Smart Technologies SDC-550 Montageanleitung
1
2
TV RGB
TV RGB
TV RGB
Congratulations on your new SMART product!
smarttech.com/downloads
- Download software
smarttech.com/support
- Information on support, compliance,
warranty, and product registration
Willkommen in Ihrem neuen SMART-Produkt!
smarttech.com/downloads
- Laden Sie Ihre Software herunter
smarttech.com/support
- Informationen über Support, Compliance,
Garantie und Produktregistrierung
Félicitations pour votre nouveau produit SMART !
smarttech.com/downloads
- Télécharger votre logiciel
smarttech.com/support
- Informations sur l'assistance, la conformité,
la garantie et l'enregistrement du produit
SMART Technologies
3636 Research Road NW
Calgary, AB, T2L 1Y1
CANADA
Toll free (U.S./CA): 1.888.42.SMART
Tel: +1.403.245.0333
P/N: 1029266 Rev: 02
M
CAMERA PLAYBACK PC 1/2
VISOR SPOTLIGHT SPLITSCREEN
ROTATE TIMER MODE
ZOOM LAMP BRIGHTNESS
ZOOM1X DEFAULT
DEL
MENU
AUTOFOCUS
CAPTURE RECORD FREEZE/STOP
TV RGB
TV RGB
3
4
DC 12V WIFI HDMI IN HDMI OUT TV OUT USB
smarttech.com/kb/170279
SMART Document Camera™
User’s Guide
TV RGB
DC 12V WIFI HDMI IN HDMI OUT TV OUT USB
B
A
C
SDC-550 QUICK CONNECT GUIDE
smarttech.com/kb/170279
SMART Document Camera™
User’s Guide
RESET
RS-232
RESET
RS-232
TV RGB
TV RGB
3x
B
AC
1030771 3
Federal Communication Commission interference statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
The operation within 5.15~5.25 GHz / 5.47~5.72 GHz frequency range, it is restricted to indoor environment. The band from 5600~5650
MHz will be disabled by the software during the manufacturing and cannot be changed by the end user. The device meets all the other
requirements specified in Part 15E, Section 15.407 of the FCC Rules.
Radiation Exposure Statement:
The product comply with FCC portable RF exposure limits set forth for an uncontrolled environment and are safe for intended operation as
described in this manual. The further RF exposure reduction can be achieved if the product can be kept as fas as possible from the user
body or set the device to lower output power if such function is available.
1030771 Rev 01
© 2017 SMART Technologies ULC. All rights reserved. SMART Document Camera, smarttech, the SMART logo
and all SMART taglines are trademarks or registered trademarks of SMART Technologies ULC in the U.S. and/
or other countries. All third-party product and company names may be trademarks of their respective owners.
This product and/or use thereof covered by one or more of the following U.S. patents: smarttech.com/patents.
Other patents pending. 09/2017
*1030771*
smarttech.com/kb/ 171223
support.smarttech.com/support
support.smarttech.com/contact-support
Hardware environmental compliance
SMART Technologies supports global eorts to ensure that electronic equipment is manufactured, sold and disposed of in a safe and
environmentally friendly manner.
Waste Electrical and Electronic Equipment and Battery regulations (WEEE and Battery Directives)
Electrical and electronic equipment and batteries contain substances that can be harmful to the environment and to human health.
The crossed-out wheeled bin symbol indicates that products should be disposed of in the appropriate recycling stream and not as
regular waste.
Batteries: The SDC 550 contain rechargeable lithium batteries. The remote contains two AAA batteries. Recycle or dispose of
batteries properly.
+
-
EU Declaration of Conformity
Hereby, SMART Technologies ULC declares that the radio equipment type Doc Camera, SDC-550 is in compliance with Directive 2014/53/
EU. The full text of the EU
declaration of conformity is available at the following internet address: www. smarttech.com/compliance
The frequency band and the maximum transmitted power in EU are listed below:
2400MHz - 2483.5MHz: 19.85dBm (EIRP) • 5150MHz – 5350MHz: 19.45dBm (EIRP) • 5470MHz – 5725MHz: 17.44dBm (EIRP)
Restrictions in (5GHz) AT/BE/BG/CZ/DK/EE/FR/DE/IS/IE/IT/EL/ES/CY/LV/LI/LT/LU/HU/MT/NL/NO/PL/PT/RO/SI/SK/TR/FI/SE/CH/UK/HR.
5150MHz-5350MHz is for indoor use only.
This device complies with RSS-2410 of the ISED rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Caution:
(i) the device for operation in the band 5150-5250 MHz is
only for indoor use to reduce the potential for harmful
interference to co-channel mobile satellite systems;
(ii) the maximum antenna gain permitted for devices in
the bands 5250-5350 MHz and 5470-5725 MHz shall
comply with the e.i.r.p. limit; and
(iii) the maximum antenna gain permitted for devices in
the band 5725-5825 MHz shall comply with the e.i.r.p.
limits specified for point-to-point and non point-to-point
operation as appropriate.
(iv) Users should also be advised that high-power radars
are allocated as primary users (i.e. priority users) of the
bands 5250-5350 MHz and 5650-5850 MHz and that
these radars could cause interference and/or damage
to LE-LAN devices.
Radiation Exposure Statement:
The product comply with FCC portable RF exposure limits
set forth for an uncontrolled environment and are safe
for intended operation as described in this manual. The
further RF exposure reduction can be achieved if the
product can be kept as fas as possible from the user body
or set the device to lower output power if such function
is available.
Cet appareil est conforme à la norme ISED CNR-210 pour les appareils radio
agréés. Son fonctionnement est sujet aux deux conditions suivantes: (1) le
dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit
accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer
un fonctionnement indésirable.
Avertissement:
Le guide d’utilisation des dispositifs pour réseaux locaux doit inclure des
instructions précises sur les restrictions susmentionnées, notamment :
(i) les dispositifs fonctionnant dans la bande 5 150-5 250 MHz sont réservés
uniquement pour une utilisation à l’intérieur afin de réduire les risques de
brouillage préjudiciable aux systèmes de satellites mobiles utilisant les
mêmes canaux;
(ii) le gain maximal d’antenne permis pour les dispositifs utilisant les bandes
5 250-5 350 MHz et 5 470-5 725 MHz doit se conformer à la limite de
p.i.r.e.;
(iii) le gain maximal d’antenne permis (pour les dispositifs utilisant la bande
5 725-5 825 MHz) doit se conformer à la limite de p.i.r.e. spécifiée pour
l’exploitation point à point et non point à point, selon le cas.
(iv) De plus, les utilisateurs devraient aussi être avisés que les utilisateurs
de radars de haute puissance sont désignés utilisateurs principaux (c.-
à-d., qu’ils ont la priorité) pour les bandes 5 250-5 350 MHz et 5 650-5
850 MHz et que ces radars pourraient causer du brouillage et/ou des
dommages aux dispositifs LAN-EL.
Déclaration d’exposition aux radiations:
Le produit est conforme aux limites d’exposition pour les appareils portables
RF pour les Etats-Unis et le Canada établies pour un environnement non
contrôlé. Le produit est sûr pour un fonctionnement tel que décrit dans ce
manuel. La réduction aux expositions RF peut être augmentée si l’appareil
peut être conservé aussi loin que possible du corps de l’utilisateur ou que le
dispositif est réglé sur la puissance de sortie la plus faible si une telle fonction
est disponible.
Innovation, Science and Economic Development Canada Statement:
Inhaltsverzeichnis
Andere Smart Technologies Dokumentenkamera Handbücher
