4
Diagnostic Session - A diagnostic session can be run either through ICU or with a terminal session
through P5. Turn on the diagnostic information settings using either ICU or the HTML connection to the
ISTAR Pro 2U.
Note that the diagnostic information causes overhead and should not be left on during normal operation.
1. Connect P5 to a COM port on a PC. Use a straight through DB9F to DB9F cable.
2. Set the COM port to 115,200 baud, 8, None, 1, Hardware Flow Control.
3. Start a terminal session using an emulator such as HyperTerminal.
LEDs
LED4- indicates power and shines through an opening in the door.
LED2- displays the Ethernet Link signal on P6.
LED1- displays the Receive Data signal on P6.
Dip Switches
DIP Switch S2 is factory set for RS232 on P6. Do Not Change.
DIP Switch S1 is factory set for RS232 on P6. Do Not Change.
DIP Switch S4 is used to control diagnostics, clear memory, and to display card reads in
hexadecimal. See the iSTAR Pro 2U Door map for more detailed information about running
diagnostics.
To display hexadecimal cards reads on the LCD panel set switch 4-8 on.
The Reset Switch, S5, will cause the GCM computer to reboot. Pressing S5 will also clear memory, including
configured readers, inputs and outputs. As long as there is a connection to the host these objects will be
immediately be downloaded to the memory.
If the switch S4-2 is on when S5 is pressed, the unit will be reset to factory default. This means that all of
the connection data, such as the IP address will be cleared in addition to the memory. In this case the unit
will have to be totally configured again using ICU.exe.
To clear memory and reboot the unit:
1. Set switch 4-2 on.
2. Press S5 and wait 10 seconds.
3. Set switch 4-2 to OFF.
4. Press S5 and watch the LCD panel. The unit will reboot, the memory will be cleared and the unit
will need to be reconfigured.
