Solas SIXTY0 LGS-60 Bedienungsanleitung

solasﬁres.com 1

SIXTY0

DIRECT-VENT LOG SET KIT

PART: LGS-60

INSTALLATION MANUAL

ONLY FOR USE ON SÓLAS MODELS: 60N-SSL, 60P-SSR, 60N-ST, 60P-SSL, 60P-SSR, 60P-ST

WARNING

This log set kit shall be installed by a qualiﬁed service agency in

accordance with the manufacturer’s instructions and all applicable

codes and requirements of the Authority Having Jurisdiction. If

the information in these instructions is not followed exactly, a ﬁre,

explosion or production of carbon monoxide may result causing

property damage, personal injury or loss of life. The qualiﬁed

service agency is responsible for the proper installation of this kit.

The installation is not proper and complete until the operation of the

converted appliance is checked as speciﬁed in the manufacturer’s

instructions supplied with the kit.

NOT FOR USE WITH VENT-FREE OR OUTDOOR FIREPLACES

SÓLAS BIRCH LOG SET KIT

INSTALLER: Leave this manual with appliance | CONSUMER: Retain this manual for future reference

SÓLAS CONTEMPORARY FIRE

KIT CONTENTS:

• (5) CERAMIC LOGS • 1lb. 11oz. LAVA ROCK

• (6) CERAMIC ROCKS • METAL LOG SET BURNERS

LOG SET INSTALLATION

SÓLAS BIRCH LOG SET

BURNER SUPPORT LOCATIONS

Unless the SIXTY0 Slim-Line Built-In Gas Fireplace was originally ordered with the Birch Log Set, your

ﬁreplace will have shipped from the factory with Glass Media burners in place. Before installing the

log set burners, you will need to remove the glass burners. See following steps 1-4 to remove the

Glass Media burners. If the ﬁreplace has been ordered with the Log Set Burner, you can skip to

Step 10 (Page 6 of this manual).

1. The burners are retained by [8] #10 sheet metal screws.

Using a ⁄" nut driver, remove screws located below

the burner (in front of and behind burner).

2. The SIXTY0 has a center burner link that aligns the

burners, remove the [2] #10 sheet metal screws using

a ⁄" nut driver.

REMOVAL OF GLASS MEDIA BURNER

solasﬁres.com 3

LOG SET INSTALLATION

5. Once the glass media burner has been removed,

locate the Log Set Burner included in the kit

LGS-60 and install in the ﬁreplace reusing the

hardware removed during disassembly.

6. When converting to propane, remove collar on burner

inlet tube. When converting to natural gas install collar

over burner inlet tube and secure with #8 sheet metal

screw provided using a ⁄” nut driver.

3. Remove pilot hood.

4. Lift the end of each burner up and move towards the

end of the ﬁrebox until the burner inlet tube is o of the

burner oriﬁce. Lift the burner out of the ﬁreplace.

Collar OFF for LP Collar ON for NG

SÓLAS CONTEMPORARY FIRE

LOG SET INSTALLATION

7. Install the left logset burner within the ﬁrebox by lowering the burner into the ﬁrebox. (while keeping the burner

pressed toward the left side of the ﬁrebox) then sliding the burner right towards the center of the ﬁrebox to

engage the burner oriﬁce. Conﬁrm that the burner inlet tube has engaged the burner oriﬁce. Secure the burner

using the [4] #10 sheet metal screws using a ⁄” nut driver set aside from steps 1-4.

Step 7-A

Step 7-B

Step 7-C

solasﬁres.com 5

LOG SET INSTALLATION

8. Install the right logset burner within the ﬁrebox by lowering the burner into the ﬁrebox. (while keeping the burner

pressed toward the right side of the ﬁrebox) then sliding the burner left towards the center of the ﬁrebox to engage

the burner oriﬁce. Conﬁrm that the burner inlet tube has engaged the burner oriﬁce. Secure the burner using the [4]

#10 sheet metal screws using a ⁄” nut driver set aside from steps 1-4.

Step 8-A

Step 8-B

Step 8-C

SÓLAS CONTEMPORARY FIRE

LOG SET INSTALLATION

9. Secure the central burner link using the [2] #10 sheet metal screws using a ⁄” nut driver set aside from Step 2.

Figure 9-A shows the burners before the burner link is installed; Figure 9-B shows the burners after the burner link

has been installed.

10. Install the 3-rock cluster on the 2 pins located to the right of the pilot assembly as shown below in Figure 10.

11. Install the log, resting along the back edge the 3-rock cluster, the left side of the log locates on a single pin

in the burner surface as shown in Figure 11 (below right).

Figure 9-A

Figure 10

Figure 9-B

Figure 11

> Start HERE if the SIXTY0 Slim-Line Built-In was originally ordered with a Log Set Burner

INTALLATION OF BIRCH LOG SET

solasﬁres.com 7

LOG SET INSTALLATION

12. Install the single rock as shown below in Figure 12 on the 2 pins projecting up from the rear edge of the burner

top, left of the center log installed in Step 11.

