SIST&MATICA Srl
SIST&MATICA SrlSIST&MATICA Srl
SIST&MATICA Srl
Pag.
2
Via S. Pertini, 17 - 12030 MANTA (CN) ITALY Tel. +3 0175 255.700 r.a. - Fax +3 0175 255.715
http://www.sistematica.it e-mail: info@sistematica.it
TECHNICAL FEATURES
•Working frequency 433.92 MHz;
•Battery supply (no. 2 "AAA" 1,5V Cell, Alkaline
Batteries)
•Transmission average absorption < 5 mA
•Quiescent absorption < 0.2 uA
•Average batteries life: 8 mths
•Light signals to indicate controls transmission and
low battery
•IP 67 protected, oil, diluted alkali and acids proof
keypad
•Up to 4 control functions
•Response time after a button push: <35 ms
•Emergency stop function response time (stop
button): <35 ms
•Working temperature: -20°C to + 70°C
•Transmitter weight (batteries included): 55 gr.
•Working distance in open spaces: 80 m.- 260 ft
(with fresh batteries)
•Size (in mm): 96 x 47 x 24
INSTRUCTIONS FOR USE
1. Switch the receiver on (emergency stop button
released)
2. Wait for a few seconds (self-testing)
3. Press START to allow the system to receive the
transmission (the system stays active for n. 2
minutes after the last control has been given, after
which it resets. Then press START again to
restart the system)
4. Press the required key on the transmitter to
activate the related output on the receiver.
Ex. KEY 1→OUT 1 + RELAY MOTOR
5. Press the STOP key to inhibit the controls
reception. In this phase all the controls are reset.
To activate again the system press START
LED INDICATED ON THE RADIO TRANSMITTER
REGULAR FUNCTIONING
While functioning regularly, the LED flashes when any
key is pressed.
LOW BATTERY
When the battery is low, the LED keeps flashing as far
as a key is pressed. At this point, the system will
function for a few more time: replace with new
batteries (see “TRANSMITTER’S BATTERIES
REPLACEMENT”).
Do not leave flat batteries inside the transmitter
SYSTEM CODING
It is necessary to code the system only if you have to
replace the transmitter unit or if you want to use it with
a different receiver from the one it was purchased with.
To recode the system refer to the receiver user
manual
