Sofar 3KTLM-G2 Bedienungsanleitung
TRACKSO INSTALLATION GUIDE FOR SOFAR
Brand: SOFAR
Type: Solar On Grid String Inverter
Models: SOFAR 3KTLM-G2, SOFAR 3.6KTLM-G2, SOFAR 4KTLM-G2, SOFAR 4.6KTLM-G2, SOFAR 5KTLM-G2, SOFAR 6KTLM-G2, SOFAR
10000TL, SOFAR 15000TL, SOFAR 17000TL, SOFAR 20000TL, SOFAR 25000TL, SOFAR 30000TL, SOFAR 33000TL, SOFAR 36000TL,
SOFAR 40000TL, SOFAR 50000TL, SOFAR 60000TL, SOFAR 70000TL-HV
CONNECTION DIAGRAM
Locate communication terminals (RS485) as shown in the picture below. There are two connection terminals on the
configuration circuit board: RS485IN and RS485OUT (used for Daisy Chain connections)
Figure S1: SOFAR String Inverter communicatio port & Connections
Connection steps
•Please unscrew the RS485 terminal as shown in A part of Figure
S1.
•Please make the connections from the Terminal Block to
TrackSo IoT Gateway as mentioned in Table –ST1.
•Provide 12V external supply to TrackSo IoT Gateway via 12V, 2A
DC adaptor provided in the package
Table ST1 –SOFAR RS485 chip connections with TrackSo
IoT Gateway
SOFAR Pin no. & Assignment
TrackSo Pin No.&
Assignment
1
485-IN
B2
4
Data-
2
A2
3
Data+
3
G
4
485-OUT
B1
Used for Daisy
Chain
Connection
5
A1
6
G
Different Connection
location/connectors exist in
different models of Inverter.
Please locate RS485 connector of
your inverter as per its
(We have collated available the
same for available model nos on
next page.)
Inverter Model No.
RS485 Port Location
SOFAR 3KTLM-G2
SOFAR 3.6KTLM-G2
SOFAR 4KTLM-G2
SOFAR 4.6KTLM-G2
SOFAR 5KTLM-G2
SOFAR 6KTLM-G2
SOFAR 10000TL
SOFAR 15000TL
SOFAR 17000TL
SOFAR 20000TL
SOFAR 30000TL
SOFAR 25000TL
SOFAR 33000TL
SOFAR 36000TL
SOFAR 40000TL
SOFAR 50000TL
SOFAR 60000TL
SOFAR 70000TL-HV
In case you are using the RJ45 connector to connect with the datalogger below is the wire config
Join the following wires from CAT6 cable to get RS485
connections
Data + (RS485 +) = 2nd + 3rd + 4th
Data –(RS485 -) = 1st + 5th + 6th
DEFAULT CONFIGURATION IN TRACKSO IOT GATEWAY
Inverter ID: 1, 2, 3, 4 …. Continuous numbering starting with 1, (Range: 1 to 247)
Baud Rate: 9600 (Default) (Values: 9600, 19200, 38400)
Data Bits: 8 ,Stop Bit: 1 ,Parity: None
CONFIGURATION AT THE INVERTER END
Inverter Screen has 4 buttons Back, Up, Down, Ok
SETTING THE INVERTER ID
The inverter ID is used to identify the inverter in a RS485 connection
•Set a different inverter ID for each inverter in the PV plant. Otherwise, the inverters cannot be correctly identified.
•On the last inverter in the RS485 connection, switch on the RS485 termination resistor.
•Users press “Back” button to enter “1.Enter setting” interface, Press ”OK“ button to enter main setting interface.
•Enter “9. Set Address” by pressing “Up” button or ”Down“ button.
•Press “OK” button and enter setting interface “Success” or “fail” is displayed after setting.
SET D ATE & T IME O F INVE RTER
For a precise calculation of the statistics in the inverter itself and in a monitoring system, date and time have to be correct.
•Users press “Back” button to enter “1.Enter Setting” interface, Press “OK button to enter main setting interface.
•Enter “1. Set Time” by pressing“Up” button or “Down” button, then press”OK“button and start to set up time.
•Time set from year, month, day, minutes, & seconds in turns, “Up or “Down”button to choose different value to set date.
•Set each value is need to press “OK” button to confirm setting. “success” is displayed if the setting time is correct, “fail”
means failure settings
Communication Card Settings
Set the Correct Date & Time
Set correct Inverter Ids
Single Inverter Terminal Resistor-off
Multiple Inverters
If multiple SOFAR Inv are used, connect all SOFAR Inv in daisy chain mode over theRS485 communication cable. Set different
Modbus address(1~31) for each inverter in LCD display and set SWT2 (match resistance) at the first and last inverter
NOTE: The above details are mentioned in the Installation & Operation Manual of SOFAR Inverters
Dieses Handbuch passt für folgende Modelle
17
Inhaltsverzeichnis
Andere Sofar Wechselrichter Handbücher
Sofar
Sofar ESI 3-6K-S1-HA1-6 Bedienungsanleitung
Sofar
Sofar HYD3000-ES Bedienungsanleitung
Sofar
Sofar HYD 6000-EP Bedienungsanleitung
Sofar
Sofar HYD 3000-EP Bedienungsanleitung
Sofar
Sofar 60KTLX-G3 Bedienungsanleitung
Sofar
Sofar 255KTL-HV-TRO Bedienungsanleitung
Sofar
Sofar HYD 5KTL-3PH Bedienungsanleitung
Sofar
Sofar HYD 5KTL-3PH Bedienungsanleitung
Sofar
Sofar 255KTL-HV Bedienungsanleitung
Sofar
Sofar 1.1KTL2-G3 Bedienungsanleitung
Sofar
Sofar HYD 5KTL-3PH Bedienungsanleitung
Sofar
Sofar SOFAR 3K-6KTLM-G2 Bedienungsanleitung
Sofar
Sofar Sunny Deer Series Bedienungsanleitung
Sofar
Sofar BTS E5-DS5 Bedienungsanleitung
Sofar
Sofar ME3000SP Bedienungsanleitung
Sofar
Sofar 25KTLX-G3 Bedienungsanleitung
Sofar
Sofar HYD 3 6K-EP Series Bedienungsanleitung
Sofar
Sofar 100KTLX-G4 Bedienungsanleitung
Sofar
Sofar 7.5KTLM Bedienungsanleitung
Sofar
Sofar 25KTLX-G3 Bedienungsanleitung