13. Install the pair of single rocks as shown in Figure 13 on the 2 sets of pins projecting up from the left side of the left

burner as shown in below right image (Figure 13).

14. Install the Y-shaped log shown below (Figure 14). The right side of the log locates on 2 pins projecting up from the

burner surface, the left side of the log rests in the joint between the 2 rocks installed in Step 13.

Figure 12

Figure 14

Figure 13

SÓLAS CONTEMPORARY FIRE

LOG SET INSTALLATION

15. At the midpoint of the left burner, centered between the rock and log features installed during steps 10-14, are

2 pins to locate the rock shown in Figure 15-A. Note the orientation of the tab on the top surface of the rock

(identiﬁed by the arrow in Figure 15-A).

16. To the right of the center rock and log installed in Step 9-10 is a 3-rock cluster located by a single pin, once the

rock engages the pin, rotate the rock cluster clockwise until the left corner of the rock cluster engages the rear

edge of the burner as shown below in Figure 16.

17. The 3-rock cluster installed in Step 16 supports the left side of the large log shown below in Figure 17. The right

side of the log rests on the burner, a groove in the underside of the log interfaces with the front edge of the burner,

slide the log to the right until the tip of the log is about to contact the enamel side panel.

Figure 15-A

Figure 16

Figure 17

Figure 15-B

solasﬁres.com 9

LOG SET INSTALLATION

18. Immediately left of the 3-rock cluster installed in Step 16 are 2 pins used to locate the small log as shown

below in Figure 18.

19. Evenly distribute the included 1lb and 11oz of lava rock on the exposed burner top. Cover the burner top completely

but do not compress or “pack” the lava rock tightly. Pay special attention to tight and hard to reach areas when

placing the media on the burner. It is ok if small amounts of lava rock are lost over the edge of the burner.

Installation of the Birch Log Set is now complete, refer to the SIXTY0 Installation and Operation

Manual for instructions on ﬁnal assembly and lighting of the appliance.

Figure 18

THANK YOU FOR CHOOSING

RECORD YOUR PRODUCT INFORMATION

Model #: ________________________ Serial Number: ______________________________

Dte Purchsed: __________________ Date Installed: _______________________________

solasfires.com

We recommend that our

gas hearth products be

installed and serviced by

professionals who are

certiﬁed in the U.S. by the

National Fireplace Institute®

(NFI) as NFI Gas Specialists.

www.NFIcertiﬁed.org

Andere Handbücher für SIXTY0 LGS-60

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Solas Kamin im Innenbereich Handbücher

Solas

Solas TWENTY6 ST-26N Bedienungsanleitung

Solas

Solas COOL ZONE Betriebsanleitung

Solas

Solas THIRTY8 Series Bedienungsanleitung

Solas

Solas ONE6 Bedienungsanleitung

Solas

Solas SEVENTY2 LGS-72 Bedienungsanleitung

Solas

Solas ONE6 FS Bedienungsanleitung

Solas

Solas FORTY6 SLIM-LINE Bedienungsanleitung

Solas

Solas ST-26N Bedienungsanleitung

Solas

Solas FIN-36N Bedienungsanleitung

Solas

Solas FORTY6 VF Bedienungsanleitung

Solas

Solas TWENTY6 SLIM-LINE Bedienungsanleitung

Solas

Solas TWENTY6 SL-26N Bedienungsanleitung

Solas

Solas ONE6 LGS-16BI Bedienungsanleitung

Solas

Solas VF-16NG Bedienungsanleitung

Solas

Solas BI-48-ST Bedienungsanleitung

Solas

Solas SL-26N Bedienungsanleitung

Solas

Solas Twenty6 FI Bedienungsanleitung

Solas

Solas FORTY8 Bedienungsanleitung

Beliebte Kamin im Innenbereich Handbücher anderer Marken

Brigantia

Brigantia 35-DVRS31N-2 Betriebsanleitung

Nordpeis

Nordpeis Bergen Bedienungsanleitung

Superior

Superior BCT2536TMN Bedienungsanleitung

Quadra-Fire

Quadra-Fire 5100I-GD-B Bedienungsanleitung

Renaissance

Renaissance RUMFORD 1000 Bedienungsanleitung

Lacunza

Lacunza IV-800 Bedienungsanleitung

Baxi

Baxi 940 Gebrauchsanweisung

Dru

Dru Maestro 60/2 Tall RCH Bedienungsanleitung

Diamond Fireglass

Diamond Fireglass SS-O22 Bedienungsanleitung

HearthStone

HearthStone Windsor Bay 8830 Programmierhandbuch

Napoleon

Napoleon ASCENT B42 Bedienungsanleitung

Enviro

Enviro E33GI Bedienungsanleitung

Smeg

Smeg L30 FABE Montageanleitung

KEDDY

KEDDY K700 Bedienungsanleitung

Godin

Godin 3451 Bedienungsanleitung

Jøtul

Jøtul Jotul GI 535 DV IPI New Harbor Bedienungsanleitung

Desa

Desa CCFPDFT Bedienungsanleitung

Miles Industries

Miles Industries Vogue 1300IRN Handbuch