08706010024
prog MEM
1 or 2 or 3
Press one of the 3 memory buttons
If the memory is empty,
the display shows one
digit for the empty
memory you selected.
Enter the telephone number
(e.g. 0870 601 0024)
then Press #
Choose the chargeband
required (e.g. Local) by
pressing *to move the
display through the
different chargebands
available (including Free
and Barred).
When correct Press #.
Repeat for the other two
memory buttons as
required. Complete the
label and refit the cover.
LOC 010024
Local Exception Codes setting
Because your payphone doesn't know where it is
installed, it will charge all calls commencing 01,
02 and 03 at the Long Distance rate. There are
some calls with these prefix digits which should
be charged at Local rates.
To localise your payphone:
The phonebook
Locate "Local Call Lists" in
your phonebook.
For your area:
Note local calls
starting 01 & 02
6
1 = Unit Fees
2 = Unit Times
3 = Dialling Type
4 = Change PIN
5 = PABX Access
6 =
7 = Ringtime Limit
8 = International Allow or Bar
9 = Dialling Code Review/Look
0 = Dialling Code Entry
Details of each setting are provided overleaf.
prog - - - -
Advanced Feature Programming
Enter the advanced
feature PIN (2468)
to set other facilities, or
Press *
to leave the Programming Mode.
Press #
and wait until display
shows:
Enter the first code
(e.g. 01672)
Then press #
LOC
------
LOC -01672
Repeat for all local codes required,
Then press #.
(If
FULL
displays, all the exception code capacity
has been used.)
Advanced Features may then be accessed by
pressing the relevant keypad number:-
Basic Programming Mode
To adjust your Solitaire 6000 settings, you must
enter Programming Mode. Leave the handset in
place and begin with the key locked:
18:53
Press *until time
disappears, then
Press #
Unlock the case
(no need to open it)
Turn the key fully
Enter your PIN
Set time
(on keypad)
When correct: Press #.
— — — —
Mon
or, for B.S.T Clock changes:
Press *to advance clock 1 hour,
Press *again to retard clock 2 hours,
Press *again to advance clock by 1 hour.
When correct time is shown: Press #.
Set day
(on keypad)
(1=Mon... 7=Sun, and
0 sets the payphone to
perpetual daytime rate),
then Press #
5
Programming the 3 Memory Buttons
Your Solitaire 6000
payphone now allows you
to program 3 numbers on
the memory buttons
underneath the keypad; for example, a local taxi
company, a credit card authority or a head office.
You may record the details on the label under
the clear plastic cover by using a ballpoint pen in
the hole at either end of the cover and flexing it.
prog MEM
Plug-In-Customiser (PIC)
If you require an expansion of your payphone's
facilities, contact our Customer Services
Helpline on 0870 601 0024
Basic Settings
Solitaire 6000 is factory programmed with the
following basic settings, many may be changed -
refer to appropriate section.
Time/Day:
Recommend these are set at installation
Memory Buttons: None have been preset.
Local Codes: 0845 is set
National Fees:
defaults set as follows
Minimum Fee 20p Unit Fee 10p
International Fees: defauit set as follows
Minimum Fee 50p Unit Fee 10p
dnabegra
Ch apeCh meityDa ndekeeW
lacoL 7676
Long Distance 3 4
eliboM 16 31
Time Period Defaults:
Mon to Fri: Cheap 00.00-08.00 & 18.00-24.00.
Mon to Fri: Daytime 08.00-18.00.
Sat and Sun: Weekend Rate all day.
Dialling Type: Set to Tone.
Personal Identification Number: On handset label
Exchange/PABX Access: Set to Direct line
Ringtime Limit Default: Set to 30 seconds.
International Barring: International calls allowed.
Exception Code Defaults:
ee
Fr alcoL gnoL
ecnatsiD eliboMedrraB
,0050
,0080
,8080
0845 ,20,10
03, 0870 70
1, 04,
05, 06, 070
076, 08, 09
Service Numbers: 100/118XXX Operator/Directory
Enquiry calls are barred in payphone mode.
Free unlimited digits 0500, 0800, 0808
These are factory settings. They may be
superseded by a "PIC" upgrade, in which case
new settings will be supplied with that upgrade.
67 67 67
43
43
43
Spare 30 20
Eire 12 7
Int Band 1 7.9 7.9
Int Band 2 2.1 2.1
9
60
12
7.9
2.1
Int Band 1 003 & 004, Int Band 2 00X
Changing the Ringer Volume
Unlock and open the case, then locate and
adjust the Ringer Volume Switch (high/low/off).
Then close and lock the case.
2.80
Unlock the case
With the key in the
unlocked position, the
display shows the cash
records:
Emptying the Cashtray
Firstly
Then
15.50
tot
Open the case,
Empty the cashtray
NB: The record of cash since the case was
last unlocked is reset to zero, but the
record of the total cash since
installation is unaffected by this
sequence.
Close and lock the case,
Remove the key.
4
Solitaire 6000 has no batteries and is powered
from the telephone line.
When the payphone is installed for the first time
we recommend that the Owner should set time
and day as follows
Press *then #, insert
key and turn to open,
enter four digit PIN
Enter correct time in
24 hour format
Eg 2.30pm becomes 14:30
Then press #
14:30
Enter correct Day
1=Mon, 2= Tues,
then Press #
DaY0
Provided your Solitaire 6000 remains connected
to the telephone line the time clock will operate.
If disconnected for more than a few minutes the
time will be lost but the payphone will continue
to operate on a Daytime rate basis.
