Instructions for using the
Convey® Picture Display
Skyline Exhibits
3355 Discovery Road
Eagan, MN 55121-2098
1-800-328-2725
Skyline®is a registered trademark of Skyline Exhibits
Convey® is a registered trademark of Skyline Exhibits
©2016 Skyline Exhibits
3/17/16
PN32791-E
Basic Quick Start Instructions:
Remove Picture Player from box. Take the AC power adaptor out of the small white box and
connect the adaptor into the DC 12V input on the right side of the Picture Player.
Plug the other end of the adaptor into a power outlet.
The Picture Player can be controlled by either the navigation buttons on the right side of the Picture Player
or the remote control.
To activate the remote, pull
out the plastic piece from the
bottom of the unit. Point it
at the sensor at the front and
bottom of the Picture Player.
Power LED Light Power to Picture Player
Menu Photo (allows you to enter the
slideshow menu)
Enter Play/Pause
Right Arrow/Volume +
Up, Right, Down, Left and
Enter (Conrm and Play)
Left Arrow/Volume -
Arrow Down
Arrow Up
Power Switch
12DC Input
Setup (enter the basic setup menu)
Media may be read from a USB drive, a media card
(XD/SE/MS/MMC) or a Compact Flash (CF) card.
Pictures should be saved as JPG or BMP, audio as
MP3 or WMA, or video as MPEG-2 (see page 5 for
details.) The Picture Display will not connect to a
computer.
Remember: images should be kept to approximately
800x600 pixels to ensure best performance and
compatibility.
Once the files have been loaded onto the media card,
insert it into the media slot on the left side of the Picture
Player.
Now the picture display is ready to use.
Mini-USB input
USB input
XD/SD/MS/MMC
CF Card
Picture Player Left Side
Picture Player Right Side Remote Control
