The 15.19 statement is used. They should have used the one for Licensed devices: “This device
complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does
not cause harmful interference.”
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE: This camera has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This camera generates uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this camera does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help
RF Exposure Information (SAR)
This device is designed and manufactured not to be exceeded the emission limits for exposure to
radio frequency RF energy set by the Federal Communications Commission of the United States.
The exposure standard for wireless devices employing a unit of measurement is known as the
Specific Absorption Rate (SAR), and the SAR limit set by FCC is 1.6 W/kg.
*Tests for SAR are conducted using standard operating positions accepted by the FCC with the
camera transmitting at its highest certified power level in all tested frequency bands. Although
the SAR is determined at the highest certified power level, the actual SAR level of the camera
while operating can be well below the maximum value. This is because the camera is designed
to operate at multiple power levels so as to use only the poser required to reach the network. In
general, the closer you are to a wireless base station antenna, the lower the power output.
The highest SAR value for the camera as reported to the FCC when tested for use direct contact on
the body, as described in this user guide, is 0.85W/kg , While there may be differences between
the SAR levels of various camera and at various positions, they all meet the government
requirement.
The FCC has granted an Equipment Authorization for this model camera with all reported SAR
levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on
this model camera is on file with the FCC and can be found under the Display Grant section of
http://www.fcc.gov/oet/fccid after searching on FCC ID: 2AE44IRIS4G. For body operation, this
camera has been tested and meets the FCC RF exposure guidelines for use with an accessory that
contains no metal and the positions with a minimum of 0.5cm from the body. Use of other
enhancements may not ensure compliance with FCC RF exposure guidelines.
