DESCRIPTION
The VE1 Single and the VE2 Dual Visible Emitters each contain a small Infrared LED, housed in
a small plastic shell. Unlike other emitters, they emit visible red light in addition to IR (infrared)
control signals when activated by IR commands sent to them by IR receivers or other Sonance
controllers. They are designed to be installed directly on the IR sensor window of each
controlled device.
INSTALLATION INSTRUCTIONS
VE1 AND VE2
VISIBLE AND DUAL VISIBLE IR EMITTER
Pg 1
INSTALLATION
ATTACHING THE EMITTERS TO IR SENSOR WINDOWS
• Each emitter has a clear adhesive layer on the bottom flat surface of the shell. The
rounded side faces the user and emits visible red light when a command is sent.
• Simply peel off the protective cover and affix the emitter to the center of the IR sensor
window on the controlled component's front panel. Move the emitter back and forth in
front of the window while sending codes to find the best location. A foil-packed alcohol
swab has been included for your convenience. Use the swab to clean off the IR sensor
window before adhering the IR emitter(s) or to clean the IR emitter(s) after installation.
• In some cases it may be difficult to find the location of the IR sensor on the component.
Consult the owner's manual of the unit, or the manufacturer, for the exact IR
window location.
• Double-sided adhesive tape is included. If you move the emitter to a different component,
use this tape to replace the current adhesive layer.
• The shell is transparent to infrared light, allowing commands from a handheld remote
control to pass through the shell. This permits direct control of the equipment from a
handheld remote as well as with the VE1 or VE2.
