VK7
Installation Instructions4
Preplanned Accessory Positioning
Positioning of all accessories must be planned in advance before installation begins.
•Ensure that no wire braids go through locations where Device accessories are to
be installed.
•Ensure that any parts of the Device will not interfere with the vehicle or its
accessories’ operation
Plan Device and mounting bracket
Positions
Note!
The best way to determine the Device’s position to the customer’s full
satisfaction is to locate it when the customer is beside you and obtain
his/her approval.
•Please ensure the Device’s location does not interfere with the vehicle or its
accessories operation: it should not interfere with opening the glove compartment
or ashtray, should not prevent access to the lighter, moving the gear stick,
operating the hand break etc.
•If the Device is installed near the car windshield/dash board, ensure that it does
not interfere with the visual field.
Warning!
Do not install the Device in front of the vehicle’s air bag. This
restriction must be adhered to, as in the case of an emergency the
air bag blows up and can fail to work properly.
•Ensure the surface on which this Device is installed is sufficiently strong to carry
the weight and pressure which would be exerted on it.
•When selecting the Device’s location, please ensure the control cable connected
to it does not interfere with the vehicle or its accessories’ operation.
•Ensure it is safe and convenient to operate the Device from the driver’s seat.
•Ensure the Device would be protected from direct sunlight and humidity (air
conditioner openings).
