Replacing a lost remote control
Please note that these steps reset/delete all remote controls
programmed for the motor. However, upper and lower limits
as well as the favourite position are retained.
N.B. Only switch off the power supply to the motor synced with
the lost remote control.
– Switch off the power supply for 2 seconds.
– Switch the power supply back on for 10 to 15 seconds.
– Switch off the power supply for another 2 seconds.
– Switch the power supply back on. The blind moves for 5 seconds.
If the blind is positioned at an end limit, the movement will
only be a jog.
– Press the programming button on the back of the new remote
until the blind jogs.
All the previous remote controls have now been cleared
from the memory and the new remote control is synced
with the motor.
Recording or changing the favourite position
– To set or change the favourite position, move the blind to
the desired position with the UP and DOWN buttons and
stop with the MY button, then hold down this button until
the blind jogs.
Deleting the favourite position
– Press the MY button to move the blind to the current
favourite position.
– Now hold down the MY button again until the blind jogs.
This deletes the favourite position.
Adjusting the upper and lower limits
The upper and lower limits have been pre-set before delivery,
but can be adjusted if necessary. They can be set in any order again.
– Hold down the UP button to move the blind to the desired
upper limit. If necessary, adjust the position using the UP
or DOWN buttons.
– Hold down the MY and DOWN buttons simultaneously and
release them once the blind begins to move. The upper limit
is now set.
– Press the MY button when it reaches the desired lower limit.
If necessary, adjust the position using the UP or DOWN buttons.
– Hold down the MY and UP buttons simultaneously and release
them when the blind begins to move. The lower limit is set and
the blind will move up and stop at the upper limit.
– To confirm both limits, press and hold the MY button until the
blind jogs.
The blind jogs and the remote control is programmed for
the upper and lower limits.
The end limits and the channel are chosen on the remote control.
