Smeg S399XPZ6 Bedienungsanleitung
Contents
1. INSTRUCTIONS FOR SAFE AND PROPER USE_______________ 34
2. INSTALLATION _________________________________________ 36
3. DESCRIPTION OF CONTROLS ____________________________ 39
4. USE OF THE OVEN______________________________________ 47
5. USING THE PIZZA FUNCTION _____________________________ 49
6. AVAILABLE ACCESSORIES _______________________________ 51
7. COOKING HINTS________________________________________ 52
8. CLEANING AND MAINTENANCE ___________________________ 56
9. EXTRAORDINARY MAINTENANCE _________________________ 62
INSTRUCTIONS FOR THE INSTALLER: these are intended for the
qualified technician who must install the appliance, set it functioning
and carry out an inspection test.
INSTRUCTIONS FOR THE USER: these contain user advice,
description of the commands and the correct procedures for cleaning
and maintenance of the appliance.
33
Introduction
1. INSTRUCTIONS FOR SAFE AND PROPER USE
THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND
THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE
PLACE FOR THE WHOLE WORKING LIFE OF THE OVEN. WE ADVISE
CAREFUL READING OF THIS MANUAL AND ALL THE INSTRUCTIONS
THEREIN BEFORE USING THE OVEN. INSTALLATION MUST BE CARRIED
OUT BY QUALIFIED PERSONNEL IN ACCORDANCE WITH THE
REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTIC
USES AND CONFORMS TO CURRENT REGULATIONS IN FORCE. THE
APPLIANCE HAS BEEN BUILT TO CARRY OUT THE FOLLOWING
FUNCTIONS: COOKING AND HEATING-UP OF FOOD. ALL OTHER USES
ARE CONSIDERED IMPROPER.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR IMPROPER
USE.
DO NOT LEAVE THE PACKING IN THE HOME ENVIRONMENT. SEPARATE
THE VARIOUS WASTE MATERIALS AND TAKE THEM TO THE NEAREST
SPECIAL GARBAGE COLLECTION CENTRE.
IT IS OBLIGATORY FOR THE ELECTRICAL SYSTEM TO BE GROUNDED
ACCORDING TO THE METHODS REQUIRED BY SAFETY RULES.
WHEN LINKING UP TO MAINS BY PLUG AND SOCKET, MAKE SURE THAT
BOTH ARE COMPATIBLE AND CONNECT BY MEANS OF A POWER CABLE
COMPLYING WITH APPLICABLE REGULATIONS.
THE SOCKET MUST BE ACCESSIBLE AFTER THE APPLIANCE HAS BEEN
BUILT IN.
NEVER UNPLUG BY PULLING ON THE CABLE.
DO NOT OBSTRUCT VENTILATION OPENINGS AND HEAT DISPERSAL
SLITS.
IMMEDIATELY AFTER INSTALLATION CARRY OUT A BRIEF INSPECTION
TEST OF THE OVEN, FOLLOWING THE INSTRUCTIONS BELOW. SHOULD
THE APPLIANCE NOT FUNCTION, DISCONNECT IT FROM THE SUPPLY AND
CALL THE NEAREST TECHNICAL ASSISTANCE CENTRE.
NEVER ATTEMPT TO REPAIR THE APPLIANCE.
34
Introduction
ALWAYS CHECK THAT THE CONTROL KNOBS ARE IN THE “ZERO” (OFF)
POSITION WHEN YOU FINISH USING THE OVEN.
NEVER PUT INFLAMMABLE OBJECTS IN THE OVEN: THEY COULD BE
ACCIDENTALLY LIGHTED AND CAUSE FIRES.
DURING USE THE APPLIANCE BECOMES VERY HOT. TAKE CARE NOT TO
TOUCH THE HEATING ELEMENTS INSIDE THE OVEN.
THE I.D. PLATE WITH TECHNICAL DATA, REGISTRATION NUMBER AND
BRAND NAME IS POSITIONED VISIBLY ON THE OVEN DOOR FRAME.
THE PLATE MUST NOT BE REMOVED.
THE USE OF THIS APPLIANCE IS NOT PERMITTED TO PEOPLE (INCLUDING
CHILDREN) OF REDUCED PHYSICAL AND MENTAL ABILITY, OR LACKING IN
EXPERIENCE IN THE USE OF ELECTRICAL APPLIANCES, UNLESS THEY
ARE SUPERVISED OR INSTRUCTED BY ADULTS OR PEOPLE
RESPONSIBLE FOR THEIR SAFETY.
THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE
2002/96/EC ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
(WEEE).
THIS GUIDELINE IS THE FRAME OF A EUROPEAN-WIDE VALIDITY OF
RETURN AND RECYCLING ON WASTE ELECTRICAL AND ELECTRONIC
EQUIPMENT.
BEFORE THE APPLIANCE IS PUT INTO OPERATION, ALL THE LABELS AND
PROTECTIVE FILMS APPLIED INSIDE OR OUTSIDE MUST BE REMOVED.
The manufacturer declines all responsibility for damage to persons
or things caused by non-observance of the above prescriptions or by
interference with any part of the appliance or by the use of non-original
spares.
35
Instructions for the installer
36
2. INSTALLATION
2.1 Electrical connection
Check that mains voltage and power cable ratings are as per the
indications provided on the label attached to the oven door frame.
This label must never be removed.
It is obligatory for the electrical system to be grounded according to the
methods required by safety rules.
