①Find the outdoor area with Strongest Signal
②Install the outdoor Antenna
PAY ATTENTION TO SELF-OSCILLATION*
③Install the Booster
④Connect the System
⑤Check the Coverage and Optimize
1)Walk around your house with
your cell phone, search for the
place where your phone gets the
strongest signal reception, at
least 3-4 signal bars.
2)Make a few phone calls there
to check the call quality, if it is
clear and stable, that will be an
ideal position to place the
outdoor antenna.
①
Install the outdoor antenna on
the wall near the location you
found in Step 1. Make sure the
antenna points towards the
direction on where your cellular
operator’s tower is.
To prevent lightening, the height
of the outdoor antenna should
be lower than the highest point
of your house.
②
Connect the Outdoor Antenna
cable with “BTS " port on the
cellular signal booster, and
connect the Indoor Whip
Antenna with “ANT" port on the
booster. Then power on the
booster and check the coverage.
④
√×
If you do not have any installation experience,
please read the detailed installation guide within the manual.
Place the Booster at where
strong signal is needed most.
③
*The Outdoor Antenna should be
as far away as possible from the
Indoor Antenna.
Minimum separation : 20 Feet
Horizontal and 13 Feet Vertical.
＞13FT.
＞20FT.
booster
12
The arrows represent the
isolation between outdoor
antenna and indoor antenna.
When flashing, it reminds you the
separation between antennas are
not enough. Try to increase more
distance between antenna and
make sure the antennas are not
facing to each other.
It shows the outdoor signal
strength your booster picked up
from outside. The more bars you
get, the better coverage the
booster will produce. Try to get
at least 2 bars, 3 bars will be the
best.
⑤
1
2
power
