- 3 -
IP Configuration Software
1. Safety Instructions
These safety instructions are intended to prevent hazardous situations and/or equipment damage. These
instructions are categorized into three groups, "Caution", "Warning" and "Danger" depending on the level of
hazard and damage, and the degree of emergency. They are all important notes for safety and must be followed
in addition to International Standards (ISO/IEC), Japan Industrial Standards (JIS)*1) and other safety
regulations*2).
*1: ISO 4414: Pneumatic fluid power – General rules relating to systems
ISO 4413: Hydraulic fluid power -- General rules relating to systems
IEC 60204-1: Safety of machinery -- Electrical equipment of machines (Part 1: General requirements)
ISO 10218-1992: Manipulating industrial robots -- Safety
JIS B 8370: General rules for pneumatic equipment.
JIS B 8361: General rules for hydraulic equipment.
JIS B 9960-1: Safety of machinery – Electrical equipment for machines. (Part 1: General requirements)
JIS B 8433-1993: Manipulating industrial robots - Safety, etc.
*2: Labor Safety and Sanitation Law, etc.
Caution Caution indicates a hazard with a low level of risk which, if not avoided, could result in minor or
moderate injury.
Warning Warning indicates a hazard with a medium level of risk which, if not avoided, could result in
death or serious injury.
Danger Danger indicates a hazard with a high level of risk which, if not avoided, will result in death or
serious injury.
Warning
1. The compatibility of the product is the responsibility of the person who designs the equipment or
decides its specifications.
Since the product specified here is used under various operating conditions, its compatibility with specific
equipment must be decided by the person who designs the equipment or decides its specifications based
on necessary analysis and test results. The expected performance and safety assurance of the
equipment will be the responsibility of the person who has determined its compatibility with the product.
This person should also continuously review all specifications of the product referring to its latest catalog
information, with a view to giving due consideration to any possibility of equipment failure when
configuring the equipment.
2. Only personnel with appropriate training should operate machinery and equipment.
The product specified here may become unsafe if handled incorrectly.
An operator who is appropriately trained and experienced must perform the assembly, operation and
maintenance of machines or equipment.
3. Do not service or attempt to remove product and machinery/equipment until safety is confirmed.
1) The inspection and maintenance of machinery/equipment should only be performed after measures to
prevent dropping of driven objects or run-away of machinery/equipment have been confirmed.
2) When the product is to be removed, confirm that the safety measures as mentioned above are
implemented and the power from any appropriate source is cut, and read and understand the specific
product precautions of all relevant products carefully.
3) Before machinery/equipment is restarted, take measures to prevent unexpected operation and
malfunction.
4. Contact SMC beforehand and take special consideration of safety measures if the product is to
be used in any of the following conditions:
1) Conditions and environments outside of the given specifications, or used outdoors or in a location
exposed to direct sunlight.
2) Installation of equipment in conjunction with atomic energy, railways, air navigation, space appliances,
shipping, vehicles, military, medical equipment, combustion devices, recreation equipment, or
equipment which comes in contact with food and beverages, emergency stop circuits, clutch and brake
circuits in press applications, safety equipment or any other applications unsuitable for the standard
specifications described in the product catalog.
3) An application that could have negative effects on people, property, or animals, especially those
applications requiring special safety analysis.
