a fan assisted bal-

anced flue unit.

The flue terminal MUST NOT BE OBSTRUCTED under any cir-

cumstances. If damaged, turn off the appliance and consult

the installer, service engineer, or gas supplier. If it is known or

suspected that a fault exists on the appliance it MUST NOT

be used until the fault has been rectified by a competent per-

son.

WARNING: IF A GAS LEAK IS SUSPECTED OR EXISTS,

TURN OFF THE GAS SUPPLY TO THE APPLIANCE AT THE

GAS SERVICE COCK. DO NOT OPERATE ANY ELECTRICAL

SWITCHES. DO NOT OPERATE ANY ELECTRICAL APPLI-

ANCE. OPEN ALL WINDOWS AND DOORS. DO NOT

SMOKE. EXTINGUISH ALL NAKED LIGHTS. CONTACT THE

GAS SUPPLIER IMMEDIATELY.

Andere Handbücher für Format System 25 HE

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Sime Kessel Handbücher

Sime

Sime RX 19 Benutzerhandbuch

Sime

Sime Brava Slim 25 BF Handbuch

Sime

Sime DEWY Series Bedienungsanleitung

Sime

Sime 1R OF Series Bedienungsanleitung

Sime

Sime super mk.ii Benutzerhandbuch

Sime

Sime ALU PLUS HE 360 Handbuch

Sime

Sime MERIDIAN HE 30 C Benutzerhandbuch

Sime

Sime SOLIDA Series Bedienungsanleitung

Sime

Sime FORMAT DGT HE Bedienungsanleitung

Sime

Sime Open.zip 6 25 BF Bedienungsanleitung

Sime

Sime MURELLE REVOLUTION 25 Handbuch

Sime

Sime SUPERIOR Ci EI Montageanleitung

Sime

Sime 1R OF Series Bedienungsanleitung

Sime

Sime EDEA Handbuch

Sime

Sime RX Series Bedienungsanleitung

Sime

Sime RX 19 TP Bedienungsanleitung

Sime

Sime GO 18 BF Handbuch

Sime

Sime Ecomfort Plus 30 HE Benutzerhandbuch

Sime

Sime SOLO 25 Bedienungsanleitung

Sime

Sime Ecomfort Bedienungsanleitung

Sime

Sime AR Series Bedienungsanleitung

Sime

Sime BRAVA ONE 18-25 BF Handbuch

Sime

Sime rondo Bedienungsanleitung

Sime

Sime Murelle Pro HE 25 HO ErP Bedienungsanleitung

Beliebte Kessel Handbücher anderer Marken

Vaillant

Vaillant uniSTOR VIH SW GB 500 BES Bedienungsanleitung

Radijator

Radijator BIO max 23.1 Bedienungsanleitung

Brunner

Brunner BSV 20 Bedienungsanleitung

Buderus

Buderus Logamax GB062-24 KDE H V2 Bedienungsanleitung

Potterton

Potterton 50e Datenblatt

UTICA BOILERS

UTICA BOILERS TriFire Bedienungsanleitung

Joannes

Joannes LADY Series Handbuch

ECR International

ECR International UB90-125 Gebrauchsanweisung

Froling

Froling FHG Turbo 3000 Bedienungsanleitung

Froling

Froling P4 Pellet 8 - 105 Bedienungsanleitung

U.S. Boiler Company

U.S. Boiler Company K2 Bedienungsanleitung

Henrad

Henrad C95 FF Bedienungsanleitung

NeOvo

NeOvo EcoNox EF 36 Bedienungsanleitung

Potterton

Potterton PROMAX SL 12 Bedienungsanleitung

Eco Hometec

Eco Hometec EC 25 COMPACT Bedienungsanleitung

Viessmann

Viessmann VITODENS 200 Leitfaden

Baxi

Baxi Prime 1.24 Bedienungsanleitung

REXNOVA

REXNOVA ISA 20 BITHERMAL Bedienungsanleitung