Safety Instructions
ŸSafety should be always in the first priority.
ŸUse this Propane Forge after reading these entire instructions for the proper and safe
operation.
ŸAlways use this Propane Forge on a hard level non-combustible surface. This Propane Forge
is for outdoor use only. Do not use it where any kind of damage can happen. Keep fire
extinguisher nearby.
ŸThis Propane Forge is for adult use only. Keep this away from children.
ŸUse fire retardant gloves & blacksmith tong for the operation with the work-piece.
ŸWear appropriate clothes such as a leather apron. Wear goggles while watching fire of the
forge.
ŸNever leave a hot forge unattended, even if the fuel is shut off and be cautious of high
temperature of the forge parts immediately after forging session.
ŸInspect your propane cylinder (especially the valve), your regulator (especially the connector
to the cylinder and its O-ring) and your burner (especially the hose). For any signs of problems
do not install or operate.
ŸInstall the regulator by hand, without tools, until the nut (left-hand thread) is fully seated.
Immediately tighten the nut with a wrench. Do not over tighten the nut, as this will only ruin the
connectors.
ŸAlways shut down the forge by turning off the fuel at the cylinder, then backing off the regulator
knob (as a safety precaution.)
ŸOnce, Forging Session is finished, Remove the Regulator from the cylinder & take the cylinder
in outside area.
ŸAllow the forge to cool for at least half an hour before you leave the area. This is to prevent
accidental fires from going undetected.
www.simondstore.com Page 2 of 13
ŸSimond Store will not be responsible for any damage or injury caused by use
of Gas Forges.