— — — —
Making an Owner Call
As the payphone owner who knows the PIN, you
do not need cash to make a call. Begin with the
handset in place:
— — — —
13:05 OWnEr
01234567890
OWnEr
Press *until time
disappears, then
Press #:
Enter your four-
digit PIN
if correct, display shows:
Lift handset
Dial number and
Make your call.
Owner Mode - NEXT CALL
You may make another owner call without re-
entering your PIN. If you wish to dial another
number: DON'T HANG UP!
Next
Call ?
Next
Call ?
Next
Call ?
Calling a Memory Number
Memory numbers can be programmed to taxi,
credit card authority, head office numbers etc.
They must be programmed before use - see (5).
Lift handset,
Press chosen
memory button
Display shows selected
memory number.
If memory number chosen is set to a FREE
number, the call can proceed without coins.
However if the number is set as a PAY call you
will be prompted to insert cash as if the number
had been dialled normally.
NB: Memory numbers may be set at rates
different from normal (e.g. a mobile
number may be set at a free rate).
01122334455
DIAL
Memory numbers may be used in the owner
mode, when no cash will be required.
Receiving a Call
09876543210
Assuming the Ringer Volume switch is set to
either or , your payphone will ring normally
when an incoming call is received.
Calls may be accepted by lifting the handset.
The Payphone Identification Tone will sound in
the earpiece to tell telephone operators that the
telephone they have dialled is a payphone and
that reverse charge calls should not be
connected. Do not press any dialling buttons
after lifting the handset, as this may result in the
incoming caller being unable to hear you.
NB: Calls accepted on an extension
telephone cannot be subsequently
transferred to the payphone.
13:08 OWnEr
Press NEXT CALL
Dial new number
and Make new call
You may use this sequence more than once.
However if you replace the handset you will have
to re-enter your PIN.
Next
Call ?
Next
Call ?
3
Installation
If you require to fix your Solitaire 6000 securely
to a wall or table, open the case, remove the
cashtray, locate the fixing positions, drill and fix
as appropriate using the fixing kit supplied. Close
and lock the case.
When providing a payphone service to the public,
in order to comply with OFCOM regulations, you
must complete and display the important
information panel near the payphone.
1. Remove your Personal Identity
Number (PIN) label from the handset
and record the number here:
2. Plug it in.
DIAL
123
456
789
0#
*
SOLITAIRE
6000
1020 50 £1
NEXT
CALL
3. Lift the Handset.
123
456
789
0#
*
EMERGENCY
DIAL:999
Tel.No
NEXT
CALL
SOLITAIRE
6000
1020 50 £1
Your Solitaire 6000 is now
ready to use!
Making a Payphone Call
The Payphone Identification Tone (Beep...Bop)
will sound in the earpiece. Calls to Emergency
Services are free, no coins are required.
Lift handset
Dial number
When answered:
Insert cash
You may now
speak
01234567890
20P
43
DIAL
Next
Call ?
DIAL
Display shows time left. At 10 seconds, expiry
tone prompts to insert cash. Call is disconnected
if time reaches 0, and prompt reappears.
Payphone Mode - NEXT CALL
If sufficient cash credit remains after your first
call, you may make further calls without inserting
more cash. DON'T HANG UP!
Press NEXT CALL
Display shows credit left:
Display eventually shows
time remaining:
You may now speak on your Next
Call - Insert more coins if required.
You may use this sequence more than once.
26
Next
Call ?
30P
Dial new number
2
Description
Your Solitaire 6000 payphone is designed for
use in supervised indoor locations and accepts
10p, 20p, 50p and £1 coins. The case design
allows the Solitaire 6000 to be equally 'at home'
free-standing or fixed on a wall or shelf and a
Liquid Crystal Display makes it easy to operate.
The Solitaire 6000 provides Payphone
Identification Tone (Beep...Bop) to tell telephone
operators that the telephone they have dialled is
a payphone and reverse charge calls should not
be connected.
Calls to Emergency Services on 999 or 112
are always available without coins.
In Basic Settings, calls to 100 Operator and 118
XXX Directory Enquiry services are only available
to the payphone owner, in owner mode. These
facilities can be opened to payphone users. Your
payphone also has the facility to bar calls to
particular STD codes, for example 090 is barred
in the Basic Settings.
As you become more familiar with the extensive
facilities it offers, you can of course customise
the settings of your Solitaire 6000 to suit your
own particular needs.
Hearing Impaired Users
The Solitaire 6000 incorporates an
inductive coupler in the handset to
assist users of post aural hearing aids.
Future Coins
In the event that the Royal Mint introduces new
coins, please contact our Helpline.
Please Read This
You do not have to read all of this leaflet to use
your payphone. Your Solitaire 6000 is ready to
use 'straight from the box'. Batteries are already
fitted and basic setting up has been done.
Recording the Key Number and
Serial Number
We have supplied your Solitaire 6000 with two
keys to fit the case lock. As well as giving access
to the cash inside the phone they also allow you
to enter the programming modes. You need to
key number:record the
If you lose the keys, you can get replacements
by contacting our Customer Services Helpline.
www.solitairepayphones.com
You will find the serial number of your phone on
its base. Record this as it may be
required if you request Warranty service:
serial number
Your Solitaire 6000 is designed to plug into a
new modular telephone socket. If you do not
have such a telephone connection point, you
should contact your local BT Payphone Sales
Office to arrange for one to be fitted. They can
be contacted on:
0800 115511 - UK (except Northern Ireland)
150 - Northern Ireland
In the event of difficulties, please call our Customer Services Helpline on 0870 601 0024
(LGPM0208-6N RoHS)