If a plug and socket connection is being used make sure that the plug
and socket are compatible. Avoid use of adapters and shunts as these
could cause overheating and risk of burns.
If a fixed connection is being used fit power line with an omnipolar circuit
breaker with a contact opening gap equal to or greater than 3 mm in an
easily accessible position in proximity to the oven.
For operation on 220-240V
∼
:use an
H05RR-F / H05RN-F / H05V2V2-F type
three-core cable (3 x 1.5 mm2).
The cable end to be connected to the
appliance must be provided with an ground
wire (yellow-green) at least 20 mm longer.
The manufacturer declines all responsibility for damage to persons
or things caused by non-observance of the above prescriptions or by
interference with any part of the appliance.
Instructions for the installer
2.2 Mounting the oven
The oven is designed for mounting into any piece of furniture as long as
heat-resistant. Proceed according to the dimensions shown in Figures 1,
2and 3. For installing under a work top, follow the dimensions given in
Figure 1-3. For installing under a work top with combined heating plates,
ensure a minimum clearance from any side walls of at least 110 mm as
shown in Figure 1.
For installing in a column, follow the dimensions given in Figure 1-2
allowing for a clearance of 80 to 90 mm at the top and sides of the
column. Tighten the 2/4 screws Ainside the frame to secure (Fig. 1).
For installing beneath a non-integrated top, allow for a rear and bottom
clearance as shown in Figure 1(ref. B). See relevant instructions for
fitting and securing the cook top.
37
Instructions for the installer
38
Never use the oven door to lever the oven into
place when fitting.
Avoid exerting too much pressure on the oven door
when open.
Instructions for the user
3. DESCRIPTION OF CONTROLS
3.1 Front control panel
All the oven controls are grouped together on the front panel.
THERMOSTAT KNOB
Cooking temperature is selected by turning the knob clockwise to the
desired setting, between 50° and 240°C/ / .
39
Instructions for the user
40
FUNCTION SWITCH KNOB
Rotate the knob in either direction to select desired function from the
following:
NO FUNCTION SET GRILL ELEMENT +
VENTILATION
PIZZA FUNCTION LOWER HEATING ELEMENT +
VENTILATION
UPPER AND LOWER
HEATING ELEMENT VENTILATED HEATING
ELEMENT
GRILL ELEMENT UPPER AND LOWER
HEATING ELEMENT +
VENTILATED HEATING
ELEMENT
WIDE GRILL ELEMENT
Instructions for the user
TIMER KNOB (CERTAIN MODELS ONLY)
Lets you choose manual cooking or the timer with automatic turn-off of
the oven when done.
For manual control of cooking time, turn the knob anticlockwise to
the symbol .
Turn clockwise to wind up the alarm and set to the desired time.. The
numbers from 5 to 90/120 correspond to minutes. Adjustment is
progressive and intermediate positions between the numbers shown
may be used.
At the end of programmed cooking, an audible alarm sounds which goes
off automatically after 4-5 seconds.
THERMOSTAT INDICATOR LIGHT
When this light comes on, the oven is
heating up.
When this light goes out, the preset
heating temperature has been
reached.
When the light flashes, the
temperature inside the oven is steady.
PILOT LIGHT (GREEN)
This light comes on when any of the oven elements is
receiving power.
41
Instructions for the user
42
3.2 Clock + timer with end of cooking (certain models only)
Allows selection of manual cooking or to set timer and cooking time.
Always rotate the small knob AANTICLOCKWISE.
Select function and cooking temperature before setting cooking time.
3.2.1 Adjusting the clock
To adjust to correct time, PRESS and rotate the small knob A
anticlockwise.
3.2.2 Manual cooking
For manual cooking, rotate small knob Aanticlockwise until pointer is
aligned with .
3.2.3 Setting cooking time
To set cooking time, rotate small knob Aanticlockwise to the desired
length of time (maximum 90 minutes).
3.2.4 End of cooking
At end of cooking the oven turns off automatically and the alarm starts
sounds.
3.2.5 To turn the alarm off
Turn small knob Aanticlockwise until pointer is aligned with .
Inhaltsverzeichnis
Andere Smeg Ofen Handbücher
Smeg
Smeg FMI425X Bedienungsanleitung
Smeg
Smeg sfp109 Leitfaden
Smeg
Smeg GM93X8 Bedienungsanleitung
Smeg
Smeg Oven A1-6 Bedienungsanleitung
Smeg
Smeg SAC399X-8 Bedienungsanleitung
Smeg
Smeg SA112-8 Bedienungsanleitung
Smeg
Smeg SC112-8 Bedienungsanleitung
Smeg
Smeg F88MF Bedienungsanleitung
Smeg
Smeg SFP6401TVN1 Bedienungsanleitung
Smeg
Smeg SF106 Bedienungsanleitung
Smeg
Smeg SC805AO-9 Bedienungsanleitung
Smeg
Smeg SF6341GGX Bedienungsanleitung
Smeg
Smeg Oven SA1010X-5 Bedienungsanleitung
Smeg
Smeg S16EMF Bedienungsanleitung
Smeg
Smeg SDO10-5 Bedienungsanleitung
Smeg
Smeg DUSF6300X Bedienungsanleitung
Smeg
Smeg SOP6302TX Bedienungsanleitung
Smeg
Smeg SFA6300X Bedienungsanleitung
Smeg
Smeg SDK380X-5 Bedienungsanleitung
Smeg
Smeg SA578X-8 Bedienungsanleitung
