SOLTECH SFC420GM Hardware Installation Manual
D. Seek for medical help, or judge the loss and seek for available help.
2.2.4 Electrostatic Discharge Damage Prevention
Electrostatic discharge may damage devices and circuits.Improper treatment may
cause the switch to malfunction completely or discontinuously.
Move or locate the devices according to the measures of electrostatic discharge pre
vention, ensuring the machine box connects the ground.Another measure is to wea
rthe static-proof hand ring.If there is no hand ring, use the metal clip with the metal
cable to clip the unpainted metal part of the machine box.In this case, the static is d
ischarged to the ground through the metal cable of the clip.You can also discharge
the static to the ground through your body.
3. Requirements for Common Locations
This part describes the requirements for the installation locations.
1. Environment
The switch can be installed on the desk or the cabinet.The location of the machine
box, cabinet planning and indoor cabling are very important for normal system’s fun
ction.Short distance between devices, bad ventilation and untouchable control plat
ewill cause maintenance problems, systematic faulty and breakdown.
For location planning and device locating, refer to section 2.3.2 “Location Configura
tion Prevention”.
2. Location Configuration Prevention
The following preventive measures assist you to design the proper environment for
the switch.
Make sure that the workshop is well-ventilated, the heat of electrical devices i
s well-discharged and sufficient air circulation is provided for device cooling.
- 6 -
Avoid to damage devices by following the electrostatic discharge prevention
procedure.
Put the machine box at the place where cool air can blow off the heat inside t
he machine box.Make sure the machine box is sealed because the opened
machine box will reverse the cool air flow.
2.3.3 Cabinet Configuration
The following content assists you to make a proper cabinet configuration:
