2
© 2018 / SOFTWIND INSTRUMENTS / Falkenplatz 1 / CH-3012 erne / Switzerland
Assembly of the Wireless MIDI System
The angled MIDI plug connects to the front MIDI
socket of the Synthophone. The other end of the
special cable connects to the wireless transmitter
TX-02 inside the belt pack. The transmitter sends
out MIDI data received from the Synthophone over
a range of up to 150 feet to the MIDI receiver RX-02.
The receiver RX-02 connects to your computer via
US - or - it can be used as a standalone wireless
MIDI receiver when connected to any external MIDI
equipment like synthesizers or other MIDI
hardware. Always use the US charger to supply
power to the RX-02, when using it as a standalone
receiver.
Two US power banks are providing power to the
Synthophone. A fully recharged set of these special
accumulator batteries holds up for approximately
three hours of performance time.
The power banks can be easily recharged using one of the dual US power adapters shown below.
Your power adapter can be any of the 3 types shown in the picture.
They all have universal input
voltages from 115 – 230 volts.
In some countries, you may still
need a country specific travel
adapter in order to recharge.
Two US micro cables are
supplied for simultaneus
recharging of the two
powerbanks. You can recharge
while leaving the powerbanks
inside the belt pack – or - you
may remove them from the pack
to recharge them exernally. When fully loaded, the LEDs on the powerbanks either shut off
completely or light up steadilly. A full recharge cycle may take 6 to 10 hours, so it is best to recharge
your US powerbanks over night. There is NO danger in overloading the power banks, since they
have their own built-in protection.
