Version：V2.1
7/11
2) Press the shutdown button to set the shutdown settings for the controller with the
current ID. When you hear a long beep from the controller, the LCD screen of the remote
control will also display the transmission success, which means that the parameters have
been written successfully.。
3) Press the power button to set up the controller with the current ID. When you hear a
long beep from the controller, the LCD screen of the remote control will also display the
sending success, which means that the parameters have been written successfully.
3.3.2. Infrared communication：
Aim the remote control at the controller's infrared emitting tube and receiving tube, on
the main interface, move the cursor to "Send parameter", press the " □" key to enter the
sending parameter interface, move the cursor to the corresponding parameter, and press "□"
When the option is shaded, press the " ↓ ↑ " key to edit the value, press the " □" key to
confirm after setting, and press the send key to send the parameter after editing.
3.3.3 2.4G broadcast
In the main interface, move the cursor to "Send parameter", press the "□" key to enter
the transmission parameter interface, move the cursor to the corresponding parameter, press
the "□" key, when the option is shaded, press "↓↑" ”Key to edit the value, press the “□” key to
confirm after setting, and press the send key to send the parameter after editing. The 2.4G
broadcast mode will synchronously send parameters to all the nearby controllers that are
searched. The speed is faster than the 2.4G search mode. The 2.4G broadcast mode does not
display the controller ID.
1) Press the send button to set the parameters of all the controllers in the current
communication range. If the parameters are set successfully, all the indicators of the
controller will flash and the controller in the driving state will control the street lights to go
out and then turn on again, not in the state of driving lights The lower controller will control
the street light to turn on and then off, which means that the parameter has been written
successfully.
2) Press the shutdown button to perform shutdown settings for all controllers within the
current communication range. When the controller indicator is off, it means the shutdown is
successful.
3) Press the power button to set up all the controllers in the current communication
range. When the controller indicator lights or flashes, it means the power on is successful.
